GE ATP 1000 - Security Concord Alphanumeric Touchpad Support and Manuals
Get Help and Manuals for this General Electric item
Most Recent GE ATP 1000 Questions
Disconnecting Smoke Detector
Have The GE ATP1000 and have a GE ESL429/449 detectors. Have one bad. How can I disconncet that one ...
Have The GE ATP1000 and have a GE ESL429/449 detectors. Have one bad. How can I disconncet that one ...
(Posted by crick1960 3 years ago)
Alarm Is Not Hooked Up. However My Unit Won't Stop Beeping
(Posted by Cbeinke2 3 years ago)
How Do I Set Realtor Alarm Code? Thanks
(Posted by Anonymous-146449 9 years ago)
How To Change Date On Ativa At-p1000 Manual
(Posted by sajunksq 9 years ago)
Popular GE ATP 1000 Manual Pages
Installation Instructions - Page 1
... of compatible security systems (see the "Specifications" section). The door can be removed by the touchpad. • Table 2 describes the maximum wire lengths allowed between the touchpad and the panel. Tools and Equipment Needed
• 4-conductor, 22- See the panel installation instructions for cutting wallboard
Guidelines
• Mount the touchpad in speaker provides alarm, status, and...
Installation Instructions - Page 2
... to the matching panel
terminals (see
Table 2). 3. Figure 2. Insert anchors into the bottom of the touchpad.
2
ATP1000 Touchpad/Display Installation Instructions
Wiring the Touchpad to pull the wiring cable through. Gently tighten the screw into the wall at the top of the mount-
GND BUS B BUS A +12V
Figure 3. Run a 4-...
Installation Instructions - Page 3
...using the ATP1000 as a permanent part of the system, you must first connect a Programming Touchpad Cable (60-791) to the touchpad wires (see Programming Touchpad Cable Installation Instructions-466-1604, included with software version 2.0 or later:
1. Upon power up , connect the cable to the Programming Touchpad Header (see the specific panel installation instructions. At the touchpad, enter...
Installation Instructions - Page 4
...from Concord panels with software versions 1.0-1.6:
1. To adjust display brightness:
1. The display shows DOWNLOADING ON/OFF (current setting).
3. Press , and the display briefly shows DONE, then shows the time and date.
4
ATP1000 Touchpad/Display Installation Instructions Testing
Adjusting Display Brightness and Contrast
3. When programming is completed, simply disconnect the programming...
Installation Instructions - Page 5
...Check the touchpad display contrast setting. Note If the new touchpad unit number was previously learned by a switch. Touchpad display appears blank, but beeps sound when buttons are pressed).
Press ƒ. However, if the new touchpad unit number has never been
ATP1000 Touchpad/Display Installation Instructions
5 Table 3: Troubleshooting
Problem
Action/Solution
Touchpad doesn't power...
Installation Instructions - Page 6
...;‡uÃThv‡ÃQhˆyÃHIÃ$$ (à VT6ÃÉÃ8hhqh UrpuvphyÃT
6
ATP1000 Touchpad/Display Installation Instructions For systems with the instructions, may have previously learned a unit number that is a trademark of the following measures:
‰ Reorient or relocate the receiving antenna. ‰ Increase...
GE ATP 1000 Reviews
We have not received any reviews for GE yet.