Hardware Manual
Page 43
Table 1-2. Maximum rank count exceeded. Memory." Memory." About Your System 43 The USB ports are installed in a valid configuration. The system will run but with the specified memory module disabled. See "General Memory Module Installation Guidelines." Power down and restart the system from the power button, and then enter the System Setup program to change settings...
Table 1-2. Maximum rank count exceeded. Memory." Memory." About Your System 43 The USB ports are installed in a valid configuration. The system will run but with the specified memory module disabled. See "General Memory Module Installation Guidelines." Power down and restart the system from the power button, and then enter the System Setup program to change settings...
Hardware Manual
Page 60
... in all available power states. Logical Processor (Enabled default) On processors that support Simultaneous MultiThreading (SMT) technology, each processor core supports up to All, the maximum number of Cores per Processor (All default) If set to Enabled, the BIOS reports both logical processors. C States (Enabled default) When set to two logical...
... in all available power states. Logical Processor (Enabled default) On processors that support Simultaneous MultiThreading (SMT) technology, each processor core supports up to All, the maximum number of Cores per Processor (All default) If set to Enabled, the BIOS reports both logical processors. C States (Enabled default) When set to two logical...
Hardware Manual
Page 65
...• Active Power Controller sets the CPU power to System DBPM, the fan power to Minimum Power, and the memory power to Maximum Performance. Options are OS DBPM, System DBPM, Maximum Performance, or Minimum Power. For all but the Custom setting, the BIOS pre-configures the power settings on processor utilization... screen as follows: • OS Control sets the CPU power to OS DBPM, the fan power to Minimum Power, and the memory power to Maximum Performance. If you select Custom, you can configure each option independently. Using the System Setup Program and UEFI Boot Manager 65
...• Active Power Controller sets the CPU power to System DBPM, the fan power to Minimum Power, and the memory power to Maximum Performance. Options are OS DBPM, System DBPM, Maximum Performance, or Minimum Power. For all but the Custom setting, the BIOS pre-configures the power settings on processor utilization... screen as follows: • OS Control sets the CPU power to OS DBPM, the fan power to Minimum Power, and the memory power to Maximum Performance. If you select Custom, you can configure each option independently. Using the System Setup Program and UEFI Boot Manager 65
Hardware Manual
Page 92
... the control panel. Figure 3-9. See "Closing the System." 6 Reconnect the system to servicing that came with the product. NOTE: Maximum dimensions supported for the USB memory key are 24-mm (.94-in) wide, 79-mm (3.11-in) long, and 8.6-mm (.33-in your warranty. See ...online or telephone service and support team. Removing or Installing a USB Memory Key 1 3 2 1 control panel board 3 USB memory key 2 USB memory key connector 5 Close the system. Read and follow the safety instructions that is not authorized by Dell is not covered by a certified service technician. See Figure 3-9. ...
... the control panel. Figure 3-9. See "Closing the System." 6 Reconnect the system to servicing that came with the product. NOTE: Maximum dimensions supported for the USB memory key are 24-mm (.94-in) wide, 79-mm (3.11-in) long, and 8.6-mm (.33-in your warranty. See ...online or telephone service and support team. Removing or Installing a USB Memory Key 1 3 2 1 control panel board 3 USB memory key 2 USB memory key connector 5 Close the system. Read and follow the safety instructions that is not authorized by Dell is not covered by a certified service technician. See Figure 3-9. ...
Hardware Manual
Page 129
...; Quad-rank RDIMMs (two per channel) are supported for a total of up to 96 GB. • 1-GB and 2-GB UDIMMs are unused, all expansion cards in the expansion-card slots. The maximum memory that are supported for a total of three memory sockets per channel. • Except for each channel is organized into two sets of system...
...; Quad-rank RDIMMs (two per channel) are supported for a total of up to 96 GB. • 1-GB and 2-GB UDIMMs are unused, all expansion cards in the expansion-card slots. The maximum memory that are supported for a total of three memory sockets per channel. • Except for each channel is organized into two sets of system...
Hardware Manual
Page 156
...that the NIC ports are bound. If all set to servicing that is not authorized by Dell is not covered by a certified service technician. Damage due to the same data transmission ..., hubs, and switches on the network are of the proper type and do not exceed the maximum length. See the documentation for each network device. 7 Ensure that all network cables are all ... See "Installing System Components." • Cooling shroud • Hard drives • SD cards • USB memory key • NIC hardware key • Internal SD Module • Expansion cards and both expansion-card risers ...
...that the NIC ports are bound. If all set to servicing that is not authorized by Dell is not covered by a certified service technician. Damage due to the same data transmission ..., hubs, and switches on the network are of the proper type and do not exceed the maximum length. See the documentation for each network device. 7 Ensure that all network cables are all ... See "Installing System Components." • Cooling shroud • Hard drives • SD cards • USB memory key • NIC hardware key • Internal SD Module • Expansion cards and both expansion-card risers ...
Technical Guide
Page 45
... Gb/s backplane interface for optical and/or TBU N/A (no HDD) Internal or external SCSI tape/ legacy Yes-Max 2 PCIe slot external storage N/A N/A x8 Yes x1 int N/A N/A SCSI int N/A N/A SCSI ext A maximum of 2 external storage controllers (Dell PERC or SAS cards) are allowed in the system in addition to the integrated storage controller. PowerEdge R710 ...Table 12. A battery is also available for backup. The PERC H700 card has its own processor with a PCI Express Gen2 host interface and DDR2 memory and installs into the dedicated internal SAS slot on the internal H700.
... Gb/s backplane interface for optical and/or TBU N/A (no HDD) Internal or external SCSI tape/ legacy Yes-Max 2 PCIe slot external storage N/A N/A x8 Yes x1 int N/A N/A SCSI int N/A N/A SCSI ext A maximum of 2 external storage controllers (Dell PERC or SAS cards) are allowed in the system in addition to the integrated storage controller. PowerEdge R710 ...Table 12. A battery is also available for backup. The PERC H700 card has its own processor with a PCI Express Gen2 host interface and DDR2 memory and installs into the dedicated internal SAS slot on the internal H700.