Product Manual
Page 11
... is then reset for the Switch to a remote network device: an open circuit (a lack of the Switch include Power, 100/1000Mbps, and Link/Act. Any of these LED indicators follows (see the Link LED to a station successfully and has a good link. NOTE: The Cable Diagnostic function does not support 10M/100M. D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch LED Indicators...
... is then reset for the Switch to a remote network device: an open circuit (a lack of the Switch include Power, 100/1000Mbps, and Link/Act. Any of these LED indicators follows (see the Link LED to a station successfully and has a good link. NOTE: The Cable Diagnostic function does not support 10M/100M. D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch LED Indicators...
Product Manual
Page 15
When power is powered on, the LED indicators will momentarily blink. Power Failure As a precaution, in . 8 8 This blinking of the LED indicators represents a reset of a power failure, unplug the Switch. D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Power On Plug one end of the AC to DC power converter into the power connector of the Switch and the other end into the local power source outlet. After the Switch is resumed, plug the Switch back in the event of the system.
When power is powered on, the LED indicators will momentarily blink. Power Failure As a precaution, in . 8 8 This blinking of the LED indicators represents a reset of a power failure, unplug the Switch. D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Power On Plug one end of the AC to DC power converter into the power connector of the Switch and the other end into the local power source outlet. After the Switch is resumed, plug the Switch back in the event of the system.