LG 86UQ8000AUB Support and Manuals
Get Help and Manuals for this LG item
View All Support Options Below
Free LG 86UQ8000AUB manuals!
Problems with LG 86UQ8000AUB?
Ask a Question
Free LG 86UQ8000AUB manuals!
Problems with LG 86UQ8000AUB?
Ask a Question
Popular LG 86UQ8000AUB Manual Pages
Owners Manual - Page 1
... Conformity
Trade Name LG
Responsible LG Electronics USA,
Party
Inc. LED TV*
OWNER'S MANUAL
Safety and Reference
* LG LED TV applies LCD screen with LED backlights. Model
Serial No.
*MFL718464322203REV02*
www.lg.com
Printed in case you ever need service. Supplier`s Declaration of the product.
Address
111 Sylvan Avenue, North Building, Englewood Cliffs...
Owners Manual - Page 2
... not operate normally, or has been dropped. Servicing is required when the apparatus has been damaged in any ventilation openings.
Install in the product. (Depending upon the model. •• Image shown may be resolved exclusively through binding arbitration on an individual basis. By using , troubleshooting, specifications, license etc and view its contents on or...
Owners Manual - Page 6
...button, turning off the device and unplugging the power cord (Depending upon model). In that shown in a manual. •• In PC mode, there may be capable of ...error may differ slightly from that case, change the refresh rate to another resolution, change the TV's [HDMI Deep Color] setting to the manual provided with the HDMI logo attached. However, if the device doesn't support...
Owners Manual - Page 7
... upon the model or country, the typical power consumption may result in injury or damage to upgrade of the power supply and power consumption, refer to the label attached to the product. -- Specifications
Product specifications may not be necessary to 140 °F) Less than 80 %
-20 °C to 60 °C (-4 °F to support certain 8K...
Owners Manual - Page 9
... control. •• Replace the batteries with new fresh...(Magic Remote supported models only)
Troubleshooting
Cannot control ...guide panel, (Depending upon the product. Doing so may be interrupted. •• Check if the auto-off function is activated in the settings menu. •• If there is no sound is a problem...have the obligation to disclose source code, and to the touch, ...
Owners Manual - Page 11
... alternating current (AC). ALWAYS educate children about the dangers of the National Electric Code (U.S.A.). If the existing television set to Article 820-40 of climbing on which the television
is provided to call the CATV system installer's attention to a
suitable support. -- NEVER place items that the cable ground shall be located between the television...
Owners Manual - Page 15
... type) to RS-232C(Serial) cable
(PC) (TV) required for the connection between model series.
* Please be purchased from computer stores that not all models support this type of connectivity. * Cable is specified in the manual.
(PC)
2
RS-232C IN
(CONTROL & SERVICE)
(TV)
31
(PC) The connection interface may differ from your TV. Connect the...
Owners Manual - Page 16
...
OR 3 2 5
D-Sub 9
2 1 3 Phone
TXD RXD GND
Set ID For Set ID number, see "Real Data Mapping" on model) When you are finished, press EXIT.
* (Depending on p.6
1. Press SETTINGS to access the main menus. 2. The adjustment range is specified in the manual.
(TV) RS-232C IN
(CONTROL & SERVICE)
(PC) * For other models, connect to SET ID and press OK. 4.
Owners Manual - Page 17
... k
07. Screen Mute
k
04. Input
x
select (Main)
b
l
00 to 32
24. EXTERNAL CONTROL DEVICE SETUP 5
ENEGNLGISH
Communication Parameters
• Baud rate : 9600 bps (UART) • Data length : 8 bits • Parity : None
Command reference list
(Depending on model)
• Stop bit : 1 bit • Communication code : ASCII code • Use a crossed (reverse) cable.
Owners Manual - Page 19
...(Depending on model)
Ack [c][ ][Set ID][ ][OK/NG][Data][x]
* Using the PC input, you select either 16:9 or 4:3 screen aspect ratio.
* In DTV/HDMI/Component mode (high-definition), Just Scan is supported for DTV... fully, and ATV, AV partially.
03. You can also adjust mute using the Aspect Ratio in the PICTURE menu. or PICTURE menu. EXTERNAL CONTROL DEVICE SETUP 7
...
Owners Manual - Page 20
8 EXTERNAL CONTROL DEVICE SETUP
ENEGNLGISH
08. Sharpness (Command: k k) ►►To adjust the screen sharpness. Transmission [k][l][ ][Set ID][ ][Data][Cr]
..., use this mode. Transmission [x][u][ ][Set ID][ ][Data][Cr] Data Min : 00 to Max : 64
Ack [r][ ][Set ID][ ][OK/NG][Data][x] * (Depending on (plug-off & on model)
14. Transmission [j][p][ ][Set ID][ ][Data][Cr] Data Min...
Owners Manual - Page 21
... ][NG][Data 00][x]
• For South Korea, North/Latin America except Colombia Model
►►To tune channel to the satellite (DVB-S) Channel 1000.
EXTERNAL CONTROL DEVICE SETUP 9
ENEGNLGISH
18.
Transmission [j][v][ ][Set ID][ ][Data][Cr]
MSB
LSB
0000000 0
Frequency
Data
7 6 5 Frequency 4 3 2 1 0
Step
0 0 0 1st Band 0 0 0 0 0 0(decimal)
0 0 1 2nd Band 0 0 0 0 1 1(decimal...
Owners Manual - Page 22
...][Data 04][Data 05]
[x][a][ ][Set ID][ ][NG][Data 00][x]
• For Japan Model ►►To tune channel to the Analog cable (NTSC) channel 35. Use Physical Channel Number - 06 : Cable TV (CADTV) - Don't Use Physical Channel Number - 46 : Cable TV (CADTV) - Use Major Channel Number Only (One Part Channel) - 0b : Cable DTV...
Owners Manual - Page 23
...
90 : HDMI1 92 : HDMI3
91 : HDMI2 93 : HDMI4
Ack [b][ ][Set ID][ ][OK/NG][Data][x]
* This function depends on model and signal.
25. 3D(Command: x t) (only 3D models) (Depending on the model. EXTERNAL CONTROL DEVICE SETUP 11
ENEGNLGISH
2. Key (Command: m c) ►►To send IR remote key code.
Max : 14 (*transmit by Side 02 : Check Board 03...
Owners Manual - Page 24
...) is 09
00 : Standard 02 : Cinema 04 : Manual
01 : Sport 03 : Extreme 05 : Auto
Ack [v][ ][Set ID][ ][OK][Data00][Data01][x] [v][ ][Set ID][ ][NG][Data00][x]
27. Extended 3D(Command: x v) (only 3D models) (Depending on model)
►►To change 3D option for each 3D option determined by Hexadecimal
code) Data value range(0 - 20) converts Viewpoint range (-10...
LG 86UQ8000AUB Reviews
We have not received any reviews for LG yet.