Owner's Manual
Page 11
...rail (Fig. 1-6). Remove Remove FIG. 1-8 Disable garage door lock. Begin with Section 2 INSTALLATION. The belt adjustment nut is approximately 1/8 inch above the base of rail assembly T-Rail FIG. 1-6 Chain adjustment. Do NOT over tighten chain. Drive chain can slide out of rail assembly T-Rail FIG. ...ropes and/or cables (NOT door lift cables) and disabled the door lock already. Assembly for CHAIN DRIVE OPENER NOTE: Handle carefully! Power head assembly. The chain adjustment nut is approximately 1/8 inch above the base of the rail at midpoint on the rail ...
...rail (Fig. 1-6). Remove Remove FIG. 1-8 Disable garage door lock. Begin with Section 2 INSTALLATION. The belt adjustment nut is approximately 1/8 inch above the base of rail assembly T-Rail FIG. 1-6 Chain adjustment. Do NOT over tighten chain. Drive chain can slide out of rail assembly T-Rail FIG. ...ropes and/or cables (NOT door lift cables) and disabled the door lock already. Assembly for CHAIN DRIVE OPENER NOTE: Handle carefully! Power head assembly. The chain adjustment nut is approximately 1/8 inch above the base of the rail at midpoint on the rail ...
Owner's Manual
Page 13
CLEVIS PIN COTTER PIN (Chain drive shown) FIG. 2-5 Rail mounting to ceiling, insure that rail clamp bolts and nuts are tight. • DO NOT PLUG OPENER IN YET! NOTE: Before final .... 2-6). • Set height of power head or rail. • Check that assembly is in proper alignment (Fig. 2-4). Getting started. • Position assembled rail on the garage construction, extra framing material (not provided) which may be required should be installed using a stud finder or similar device. NOTE: For nuts, bolts, and lag...
CLEVIS PIN COTTER PIN (Chain drive shown) FIG. 2-5 Rail mounting to ceiling, insure that rail clamp bolts and nuts are tight. • DO NOT PLUG OPENER IN YET! NOTE: Before final .... 2-6). • Set height of power head or rail. • Check that assembly is in proper alignment (Fig. 2-4). Getting started. • Position assembled rail on the garage construction, extra framing material (not provided) which may be required should be installed using a stud finder or similar device. NOTE: For nuts, bolts, and lag...