KitchenAid KDRS483VSS - 48" Commercial Dual Fuel Range Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid KDRS483VSS manuals!
Problems with KitchenAid KDRS483VSS?
Ask a Question
Free KitchenAid KDRS483VSS manuals!
Problems with KitchenAid KDRS483VSS?
Ask a Question
Most Recent KitchenAid KDRS483VSS Questions
Where Is Lp Conversion Kit Located?
(Posted by kellyshideler 11 years ago)
Control Panel
If the control panel goes bad or cracks, can you order a new part. Someone who reviewed this model s...
If the control panel goes bad or cracks, can you order a new part. Someone who reviewed this model s...
(Posted by affordableuniforms 11 years ago)
Range Problem
the igniters on my new kdrs483vss operate constantly when the range is plugged in. Any ideas?
the igniters on my new kdrs483vss operate constantly when the range is plugged in. Any ideas?
(Posted by brockdupont 12 years ago)
KitchenAid KDRS483VSS Videos
Kitchenaid KDRS483VSS Commercial-Style Dual Fuel Range
Duration: :38
Total Views: 34
Duration: :38
Total Views: 34
Popular KitchenAid KDRS483VSS Manual Pages
Dimension Guide - Page 1
...a qualified service technician.
Mobile home installations require:
q When this kit are in a mobile home, it here. Specifications subject to the proper electrical voltage and frequency
as it may not include a power supply cord.
30", 36", and 48" Professional Dual Fuel Convection Ranges
PRODUCT MODEL NUMBERS
KDRS407VSS KDRS462VSS KDRS463VSS
KDRS467VSS KDRS483VSS KDRU707VSS
GAS...
Installation Guide - Page 5
.... Check local codes for 48" (121.9 cm) Ranges Order Part Number W10225948
To order, see NOTE* C. 35¾" (89.6 cm) cooktop height when setting on the right vertical surface of the oven door frame.
■ It is recommended that a microwave hood combination be installed B. 27¾" (70.5 cm) depth with control panel, see the "Assistance or Service" section...
Installation Guide - Page 7
... 827 kPa) is required to refill after heavy usage. The model/serial number rating plate is located on the model/serial rating plate.
**If connecting to setting the range in the upright position. Typical Installation Configuration NOTE: For unique installations, contact a licensed plumber. In Massachusetts, plumbing code 248 CMR 3.00 and 10.00 must determine the type...
Installation Guide - Page 9
... supplier. The parts for turning on the types of Gas
Natural Gas:
This range is design-certified by a qualified service technician. Do not block access to the range. IMPORTANT: This installation must be connected to a regulated gas supply. With LP gas, piping or tubing size can be used . Flexible metal appliance connector:
■ If local codes permit, a new...
Installation Guide - Page 10
...avoid damaging floor.
10 INSTALLATION INSTRUCTIONS
Unpack Range
WARNING
3. For 48" (121.9 cm) models only, rotate center support counterclockwise off shipping pallet. Remove shipping materials, tape and film from kickplate. Remove screws from range. NOTE: This support is used . Set range on cardboard to be disconnected from the gas supply piping system by closing its individual...
Installation Guide - Page 20
... piping system by a qualified installer....model/serial rating plate. Failure to follow these instructions can tip the range and be done by closing its individual shutoff valve must be used to the closed position) C. Turn the manual shutoff valve to remove the burner head of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service...
Installation Guide - Page 21
... gas pipe. Replace with correct LP gas orifice spud. See "LP Gas Orifice Spud/Hood Chart."
Grill orifice hood location
3. Place Natural gas orifice hoods in the nut driver while changing it. Before replacing the burner assembly, loosen the screw at the
front of this manual to help hold the gas orifice spud in plastic parts...
Installation Guide - Page 23
... supply.
2. Apply masking tape to the end of this manual to help hold the gas orifice spud in the "Installation Instructions" section of a 7 mm nut driver to complete this procedure.
23 Set gas orifice spud aside.
6. See "Install Grill Grease Trays" section for the remaining burners. Grill orifice hood location
3.
Size stamp
7. Repeat steps 2 through 9 for removal...
Use & Care Guide - Page 5
... not repair or replace any part of the oven.
■ WARNING: NEVER cover any slots, holes or passages in
cabinets above a range or on any part of fire, electrical shock, injury to
heat or warm the room. Only certain types of a range - Surface units may result in carbon monoxide poisoning and overheating of the range unless specifically recommended in...
Use & Care Guide - Page 6
... around any part of any kind should not be careful to cause burns - Be sure the range is essential for a good seal.
The door gasket is properly installed and grounded by a qualified technician. The range, when installed, must be taken not to burst and result in Manual.
■ Before Self-Cleaning the Oven - SAVE THESE INSTRUCTIONS
6 If a wet...
Use & Care Guide - Page 7
...
SatinGlide™ roll-out extension rack with True-Broil™
reflector C. Commercial style die cast metal control
knobs M. Drip tray (on some or all of your model. CleanBake™ hidden element E. PARTS AND FEATURES
This manual covers several different models. Range
B C
D
E Oven Interior
A
A
F B
O N
M
L K
A. Stainless steel panels E. Culinary ledge O. Broil elements with handle...
Use & Care Guide - Page 11
... not service the ... with a damp cloth.
3. Replace the burner cap, making sure... for proper size and shape ...A. Contact a trained repair specialist. Do not use oven cleaners, bleach or rust...settings. Turn on the burner. If the burner still does not light, do not allow spills, food, cleaning agents or any other material to avoid curling.
■ Allow space between food on some models...
Use & Care Guide - Page 26
... caps against each other knobs have temperature settings. If this happens, a light coating of grain to avoid damaging. ■ KitchenAid® Stainless Steel Cleaner and Polish Part Number
4396920 (not included) or KitchenAid® Stainless Steel Wipes Part Number 8212510 (not included): See "Assistance or Service" section to remove. Press OFF to the rack guides will discolor and...
Use & Care Guide - Page 28
... use of the surface burner knobs to operate properly. See "Electronic Oven Control" section.
■ Has a delay start been set correctly? See "Display(s)" section. If a letter followed by a number? Replace the fuse or reset the circuit breaker. Surface burner makes popping noises
■ Is the burner wet? See the Installation Instructions for the griddle to release...
Use & Care Guide - Page 29
...self-cleaning, the other oven cannot be set to KitchenAid with : ■ Features and specifications on "applianceaccessories.com." See "Oven Temperature Calibration - If you still need further assistance, you need to "Replacement Parts & Accessories" and click on our full line of time being used to local dealers, repair parts distributors and service companies. See "Positioning Racks...
KitchenAid KDRS483VSS Reviews
We have not received any reviews for KitchenAid yet.