Hayward NorthStar Support and Manuals
Get Help and Manuals for this Hayward item
View All Support Options Below
Free Hayward NorthStar manuals!
Problems with Hayward NorthStar?
Ask a Question
Free Hayward NorthStar manuals!
Problems with Hayward NorthStar?
Ask a Question
Most Recent Hayward NorthStar Questions
Hayward Northstar Pool Pump .where Is The Capacitor?
(Posted by omidmsirro 9 years ago)
Does The Hayward Spx1610z2mns Pump Motor Have A Switch
(Posted by bry0PATRI 9 years ago)
How To Wire Hayward Northstar Pool Motor
(Posted by bzichucks 9 years ago)
What Type Of Capacitor Is In The Northstar Pump?
(Posted by kph10blacko 9 years ago)
How To Fix Hayward Northstar Pump Leak
(Posted by tukiseansa 9 years ago)
Hayward NorthStar Videos
Hayward Northstar Shaft Seal Removal & Repair
Duration: 5:56
Total Views: 3,605
Duration: 5:56
Total Views: 3,605
Hayward Northstar Pool Pump Seal Change
Duration: 4:38
Total Views: 702
Duration: 4:38
Total Views: 702
Hayward Northstar Motor End Bell Removal
Duration: 1:07
Total Views: 204
Duration: 1:07
Total Views: 204
Hayward Northstar Strainer Pump Basket Cleaning
Duration: 1:29
Total Views: 2,096
Duration: 1:29
Total Views: 2,096
Popular Hayward NorthStar Manual Pages
All NorthStar models - Page 1
...A
OWNER'S MANUAL
INSTALLATION, OPERATION, & PARTS
NorthStarTM Pump Series
*50HZ Models are not UL Listed. NOTE - Required: 2" plumbing minimum Recommended: 2 ½" plumbing or larger
SAVE THIS INSTRUCTION MANUAL
HAYWARD POOL PRODUCTS
620 DIVISION STREET ELIZABETH, NJ 07207 (908) 351-5400 WWW.HAYWARDPOOL.COM The NorthStar is equipped with large capacity filters, heaters, and pool cleaning...
All NorthStar models - Page 2
... with storable pools. Select a well-drained area, one of the following : Failure to follow instructions may also be readily disassembled for storage.
It can cause severe injury and/or death.
WARNING - This product should always be installed and serviced only by a qualified professional.
CAUTION - It requires free circulation of non-Hayward replacement parts voids warranty...
All NorthStar models - Page 3
...codes applicable. -
NorthStar™ Pump Series
Page 3 of a vacuum release or vent system, which relieves entrapping suction, is recommended.
WARNING - Connect a No. 8 AWG (8.4 mm2) solid copper bonding wire to the pressure wire connector provided on the motor housing and to all metal parts... ONLY HAYWARD GENUINE REPLACEMENT PARTS Notes to reinforcing rod or mesh.
Replace damaged,...
All NorthStar models - Page 4
... support, plus versatility for burns. WWW.HAYWARDPOOL.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pool and spa water circulation systems operate under
hazardous pressure during pump start -up . Failure to follow safety and operation instructions could result in violent separation of pump components. Before starting system pump, all internal parts.
Strainer cover must be removed...
All NorthStar models - Page 5
... discharge piping. Keep motor clean. Pump mount must equal or be as close to pool as practical and run suction lines as direct as possible.
Select a well-drained area that a minimum length of 15
HP 3/4 1 1 1/2 2 2 1/2 3
FR "A" 13 1/4" 13 1/2"
14" 14 3/4"
N/A 16 1/4"
MR "A" N/A
13 1/4" 13 1/2"
14" 14 3/4" 16 1/4"
FR: Full Rate MR: Max Rate
Installation Instructions
WARNING -
All NorthStar models - Page 6
... threaded connections on the motor housing and to all metal parts of a
swimming pool filtration system operate under motor canopy or access place; Wind the tape clockwise as friction is adequate for all applicable local codes,
regulations, and the National Electric Code (NEC). Use a non-entrapping suction fitting in thread stops.
Grounding And Bonding
Install, ground, bond, and...
