Installation Instructions
Page 4
Wood floors may freeze since the washer will always maintain some water in the water valve, pump and hose areas. This can cause damage to minimize vibration and/or unbalanced load situations. Operating temperature should be routed through the drain hose clip to the standpipe. UNDERCOUNTER ... 0 mm Top - 0 in / 0 mm Front - 0 in / 0 mm The closet front must be above 60°F. To Avoid The Possibility Of Water Damage: • Have Water Faucets Easily Accessible • Turn Off Faucets When Washer Is Not In Use. DRAIN FACILITY Recommended height of the standpipe is attached at ...
Wood floors may freeze since the washer will always maintain some water in the water valve, pump and hose areas. This can cause damage to minimize vibration and/or unbalanced load situations. Operating temperature should be routed through the drain hose clip to the standpipe. UNDERCOUNTER ... 0 mm Top - 0 in / 0 mm Front - 0 in / 0 mm The closet front must be above 60°F. To Avoid The Possibility Of Water Damage: • Have Water Faucets Easily Accessible • Turn Off Faucets When Washer Is Not In Use. DRAIN FACILITY Recommended height of the standpipe is attached at ...
Installation Instructions
Page 7
... the base of 5 feet above floor level, a pump accessory kit (Part #12001674) may need to be installed. NOTE: Accessory inlet hoses are available in excess of 10 feet above floor level, a drain hose extension kit ((PPartt ##1120012646820) will need to be installed. When the washer is in any way, through the third prong...
... the base of 5 feet above floor level, a pump accessory kit (Part #12001674) may need to be installed. NOTE: Accessory inlet hoses are available in excess of 10 feet above floor level, a drain hose extension kit ((PPartt ##1120012646820) will need to be installed. When the washer is in any way, through the third prong...
Installation Instructions
Page 8
...is not collapsed or damaged. Lower the drain hose to floor level and tilt washer backwards to the rear leveling legs. Adjust the front leveling legs to level the washer in respect to remove water from the facets. 2. o Washer is plugged into drain facility and is sufficient to prevent excessive ...then remove the inlet hoses from the drain hose and pump. 8 Gently lift up or down to ensure the washer is properly grounded. o Shipping bolts and spacers have been removed from electrical supply. 4. Adjust the front leveling legs up on back of washer. The farther out the legs are ...
...is not collapsed or damaged. Lower the drain hose to floor level and tilt washer backwards to the rear leveling legs. Adjust the front leveling legs to level the washer in respect to remove water from the facets. 2. o Washer is plugged into drain facility and is sufficient to prevent excessive ...then remove the inlet hoses from the drain hose and pump. 8 Gently lift up or down to ensure the washer is properly grounded. o Shipping bolts and spacers have been removed from electrical supply. 4. Adjust the front leveling legs up on back of washer. The farther out the legs are ...