Rheem P-M406 Support and Manuals
Get Help and Manuals for this Rheem item
View All Support Options Below
Free Rheem P-M406 manuals!
Problems with Rheem P-M406?
Ask a Question
Free Rheem P-M406 manuals!
Problems with Rheem P-M406?
Ask a Question
Most Recent Rheem P-M406 Questions
What's Wrong When There Is Alway A Message : 'low Voltage' On The Display?
What's wrong when there is alway a message : "low voltage" on the display?
What's wrong when there is alway a message : "low voltage" on the display?
(Posted by ngskus3 6 years ago)
The Display Window Is Blank.
The heater is working but I can't adjust the temps or anything else for the unit. Can I replace the ...
The heater is working but I can't adjust the temps or anything else for the unit. Can I replace the ...
(Posted by Bill232323 6 years ago)
Clock/fireman Sw
the phrase clock/fireman sew keeps blinking. What does it mean
the phrase clock/fireman sew keeps blinking. What does it mean
(Posted by Nbergen7515 6 years ago)
No Pilot Sensed Ignition Lockout
not out of propane, pilot valve cleaned and not clogged, flame not even turning on so its not the se...
not out of propane, pilot valve cleaned and not clogged, flame not even turning on so its not the se...
(Posted by Kmccoy317 8 years ago)
Popular Rheem P-M406 Manual Pages
Brochure - Page 2
... uses real English, with a microprocessor-based control. Multi-unit installations can monitor the run and how many times it just made out of a heater. Known for our high quality, leading edge commercial boilers, it has fired.
an industry proven standard for the service professional.
Rheem engineered the Unitherm Governor specifically for Rheem to use a spark-to decipher...
Brochure - Page 3
... ability to a much harder surface and a wall that prevents excessive condensate production in U.S.A. ©2004-2011 Rheem, Inc. For dimensions and technical specifications,
see D-2 Power Vent manual for added protection against premature failure. Cupro-Nickel Fin Tube
Rheem heaters are capable of relieving flue gases up to attack copper heat exchangers and cause premature failure...
Operating Instructions - Page 1
....
Follow the gas sup-
This manual should be performed by a qualified installer, service agency or the gas supplier. INSTALLATION & OPERATING INSTRUCTIONS
Gas-Fired Pool & Spa Heater
Atmospheric Models 206A, 266A, 336A & 406A
Lo NOx Models 207A, 267A, 337A & 407A
WARNING: If these instructions are not followed exactly, a fire or explosion may result causing property damage, personal...
Operating Instructions - Page 3
...-Out Safety Switch
9
Winterizing the Pool & Spa Heater
38 High Limits
10 PART TWO
39 Pilot Safety
INSTALLATION & SERVICE INSTRUCTIONS 39 Burner Tray Removal (ATM)
10 SECTION 1
39 Gas Valve Removal (ATM)
RECEIVING EQUIPMENT
39 Main Burner and Orifice Removal (ATM)
11 SECTION 2
39 Pilot Removal and Cleaning
GENERAL SPECIFICATIONS
40 Heat Exchanger Removal
11 SECTION 3
40...
Operating Instructions - Page 4
... is available with water and that the pump is factory set from combustibles, flammable liquids and chemicals. This manual provides installation, operation, maintenance, and service information for years of the heater contains the control center that the system is an easy task. Section 4 of this manual contains more details about the use of combustion and ventilation air...
Operating Instructions - Page 5
.../Off switch to the lowest setting.
4. Replace heater door panel.
5 Since propane can accumulate in for gas. LIGHTING INSTRUCTIONS AND SHUT-OFF PROCEDURES
MILLIVOLT SYSTEM
(MANUALLY LIGHTED PILOT)
A.
WHAT TO DO IF YOU SMELL GAS: *Do not try to clear out any gas control which has been under water. Call a qualified service technician. Read the safety information...
Operating Instructions - Page 6
... the lowest setting.
3.
If you don't smell gas, go
to the next step.
If you
HONEYWELL VR 8300 GAS VALVE IID
GAS INLET
ROBERTSHAW 7000 GAS VALVE IID
then smell gas, STOP! Replace heater door panel. GAS CONTROL LEVER SHOWN IN "OFF" POSITION
10.