All NorthStar models - Page 7
... at a water temperature no longer than 100° F (38° C). 5.
WARNING -
WWW.HAYWARDPOOL.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Remove any trapped air in the system by fully opening filter manual air relief valve until a
steady stream of 15
Electrical (cont'd.)
Wiring
WARNING - Use the load circuit breaker as filter air relief
valve (if available...
All NorthStar models - Page 8
...-
Turn on strainer housing; Storage/Winterization
WARNING - Use only a low pressure (below 5 PSI), high volume blower when air purging the pump, filter, or piping.
Tighten strainer cover lock ring by hand only (no wrenches).
Do NOT use water to tighten cover. Separation Hazard. WWW.HAYWARDPOOL.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Before removing strainer cover...
All NorthStar models - Page 9
... HAYWARD GENUINE REPLACEMENT PARTS Exercise extreme care in your local authorized Hayward Dealer or
service center if you have any questions. Disconnect all inlets to motor
before beginning shaft seal replacement. NorthStar™ Pump Series
Page 9 of the pump/strainer housing (item #3), exposing the diffuser (item #10).
Contact your pool/spa system. Removing the Motor Assembly...
All NorthStar models - Page 10
...
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS NOTE - Gently wipe the polished face of the ceramic seal (item #13) with a dilute solution of this manual for pump component locations.)
13. Lubricate the rubber cup on the ceramic seat and press it . Slide the motor assembly with the diffuser (item #10) in step #4. Replace motor cover to pump/strainer housing (item #3) by...
All NorthStar models - Page 11
...USE ONLY HAYWARD GENUINE REPLACEMENT PARTS No. Part No. 1 SPX3200UNKIT 2 SPX3200UG 3 SPX4020TP 4 SPX4000M 5 SPX4000S
6 & 7 SPX4000CLO SPX4000CLOB
8 SPX4000T 9 SPX4000Z1 10 SPX4000B 11 SPX3021R
12 See SKU Detail
Description Union Connector Kit (Includes Union Nut, Union Connector, Union Gasket - 2 ea.) Union Gasket Pump Strainer Housing, 2" x 2 1/2" with Drain Plugs, threaded style Strainer Basket...
All NorthStar models - Page 12
... ONLY HAYWARD GENUINE REPLACEMENT PARTS No. Part No. 13 SPX4000SA2 14 SPX4000E 15 SPX0125Z44 16 SPX4000F 17 SPX4000K 18 See SKU Detail
19 & 20 SPX4000FG 21 SPX4000GA 22 SPX1600Z52
Description Shaft Seal Assembly Seal Plate Motor Cap Screws Motor Mounting Plate Motor Lock Ring Motor Drain Plug with O-Ring Mounting Base w/2 Cap Screws Mounting Base Cap Screw Kit (set of 15
Parts...
All NorthStar models - Page 13
... firmly in the suction piping may be certain it is heavy enough. Low Flow - Undersized pool piping. WWW.HAYWARDPOOL.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS NorthStar™ Pump Series
Page 13 of overheating. Manually check rotation of "Shaft Seal Change Instructions" in suction. Motor Shuts OFF - The "thermal overload protector" will result in the cover o-ring groove...
All NorthStar models - Page 14
... pump housing.
Solution: Mount the pump on a level surface and secure the pump to improper mounting, etc. Motor bearings noisy from return fittings). PRODUCT REGISTRATION
(Retain For Your Records)
DATE OF INSTALLATION INITIAL PRESSURE GAUGE READING (CLEAN FILTER PUMP MODEL HORSEPOWER FILTER MODEL SERIAL NUMBER
WWW.HAYWARDPOOL.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Solution...
All NorthStar models - Page 15
....COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS No returns may not apply to you may also have other conditions and terms of purchase/installation, or REGISTER ONLINE AT WWW.HAYWARDPOOL.COM. Hayward Pool Products 620 Division Street Elizabeth, NJ 07207
▲Retain this pump, Hayward Pool Products, 620 Division Street, Elizabeth, New Jersey, warrants its pump housing/strainer to be...
Hayward NorthStar Reviews
We have not received any reviews for Hayward yet.