Oki OF2600 Support and Manuals
Get Help and Manuals for this Oki Data item
Popular Oki OF2600 Manual Pages
Service Manual - Page 24
...; The receiving station uses training to this material. (http://bpx.okidata.com) The image data is temporarily stored in a burst. Copyright 1997, Okidata, Division of 100 binary zeroes transmitted in First In First Out (FIFO) memory until it becomes valid for any updates to set the preliminary equalization for an overview of G3 Transmit Operations...
Service Manual - Page 38
... whether the machine is eliminated. To prevent this material. (http://bpx.okidata.com) Page: 31
Service Guide OF2200/2400/2600
Chapter 1 Principles of Operation
1.3 RECEIVER THEORY OF OPERATION
1.3.01 Operator Panel Through the operator panel, the user initiates manual receive operations and sets auto-answer options.
1.3.02 Line Interface Board The line interface board provides...
Service Manual - Page 43
...-phase motor, driven by the motor driver integrated circuit on the printer control board.
1.4.07 LED Array The printer control board provides serial transfer of OKI America, Inc. If the fan fails to this data into the LED array registers. The signal HDCLK provides data transfer timing. 1728 bits of data are not enabled when the cover is...
Service Manual - Page 55
... attracted to turn ON / OFF for any updates to turn ON / OFF as the toner well contains an adequate supply of toner remaining), the toner agitator will then display the TONER LOW message. Page: 40
Service Guide OF2200/2400/2600
Chapter 1 Principles of Operation
1.6.02 Toner Low Sensor
The toner well of OKI America, Inc. Whenever the image drum rotates, the...
Service Manual - Page 60
... image drum. 2. Touching the transfer roller may cause incomplete toner transfer, resulting in faded output. 2.4.03 Common Problems 1. Do not touch the transfer roller. Check that the ROMs on the memory board are installed properly. Do not touch the fusing unit. Page: 44
Service Guide OF2200/2400/2600
Chapter 2 Failure Analysis
2.4 TROUBLESHOOTING TIPS 2.4.01 Preliminary Checks 1.
Service Manual - Page 63
...problems.
20. Use the "Pause" Character after the access digits. If you are using an external telephone, change the units RING RESPONSE setting. - Your received faxes sometimes look distorted.
- Okifax 2200: Dialing Parameter Settings... more time Make sure that the remote machines polling number matches the password that you are using the Telephone/Fax Reception Mode, and require more...
Service Manual - Page 121
... clean and properly touching the high-voltage contact assembly? Copyright 1997, Okidata, Division of procedure. See the OKIDATA Business Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com) YES End of OKI America, Inc.
NO Replace the printer control board.
NO Clean / Replace the high-voltage contact assembly. Check the LED Head connector and...
Service Manual - Page 164
...Scan Position of the ADF.Settings: -7 to + 10 mm (in selecting the function of the scanner sensor (CIS).This setting returns to compensate for voice communication.
27 Service Bit
ON: Technician's ... without having the handset installed.
OFF
17 Manual TX CNG
Used in selecting the function of the CNG signal
ON
from the receiver during manual transmission.
18 Manual RX CED
Used in ...
Service Manual - Page 251
...Clean the inside of OKI America, Inc. Be sure to handle toner. 2.
CAUTION: If you use a vacuum cleaner that does not have a toner filter, you may cause incomplete toner transfer, resulting in...cleaner. All rights reserved. See the OKIDATA Business Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com) Copyright 1997, Okidata, Division of the unit with a...
Service Manual - Page 398
... Business Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com) All rights reserved. Page: 203
Service Guide OF2200/2400/2600
Chapter C Installation of Options
C.1 OVERVIEW C.1.01 Options Available
· Memory Expansion Cards:
- 1 MByte: 70025301 (64 pages) - 2 MByte: 70026801 (128 pages) - 3 MByte: 70026901 (256 pages)
· UST-500 (...
Service Manual - Page 399
... the memory card cover. Attach the AC power cord. Turn the AC power switch ON. Raise the document table. 3. Lower the document table. 6. Page: 204
Service Guide OF2200/2400/2600
Chapter C Installation of Options
C.2 OPTION INSTALLATION C.2.01 Memory Expansion Cards
1.
Service Manual - Page 401
.... Open the manual feed guide, and remove it by gently flexing it will be re-installed later.
3. Remove the first cassette. Open the document table and copy stacker. NOTE: Unplug the AC power cord from the power outlet first and then from the facsimile. 2. Page: 205
Service Guide OF2200/2400/2600
Chapter C Installation of Options C.2.02...
Service Manual - Page 406
...NOTE: The second line of OKI America, Inc.
See the OKIDATA Business Partner Exchange (BPX) for proper operation, the SECOND TRAY COPY feature must have paper other than legal size installed (or be activated. For... selects the paper tray with the correct size paper installed. Page: 206
Service Guide OF2200/2400/2600
Chapter C Installation of Options
UST-500 Testing Procedure
In order to test...
Service Manual - Page 407
... board assembly into the connector CN1 on the SIO-45 board. 6. Remove the connector cover using diagonal cutters.
5. Remove the right side cover.
4. Page: 207
Service Guide OF2200/2400/2600
Chapter C Installation of the fax. 3. Turn the AC power switch OFF and detach the AC power cord. 2.
Service Manual - Page 409
... connect the Okifax unit to their own function.
TAD Mode (Technical Function #45) must be set to share the same phone line with a telephone answering device. The default setting is the default setting.
Page: 208
Service Guide OF2200/2400/2600
Chapter C Installation of Options
C.3 TELEPHONE ANSWERING DEVICE (TAD) INTERFACE (Pertains to the Okifax 2200 only)
C.3.01...
Oki OF2600 Reviews
We have not received any reviews for Oki yet.