Weider 7400 Support and Manuals
Get Help and Manuals for this Weider item
Popular Weider 7400 Manual Pages
English Manual - Page 1
... OUR TOLL-FREE CUSTOMER HOT LINE. PATENT PENDING
•
• C. WG74000 Serial No. Save this equipment. MST
CAUTION! TM
Model No. As a manufacturer, we will provide immediate assistance, free of charge to providing complete customer satisfaction.
Read all safety precautions and instructions in this owner's manual before using this owner's manual for future reference.
English Manual - Page 2
... all parts each time you feel pain or dizziness at all instructions before using. Keep hands and feet away from the weight system when performing an exercise that the cables are raised. The weights will fall with pre-existing health problems. Read all times. Always disconnect the lat bar from moving weights.
12. your physician. WEIDER assumes...
English Manual - Page 3
... be found on a decal attached to achieve the specific results you have additional questions, please call our Customer Service Department toll-free at the drawing below and familiarize yourself with the parts that are labeled. Whether your goal is WG74000. To help you to the,WEIDER 7400 (see the front cover of the body. Length...
English Manual - Page 4
...materials. Place all parts are oriented exactly as shown in the Footrest Frame (83). As you attach them, unless instructed to the PART IDENTIFICATION CHART accompanying this owner's manual. The following tools ... Stabilizer (5). Tighten all nuts and bolts as you assemble the weight system, make sure that all parts of soapy water are required: Two adjustable wrenches, a standard ...
English Manual - Page 7
...Squat Arm (75) to avoid tipping the stack of the Weight Tube. Set the two Weight Bumpers (19) on the indicated plate on the side of Weight Guides have Holes
72
25 o
"welder" Logo on top, and...pin groove in the Weight. The top ends of the Weight Guides (72) have holes through them-insert the lower ends of the Weight Guides into the ten Weights (25).
76 75
6 76
25 ef)
"weider" Logo on Top...
English Manual - Page 8
... 3/4" Inner Caps (44) and 1" Round Caps (49) into each of the Top Frame (67). Set the Arm Frame Bushings and the Arm Frame on the plate welded to the lower axles on the Arm Frame... 5E>.•
14. Attach the Arm Frame Bracket to the upper axle on the Arm Frame (52). The upper end of the Weight Guides (72)
13
to the Arm Frame (52) in the same manner.
14 7
69 67
52-G rease
68 49
49 44...
English Manual - Page 13
...Bolt.
Before the weight system is used, the cables
should be turned to the lower end of the Front Upright (42) as shown. See TIGHTENING THE
CABLES on page 19 for instructions.
23
15 ... Plate (20) with a 5/16" Flat Washer (8), through the Weight Guide, the Weight Tube and the end of the Weight Tube as shown. Slide the Weight Guide (81) onto the top of the Short Cable. 32.
English Manual - Page 14
...) down through the Leg Lever (29) from the indicated side.
No not overtighten the Nylock Nut; the Leg Lever must be able to pivot freely. Set the bracket on the Seat Frame (36) on the indicated pins on the Front Upright (42).
Press two 3/4" Inner Caps (34) into the Leg Lever...
English Manual - Page 16
... apply them to make sure that all remaining parts will be damaged when heavy weight Is used.
16 Make sure that the cables move smoothly, locate and correct the problem before using the weight system, test the cables and pulleys. Pull each end of this owner's manual. Press a 1" Round Cap (49) into each cable a few...
English Manual - Page 17
... is touching the Weights, and turn the bent end downward. Refer to the EXERCISE GUIDE accompanying this owner's manual to see how the weight system should be reduced...) and Seat Knob (40). ADJUSTMENT
The instructions below describe how each part of the weight system can be performed.
CHANGING THE WEIGHT SETTING
To change the weight setting, insert the 5" Weight Pin (26) under one of the ...
English Manual - Page 19
...
Sleeve
If the cables need to be replaced, see ORDERING
23
REPLACEMENT PARTS on the weight system, can be tightened.
TIGHTENING THE CABLES
Woven cable, the type of this
owner's manual.
19 If there is slack in the cables before resistance is no slack. Retighten the adjustment screw. TROUBLE-SHOOTING AND MAINTENANCE
Inspect and tighten all...
English Manual - Page 20
... IS LIMITED IN ITS SCOPE AND DURATION TO THE TERMS SET FORTH HEREIN.
You may also have other warranty beyond that specifically set forth above is authorized by WEIDER.
ORDERING REPLACEMENT PARTS
To order replacement parts, simply call our Customer Service Department toll-free at one of its authorized service centers with all freight and other transportation charges prepaid, accompanied...
Weider 7400 Reviews
We have not received any reviews for Weider yet.