KitchenAid KFDC500JAV Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid KFDC500JAV manuals!
Problems with KitchenAid KFDC500JAV?
Ask a Question
Free KitchenAid KFDC500JAV manuals!
Problems with KitchenAid KFDC500JAV?
Ask a Question
KitchenAid KFDC500JAV Videos
KitchenAid KFDC500JAV Range
Duration: :36
Total Views: 1
Duration: :36
Total Views: 1
KitchenAid KFDC500JAV Cuisinière
Duration: :35
Total Views: 0
Duration: :35
Total Views: 0
Popular KitchenAid KFDC500JAV Manual Pages
Owners Manual - Page 4
...manual. I Do Not Use Water on hot surfaces may be seriously injured.
I Storage in or on the range to the sudden change in area where the range is under anti-tip bracket. • See installation instructions for range-top service... FEET AFTER RETURNING THE RANGE TO THE ORIGINAL INSTALLED POSITION.
Do not repair or replace any part of the oven. Areas near surface units. Only...
Owners Manual - Page 14
... tone will sound every 30 seconds until the error is connected to the OFF position.
14
To exit idle mode, re-select a mode and setting before pressing start button to confirm a mode change...on , mode can send instructions to monitor the unit. If no preheat for valid selections. NOTE: When the unit is invalid. See the model compatibility table on 48" models only)
USE AND LIGHT ...
Owners Manual - Page 16
...Guide" for either iOS or Android®‡ devices.
‡Google Play® and Android® are set , the oven will remain in a bake setting... time it cannot be scanned or manually added. NOTE: The temperature can be... the "Remote Enable" section for the SAID code on page 6.
3. Press the Start button .... Wi-Fi Connectivity and Remote Operation
Models are provided with a Wi-Fi module...
Owners Manual - Page 23
...® Cooktop Cleaner or affresh® Cooktop Cleaning Wipes can also be adjusted, contact a trained repair specialist.
4. Replace burner cap.
Burner
2. Clean food spills.
1
1 Incorrect 2 Correct
2
To preserve the...does not light, check cap alignment. If the burner still does not light, do not service the sealed burner yourself. Do not use oven cleaners, bleach, or rust removers. ■...
Owners Manual - Page 30
... surface burner and contact a service technician. Use medium-to operate properly. Set the Cooktop Control to H or L, depending upon the type of the surface burner knobs to automatically run in knob before turning to start at a later time.
There is set correctly. See Sabbath Mode section for leveling instructions. Allow more than 12 hours...
Owners Manual - Page 31
...positions.
If the proper steps are browning early. TROUBLESHOOTING
First try the solutions suggested here.
The oven ...time. Install the bottom rack first and then install the rack above each food item.
POSSIBLE CAUSES
The set temperature did...setting the desired function, the oven will preheat before cooking. Racks are level, and check that may help you avoid a service...
Owners Manual - Page 32
..., you the cost of your correspondence. KitchenAid Canada designated service technicians are trained to local dealers, repair parts distributors and service companies. Our consultants provide assistance with :
■■ Features and specifications on our full line of appliances.
■■ Installation information.
■■ Use and maintenance procedures.
■■...
Installation Instructions - Page 5
....
■ Contact a qualified floor covering installer to check that all parts are shown must be installed with your local hardware store. Additional Installation Requirements The installation of this range must conform with the current standards CAN/CSA-A240-latest edition or with installation clearances specified on griddle models)
Parts Needed
■ All models must be used will not...
Installation Instructions - Page 7
...with the CSA Standard C22.1, Canadian Electrical Code, Part 1 - If codes permit and a separate ground wire is used , it is recommended that a qualified electrical installer determine that the ground path is located under the console on the model/serial/rating plate. Check with local codes. Electrical Connection To properly install your local qualified electrician.
latest edition - Gas...
Installation Instructions - Page 8
...a qualified service technician.
...The parts for ...the model/serial/rating plate...codes permit, a new CSA design-certified, 4-5 ft (122-152 cm) long, 5/8" (1.6 cm) or 3/4" (1.9 cm) I.D., flexible metal appliance connector may be used in excess of 1/2 psi (3.5 kPa). Do not allow the regulator to turn or move when tightening fittings.
■ Must include a shut-off valve: Install a manual... set for...
Installation Instructions - Page 9
...Kick plate b. A. Oven door hinge in the locked position
B
B. INSTALLATION INSTRUCTIONS
Unpack the Range
WARNING
Excessive Weight Hazard Use two or more people, firmly...install. Remove shipping materials, tape, and film from inside oven. For 48" (121.9 cm) models only, rotate center support counterclockwise off the pallet until range is off shipping pallet. Remove oven racks, and parts...
Installation Instructions - Page 11
... your local hardware store. 5. Gas pressure regulator B. Use pipe-joint compound.
Manual gas shut-off valve. A
BC
D
E
A. Adapter (must be made ...include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. See the following installation instructions.
If connected to move when tightening fittings. Tighten both adapters,...
Installation Instructions - Page 12
...and grates from parts package. For further...
12 Open the manual shut-off valves ... at this point, contact your service provider. Turn on
burner bases... to the user instructions located in place ...Guide. Griddle
2. Flame Height
The range flame should light within 4 seconds. Upper (main) flame B. Install Griddle Tray
(On griddle models)
The griddle is indicated. If burner caps are factory set...
Installation Instructions - Page 15
...8 for more information on the model/serial/rating plate. A
NAT
LP...If the burner grates are installed, remove them. 2. ...range and its individual manual shut-off valve must be... parts bag...driver to the regulator should be extra orifices in NAT position
E.
Spring retainer in your kit.
7.
Replace...position
6. Line pressure testing above the set pressure. To Convert Surface Burners from...
Installation Instructions - Page 18
... information on the model/serial/rating plate. If the burner grates are installed, remove them. ... parts bag for the remaining burners. Spring retainer in the nut driver ...supply line. Line pressure testing above the set pressure. Tighten screws only until burner is ...manual shut-off valve must be removed).
18 Remove the burner base by turning the spring retainer counterclockwise.
Replace...
KitchenAid KFDC500JAV Reviews
We have not received any reviews for KitchenAid yet.