KitchenAid KFGC558JMB Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid KFGC558JMB manuals!
Problems with KitchenAid KFGC558JMB?
Ask a Question
Free KitchenAid KFGC558JMB manuals!
Problems with KitchenAid KFGC558JMB?
Ask a Question
KitchenAid KFGC558JMB Videos
KitchenAid KFGC558JMB Range
Duration: :37
Total Views: 0
Duration: :37
Total Views: 0
KitchenAid KFGC558JMB Cuisinière
Duration: :35
Total Views: 1
Duration: :35
Total Views: 1
Popular KitchenAid KFGC558JMB Manual Pages
Owners Manual - Page 4
... RANGE MUST BE SECURED BY PROPERLY INSTALLED ANTI-TIP DEVICES. Doing so may result in death or serious burns to
persons, or damage when using the range.
I Storage in the manual.
I Never Leave Surface Units Unattended at High Heat Settings -
I WARNING: NEVER cover any part of a range - I User Servicing - Boilover causes smoking and greasy spillovers...
Owners Manual - Page 16
...to the OFF position. Reference the "Internet Connectivity Guide" for the SAID code on your mobile device. App Features
The KitchenAid...failure occurs when the Sabbath Mode is set and the appliance is to be scanned or manually added. Download the KitchenAid™ app...Connectivity and Remote Operation
Models are provided with a Wi-Fi module that certain features and modes are set , the oven ...
Owners Manual - Page 23
...repair specialist.
4. Replace burner cap. Do not use oven cleaners, bleach, or rust removers. ■■ Soap, water, and a soft cloth or sponge are cool. Use a straight pin.
If the burner still does not light, do not service...cooktop are suggested first. If the burner needs to be used. Contact a trained repair specialist.
2. Clean gas opening with damp cloth.
23 Do not enlarge or...
Owners Manual - Page 30
.... Push in keeping with burner. Contact a trained repair specialist. The oven door is not set to automatically run while the oven is in the same cavity within 12 hours. If sparking continues, discontinue use or for the fan to the proper heat level.
See the Installation Instructions for the function you have properly followed...
Owners Manual - Page 31
TROUBLESHOOTING
First try the solutions suggested here. The proper bakeware is not being used is not being cooked.
Pie crust edges are followed when setting the desired function, the oven will preheat before cooking.
If you avoid a service call, refer to the "Warranty" or visit https://kitchenaid.com. POSSIBLE CAUSES
The set...pan. Install the bottom rack first and then install the...
Owners Manual - Page 32
...toll free: 1-800-807-6777. To locate the KitchenAid designated service company in your area, you still need to order replacement parts, we recommend that you the cost of appliances.
■■ Installation information.
■■ Use and maintenance procedures.
■■ Accessory and repair parts sales.
■■ Specialized customer assistance (Spanish speaking, hearing...
Installation Instructions - Page 5
...caps ■ Griddle drip tray (on griddle models)
Parts Needed
■ All models must be installed with local codes. Check local codes and consult gas supplier. Check existing gas ... or microwave hood combination installation instructions for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. In Canada, the installation of flooring may differ. 30" (76.2 cm) models
A
B
D C...
Installation Instructions - Page 8
...model/serial/rating plate.
IMPORTANT: All connections must be disconnected from the gas supply piping system by a qualified service...minimum. Flexible metal appliance connector:
■ If local codes permit, a new CSA design-certified, 4-5 ft (...Install a manual gas line shut-off valve open position C. The inlet pressure to Propane gas, use with Natural gas.
The model...factory set for ...
Installation Instructions - Page 9
... used only for installation.
3.
For 48" (121.9 cm) models only, rotate center support counterclockwise off shipping pallet. Lift range up about 3" (8.0 cm) and move it back until range is not needed for shipping and is off the pallet until the range is ready to avoid scratching. Set range on the floor behind range. Lay...
Installation Instructions - Page 12
...the manual shut-off valves are properly positioned on
burner bases. Correct any position, the system creates a spark to OFF. Place grates over burners and caps. 4.
Install Griddle Tray
(On griddle models)
The... rods one full turn the Control Knobs to the user instructions located in the well at this point, contact your service provider. Place burner caps on top of air in and...
Installation Instructions - Page 15
...driver into the gas opening and press down onto the gas orifice spud and remove by first removing (2) T-20 screws. Burner base
13,000 BTUs 99 50
0.99 mm Large burner - Replace the burner base and screws. Adjusting Simmer Low Setting on the model...LP" are installed, remove them. 2. Turn over -tighten.
8. Tighten the gas pressure regulator cap by closing its individual manual shut-off...
Installation Instructions - Page 18
... with a letter and a number.
Bracket
7. Replace oven bake burner electrode inside bracket. Oven bake burner electrode B. Propane gas orifice spud
8.
6. Insert nut driver into the gas opening, and press down on the clip on the electrode bracket. Oven bake burner electrode bracket
12. Set gas orifice spud aside. Install the Number 125 oven bake...
Installation Instructions - Page 19
... cover, and slide to left or right to help hold the gas orifice spud in the nut driver while changing it slides out of the hole in plastic parts bag for illustration. A
A. A
A
BC
A. Oven back B. Replace the broil burner in the hole in back of the oven.
2. Reinstall the oven broil burner screw...
Installation Instructions - Page 23
...B. Set propane gas orifice spud aside. Replace with package containing literature.
7. Line pressure testing at test pressures in and the letters "NAT" are installed, ... sure to help hold the control console in plastic parts bag for more information on burner ratings and locations....on the model/serial/rating plate. Adjusting Simmer Low Setting on each side of a 7 mm nut driver to ...
Installation Instructions - Page 27
... of oven
3. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver to slide shoulder screws into the narrow ends of the oven while you until it . Set propane gas orifice spud aside. Replace the broil burner in the hole in plastic parts bag for illustration. The screw is aligned with package containing literature...
KitchenAid KFGC558JMB Reviews
We have not received any reviews for KitchenAid yet.