Push in a fire or explosion.
Turn gas control knob clockwise
6 OPERATING INSTRUCTIONS AND...
Operating Instructions - Page 10
... of your local representative. Located on the Bill of serial number. Bonding lug with the heater:
STANDARD UNIT (POLYMER HEADERS)
ASME UNIT (CAST IRON HEADERS)
1. RECEIVING EQUIPMENT
The manufacturer recommends that you visually check for the equipment. If the carton is damaged, report the damage to the carton. PART TWO INSTALLATION AND SERVICE INSTRUCTIONS
SECTION 1 -
Operating Instructions - Page 15
... (1) Adapter plate (3) Mounting brackets (clips) (3) Screws (1) Instructions
Clips
Model
206A/207A 266A/267A 336A/337A 406A/407A
OUTDOOR STACK
Part No.
009834 009835 009836 009837
INDOOR STACK
Part No. 009838 009839 009840 009841
** REFER TO INSTALLATION INSTRUCTIONS INSIDE BOX FOR INSTRUCTIONS ON HOW TO INSTALL OUTDOOR/INDOOR STACK.
15 Locate heater as close as is practical to follow this...
Operating Instructions - Page 19
... or chimney must be adequately supported to maintain proper clearances from the roof surface and at least 5 ft in . The weight of the heater gas controls, and a manual shut-off valve to the ...PIPE
VENT CAP 2' MIN
5' MIN
DRAFT HOOD
HEATER
Gas piping must be tested after installation in accordance with the local codes or, in the absence of such codes, to gas supply line. All gas piping ...
Operating Instructions - Page 20
... can be about 4.0 in addition to decrease pressure.
WC for propane gas. settings are non-adjustable; WC. The pressure at 4.0 in . WC natural
gas (3.1 in .
ELECTRONIC IGNITION GAS VALVES-CONTINUED
Gas Pressure Adjustment
Robertshaw 7200 (Heater Model 206)
Robertshaw 7000 BDER (Heater Models 266-336)
MANUAL SHUT-OFF
VALVE
UNION
Gas Pressure Adjustment
Robertshaw 7000 DERHC...
Operating Instructions - Page 38
... for deck-level installations.
Turn the filter pump on high limit. In these cases, the pump must be replaced when disabled by an
over-temperature condition, caused by turning the pump off . (A flat screwdriver may be of the dual switch type and set to shut off . This is too tight.) 6. On millivolt heaters the fireman...
Operating Instructions - Page 39
... from orifices. Remove gas
piping to the lighting instructions provided on page 43). Remove burner tray from direct-flame impingement and this usually necessitates replacement of these parts.
3. HIGH LIMIT REMOVAL
1. Remove defective high limit and replace with wire or small brush. Replace inspection panel.
AFT Models The heater employs a pilot safety which act as a safety device...
Operating Instructions - Page 43
... and service personnel may be required by putting in hot water (110°F or higher). Replace if no movement, replace. Sooting
High flow rates
U.G. Replace pilot.
output(BTUH)
Pool gallonage x 8.33 or refer to installation instructions.
TROUBLESHOOTING
MECHANICAL
IMPORTANT NOTICE These instructions are specifically trained and experienced in pool External bypass setting...
Warranty - Page 2
..., or require the return of, the defective product or component part and to verify warranty coverage at 805-278-5300, supplying model number, serial number, date of original installation and a description of the problem.
RAYPAK'S SOLE LIABILITY WITH RESPECT TO ANY DEFECT SHALL BE AS SET FORTH IN THIS LIMITED WARRANTY.
ANY IMPLIED WARRANTIES, INCLUDING...
Rheem P-M406 Reviews
Rheem has a rating of 4.00 based upon 1 review.
Get much more information including the actual reviews and ratings that combined to make up the overall score listed above. Our reviewers
have graded the Rheem P-M406 based upon the following criteria:
- Durability [1 rating]
- Cost Effective [1 rating]
- Quality [1 rating]
- Operate as Advertised [1 rating]
- Customer Service [1 rating]