User Manual (user Manual) (ver.1.0) (English)
Page 8
... not install near or around any location other than vertical walls. 2 To protect the performance of the PDP and prevent problems, avoid the following figure: Fixing bolts must protrude from 0 to 5 degrees. When the angle has been set to 20 degrees. Angle control holes 5 degrees of tilt 10 degrees of tilt... area subjected to be set to 15 degrees. Parts (Wall attachment panel is not enough strong to support the PDP, strengthen the wall before installation. 2 Fix the wall attachment panel on the sides of tilt No tilt Continued... 15
... not install near or around any location other than vertical walls. 2 To protect the performance of the PDP and prevent problems, avoid the following figure: Fixing bolts must protrude from 0 to 5 degrees. When the angle has been set to 20 degrees. Angle control holes 5 degrees of tilt 10 degrees of tilt... area subjected to be set to 15 degrees. Parts (Wall attachment panel is not enough strong to support the PDP, strengthen the wall before installation. 2 Fix the wall attachment panel on the sides of tilt No tilt Continued... 15
User Manual (user Manual) (ver.1.0) (English)
Page 9
... is put in the groove at the top may be taken off. ) Œ ´ 16 Separating the Display from the Wall Attachment Panel Remove the fixing bolts from the rear top of the display in the groove on top of the wall attachment panel. Œ ´ 17 4 Remove four large screws...
... is put in the groove at the top may be taken off. ) Œ ´ 16 Separating the Display from the Wall Attachment Panel Remove the fixing bolts from the rear top of the display in the groove on top of the wall attachment panel. Œ ´ 17 4 Remove four large screws...
User Manual (user Manual) (ver.1.0) (English)
Page 12
... Input jacks (Video) on the rear of the PDP, matching the "+" and "-" ends of 7 watts minimum(impedance 8ohm). Connecting PDP and Speakers / Stand and Speakers 1 Fix the bracket onto the guide pole located on the rear of speaker and fasten the screws. 2 After removing the three screws on the PDP, clamp...
... Input jacks (Video) on the rear of the PDP, matching the "+" and "-" ends of 7 watts minimum(impedance 8ohm). Connecting PDP and Speakers / Stand and Speakers 1 Fix the bracket onto the guide pole located on the rear of speaker and fasten the screws. 2 After removing the three screws on the PDP, clamp...