User Manual
Page 16
Leaving the cartridge unpacked for a long time before use may result in damage to refill them. This could result in reduced print quality. • Do not use cartridges within six months of installation. 16 For best results, use an ink cartridge beyond the date printed on the cartridge package. 16 | Introduction • Do not dismantle the ink cartridges or try to the print head. • Install the ink cartridge immediately after you remove it from its package.
Leaving the cartridge unpacked for a long time before use may result in damage to refill them. This could result in reduced print quality. • Do not use cartridges within six months of installation. 16 For best results, use an ink cartridge beyond the date printed on the cartridge package. 16 | Introduction • Do not dismantle the ink cartridges or try to the print head. • Install the ink cartridge immediately after you remove it from its package.
Service Manual
Page 219
...the rear of the printer body shows "READY". 5. Turn on , the ink initial refilling operation starts. Turn on again. Transmit the firmware file in the IPL format from the host PC to the printer body. 3. EPSON Stylus Pro 7600/9600 Revision A 5.1.6 Firmware Reinstallation In Stylus Pro 7600/9600, the firmware is written in the Flash ROM on the new.... 8. Write the firmware file in the RCC format in a ROM-DIMM (C309 PROG). 3. Pull the ROM-DIMM out of the dedicated socket. 9. If initial refilling is turned on the power to start the printer by the following procedure: 1.
...the rear of the printer body shows "READY". 5. Turn on , the ink initial refilling operation starts. Turn on again. Transmit the firmware file in the IPL format from the host PC to the printer body. 3. EPSON Stylus Pro 7600/9600 Revision A 5.1.6 Firmware Reinstallation In Stylus Pro 7600/9600, the firmware is written in the Flash ROM on the new.... 8. Write the firmware file in the RCC format in a ROM-DIMM (C309 PROG). 3. Pull the ROM-DIMM out of the dedicated socket. 9. If initial refilling is turned on the power to start the printer by the following procedure: 1.