ZyXEL omni.net LCD Support and Manuals
Get Help and Manuals for this ZyXEL item
This item is in your list!
View All Support Options Below
Free ZyXEL omni.net LCD manuals!
Problems with ZyXEL omni.net LCD?
Ask a Question
Free ZyXEL omni.net LCD manuals!
Problems with ZyXEL omni.net LCD?
Ask a Question
Popular ZyXEL omni.net LCD Manual Pages
Quick Start Guide - Page 3
Omni 56K Plus Modem Quick Start Guide
1 Introduction
Models included in this guide at the time of free disk space for the driver and software. • A USB-equipped computer with a functioning USB controller.
2.2 COM Plus
To install the COM Plus you will need the following minimum system requirements: • Microsoft Windows 95/98 SE (Second Edition)/Me (Millennium
Edition)/2000/XP. •...
Quick Start Guide - Page 6
...adaptor (use a power adaptor not appropriate for the ZyXEL Omni 56K COM Plus modem, your COM Plus to turn on -hook status (the telephone line is available) There is busy).
Omni 56K Plus Modem Quick Start Guide
LED OH
DATA MR
FUNCTION Hook Status
RS232 Status Modem... phone or fax.
2. The modem is not ready. Push in on the COM Plus.
Connect your modem
could be damaged.
4.
Quick Start Guide - Page 7
..., you may go to the manual installation section to install your computer, then plug the USB cable back in again. Other Windows screens are shown here.
The plug and play function of Windows detects your USB driver. Omni 56K Plus Modem Quick Start Guide
Figure 4 Rear Panel Connections
4 Software Installation
4.1 USB Plus
Follow the steps below to install your new device and shows...
Quick Start Guide - Page 9
After the ZyXEL Omni 56K USB Plus modem has been installed successfully, click Finish to enter Control
Panel.
Manual Installation Screens for Windows 2000 are shown here. 1. Double-click on . 2. Be sure your USB driver. Click Start, select Settings to complete the driver installation. Windows 98 SE/Me/2000: The installation wizard has found the location of your modem is turned on the ...
Quick Start Guide - Page 10
... of Plug and Play installation to install your COM Plus modem driver. Windows XP: Please wait for Windows 2000 are similar.
10 Omni 56K Plus Modem Quick Start Guide 3. Other Windows screens are shown here. Screens for few minutes while Windows detects the modem.
5. After the ZyXEL Omni 56K USB Plus modem has been installed successfully, click Finish.
4.2 COM Plus
Follow the steps...
Quick Start Guide - Page 13
...-up connection after you . Screens for your ISP to setup your ISP gave you finish. Windows creates an icon for Windows 2000 are shown here. 1. After the ZyXEL Omni 56K COM Plus modem has been installed successfully, click Finish.
5 Dial-up networking connection. Windows 2000: Click Start, Settings, Network and Dial-up Networking, double-click Make...
Quick Start Guide - Page 16
... driver. Follow the wizard to complete the installation.
7 Uninstalling your computer if prompted.
8 Troubleshooting
16 Enter "Yes" to continue. 6. Windows 98SE/Me/2000: Click Start, Settings, Control Panel,
double-click Add/Remove Programs and select ZyXEL OMNI 56K USB Plus Modem (or ZyXEL OMNI 56K COM Plus Modem). Click Change/Remove, then Remove. 5. Omni 56K Plus Modem Quick Start Guide...
Quick Start Guide - Page 17
...If the error persists, you may have a hardware problem. Make sure the Line port is not present, install the modem driver. Carefully follow the instructions to uninstall and reinstall the software driver.
If ZyXEL OMNI 56K USB Plus is properly connected to the USB port on and connected to the phone jack with a different USB device or try using a different USB cable).
Connect...
Quick Start Guide - Page 18
... your computer. Carefully follow the instructions to plug the phone directly into the Phone port and see if the RS-232 cable works with a different device with a telephone wire. Check the telephone wire (use it to uninstall and reinstall the software driver.
Omni 56K Plus Modem Quick Start Guide
8.2 COM Plus
PROBLEM
CORRECTIVE ACTION
None of the...
User Guide - Page 8
... the Omni 56K USB Plus and/or Omni 56K COM Plus modems as the Omni 56K Plus. This manual may also be included.
• "Enter" means for programming or other applications. Quick Start Guide The Quick Start Guide is the latest firmware version that should have come in Bold Times New Roman font. User's Guide Feedback
Help us help you to install your...
User Guide - Page 11
...56K USB Plus only). Models included in this series at the time of 56Kbps. Introduction
1-1 Support Fax class 1, class 2 and class 2.0 command set. Voice digitization and compression. V.92 56K up/down-stream data transmission.
Omni 56K Plus Series User's Guide
Chapter 1 Introduction
This chapter introduces you to the features and specifications for the ZyXEL Omni 56K USB Plus and...
User Guide - Page 13
...
ITEM Power Requirements Operating Requirements
Weight
Dimensions
SPECIFICATION DESCRIPTION 9V AC (Omni 56K COM Plus only) Temperature: 0° C to 40° C Humidity: 20 to 90 % (non-condensing) Omni 56K COM Plus: 194.6 g Omni 56K USB Plus: 170.4 g 112.5 mm (W) x 29 mm (H) x 106 mm (L)
2.2 Firmware Specifications
Table 2-2 Firmware Specification
Physical layer for data mode
Multi-Auto...
User Guide - Page 35
...-error control connection.
*E1
If error control negotiation fails, disconnect the call back immediately.
ranges from -8 dBm to "ZyXEL".
If they match, the modem will disconnect the line, find the corresponding phone number and call (hang-up . Omni 56K Plus Series User's Guide
COMMAND *Dn *En *Gn
*HS *Hn *In *Pn *Qn
Table 4-4 Extended AT* Command Sets...
User Guide - Page 40
... on phase A hang up code. Omni 56K Plus Series User's Guide
Table 4-9 Supported Commands (per TIA PN2388 8/20/90)
COMMAND
DESCRIPTION
VALUE
Page bad; n=1
All other +F commands are byte aligned by the DCE, n=1 with necessary zero fill bits inserted. Transmit error on phase C hang up code. Report the non-standard setup frame response.
4-12
Command Sets n=0
The last received...
User Guide - Page 42
tpr=1:Transmitter parameters are not reported.
4-14
Command Sets nsr= 0:Non-standard frames are reported. idr= 0: ID Strings are reported. idr=1: ID Strings are not reported. Omni 56K Plus Series User's Guide
Table 4-11 Service Class 2.0 Commands
COMMAND
DESCRIPTION Page Width
Page Length
Data Compression Format
Error Correction Binary File Transfer Minimum Scan Time/Line
+FIS=...
ZyXEL omni.net LCD Reviews
Do you have an experience with the ZyXEL omni.net LCD that you would like to share?
Earn 750 points for your review!
We have not received any reviews for ZyXEL yet.
Earn 750 points for your review!