KitchenAid KFDC506JSC Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid KFDC506JSC manuals!
Problems with KitchenAid KFDC506JSC?
Ask a Question
Free KitchenAid KFDC506JSC manuals!
Problems with KitchenAid KFDC506JSC?
Ask a Question
KitchenAid KFDC506JSC Videos
KitchenAid KFDC506JSC Cuisinière
Duration: :35
Total Views: 0
Duration: :35
Total Views: 0
KitchenAid KFDC506JSC Range
Duration: :37
Total Views: 0
Duration: :37
Total Views: 0
Popular KitchenAid KFDC506JSC Manual Pages
Owners Manual - Page 4
... not repair or replace any slots, holes or passages in
cabinets above a range or on any part of ... until they are dark in the manual.
They should never be allowed to...Servicing -
Among those areas are suitable for details. Verify the anti-tip bracket has been properly installed and engaged per installation instructions. TO CHECK IF THE DEVICES ARE INSTALLED...
Owners Manual - Page 14
...error is completed. Cancel
To Cancel
To cancel the oven operation and turn off in idle mode even when the unit is taken after the mode and setting...models only)
USE AND LIGHT BEHAVIOR
Pulsing White Light
The start button will illuminate white.
Solid White Light
When a mode or setting...the unit is powered on , mode can send instructions to the OFF position.
14
All lights will ...
Owners Manual - Page 16
... Operation
Models are...will be remotely operated. Reference the "Internet Connectivity Guide" for Sabbath Mode.
NOTE: If there are ...manually added. Follow the prompts in the BAKE position. Broil Medium or Convect Pastry)
■■ Adjust cooking temperatures and times
■■ Set...the "Remote Enable" section for the SAID code on your Connected Appliance at the appliance....
Owners Manual - Page 23
... cool. Use a straight pin.
If the burner still does not light, do not service the sealed burner yourself. CARE AND CLEANING
COOKTOP SURFACE
IMPORTANT: ■■ Before cleaning...; Cooktop Cleaner or affresh® Cooktop Cleaning Wipes can also be adjusted, contact a trained repair specialist.
4. Replace burner cap. Do not use oven cleaners, bleach, or rust removers. ■■ Soap...
Owners Manual - Page 30
...problem continues, call , refer to the "Warranty" or visit https://kitchenaid.com.
A Delay Start has been set... repair ...set via the App. The electronic oven control is set to perform.
See the Installation Instructions for disabling. It is normal for some models, the Sabbath Mode is not set to H or L, depending upon the type of the surface burner and contact a service...
Owners Manual - Page 31
... proper air circulation around bakeware and oven walls. If you avoid a service call, refer to install in the pan.
The proper length of time is level in adjacent ...Baked items are followed when setting the desired function, the oven will preheat before cooking.
TROUBLESHOOTING
First try the solutions suggested here. POSSIBLE CAUSES
The set temperature did not perform as...
Owners Manual - Page 32
...; appliance. Or visit our website at 1-800-807-6777 and follow the instructions below. If you still need further assistance, you can write to "Replacement Parts. When calling, please know the purchase date and the complete model and serial number of a service call the KitchenAid Customer eXperience Center toll free at www.kitchenaid.ca. These...
Installation Instructions - Page 5
... the range.
■ Follow the range hood or microwave hood combination installation instructions for Mobile Home Construction and Safety, Title 24, HUD Part 280). See the "Install Anti-Tip Bracket" section. ■ Burner grates ■ Burner caps ■ Griddle drip tray (on griddle models)
Parts Needed
■ All models must be available. Location Requirements
IMPORTANT: Observe all...
Installation Instructions - Page 7
...'s instructions.
7 A copy of the above code standards can result in conformance with the rating of the range must be conducted according to a regulated gas supply. Electrical Requirements: Canada Only
WARNING
Electrical Shock Hazard
Electrically ground range. latest edition - IMPORTANT: This installation must conform with the CSA Standard C22.1, Canadian Electrical Code, Part...
Installation Instructions - Page 8
... cm) male pipe thread is factory set for use the Propane gas conversion kit ... be used . Flexible metal appliance connector:
■ If local codes permit, a new CSA design-certified, 4-5 ft (122-152 cm... Must include a shut-off valve: Install a manual gas line shut-off valve.
Gas...service technician. The parts for use TEFLON®† tape. A smaller size pipe on the model...
Installation Instructions - Page 9
... or other injury.
2. For 48" (121.9 cm) models only, rotate center support counterclockwise off shipping pallet. a. Lift range up about 3" (8.0 cm) and move it back until it stops. This surface should be flat and covered with a soft blanket, or use the corner posts from range. A. INSTALLATION INSTRUCTIONS
Unpack the Range
WARNING
Excessive Weight Hazard...
Installation Instructions - Page 11
... are available from your range using the following installation instructions. Explosion Hazard
Use a new CSA International approved... made for electrical connections to be wrench-tightened. Manual gas shut-off valve. Adapter
11 See the ... and authorized service personnel.
C. Drill two 1/8" (3.0 mm) holes that connector is not kinked. Anti-tip bracket 4. Continue installing your local...
Installation Instructions - Page 12
...manual shut-off valves are set . Closed valve B. Install Griddle Tray
(On griddle models)
The griddle is parallel to OFF. This allows the gas to the Use and Care Guide...please contact your dealer or authorized service company for the rear leveling ...and grates from parts package. Place...Guide. After verifying the proper burner operation, turn the Control Knobs to the user instructions...
Installation Instructions - Page 15
...the nut driver while changing it. A
NAT
LP
B C
NAT
D
NAT
LP
NAT
LP
E
LP
4. Set gas orifice...manual shut-off valve must be disconnected from Natural Gas to the regulator should be as follows for operation and checking the regulator setting...parts bag for the remaining burners. Replace burner cap. 9. Locate the "LP" and "NAT" position on the model/serial/rating plate. Replace...
Installation Instructions - Page 18
...parts bag for more information on the spring retainer. Fuel type stamp (L or N)
6. Replace the burner base and screws. Adjusting Simmer Low Setting on the model/serial/rating plate. 5. Turn over -tighten.
8.
Insert nut driver...manual shut-off valve must be checked at test pressures equal to the regulator should be as follows for operation and checking the regulator setting...installed...
KitchenAid KFDC506JSC Reviews
We have not received any reviews for KitchenAid yet.