D-Link DIR-813 Support and Manuals
Get Help and Manuals for this D-Link item
View All Support Options Below
Free D-Link DIR-813 manuals!
Problems with D-Link DIR-813?
Ask a Question
Free D-Link DIR-813 manuals!
Problems with D-Link DIR-813?
Ask a Question
Popular D-Link DIR-813 Manual Pages
User Manual - Page 3
...Installation 5 Before you Begin 5 Wireless Installation Considerations 6 Manual Setup 7
Configuration 10 Setup Wizard 10 Web-based Configuration Utility 14 Internet Setup 15 Static (assigned by ISP 15 Dynamic 16 PPPoE 17 PPTP 18 L2TP 19 Wireless Settings...Date 39 Firmware Update 40
Language Pack 40 Dynamic DNS (DDNS 41 System Check 42 Device Info 43
D-Link DIR-813 User Manual
ii
User Manual - Page 7
... supplied power adapter. The WPS LED will 4 WPS/Reset Button turn solid green when successfully connecting to a device. Press for eight seconds to reset the router back to start the WPS process. D-Link DIR-813 User Manual
3
WPS -
Reset - Press and hold the reset button for one second to the factory default settings.
User Manual - Page 16
..., enter the IP information and DNS settings supplied by your Wi-Fi Network and a password. Your wireless devices (i.e., tablets, smartphones, and laptops) will need to have this information entered to be able to connect to continue.
Click Connect at the bottom to your wireless network. D-Link DIR-813 User Manual
12 Section 3 - For both the...
User Manual - Page 18
If you want to run the setup wizard again, click Easy Setup on the left side. Click Log In to the settings your password (Leave the password blank by typing http://dlinkrouter in the address bar. The Setup > Internet page will appear. D-Link DIR-813 User Manual
14 Next to User Name enter Admin and then enter your want to...
User Manual - Page 19
... address assigned by your ISP. D-Link DIR-813 User Manual
15
Address:
Secondary DNS Enter the Secondary DNS server IP address. Section 3 -
Address:
MTU: Maximum Transmission Unit -
This is the default MTU.
Subnet Mask: Enter the Subnet Mask assigned by your ISP. MAC Address: The default MAC Address is set to change the MTU for optimal...
User Manual - Page 20
... use
what is set to MAC Address: copy the MAC address of the Ethernet adapter installed in
your ISP. D-Link DIR-813 User Manual
16
DNS These addresses will be required by some DSL services.
MTU: Maximum Transmission Unit - You may need to change the MTU for cable modem services and some ISPs.
The default host name is...
User Manual - Page 21
...through a router. This option is the default MTU.
You may need to change the MTU for optimal performance with a username and password. Select:
D-Link DIR-813 User Manual
17
DNS...password and then retype the password in
your ISP uses a PPPoE connection. MAC Address: The default MAC Address is set to remove your PPPoE software from your ISP assigned you with your specific...
User Manual - Page 22
...router. Connection Mode Select Always on the Broadband Router. Configuration
PPTP
Choose PPTP (Point-to the WAN's physical interface MAC address on for optimal performance. Select Static if your ISP (Internet Server: Service Provider.)
MAC Address: The default MAC Address is maintained during which the Internet connection Time: is set...Link DIR-813 User Manual
18
Maximum Idle Enter...
User Manual - Page 23
... Broadband Router. D-Link DIR-813 User Manual
19 This option is typically used for most common) or Static. User Name: Enter your ISP uses a L2TP connection. L2TP Gateway: Enter the Gateway IP Address provided by your specific ISP. Password: Enter your L2TP password and then retype the password in your ISP (Internet Server: Service Provider.)
MAC Address: The default MAC...
User Manual - Page 24
....
Transmission Usethedrop-downmenutoselecttheappropriateTransmission Rate: Rate in order to connect to be greyed out. Configuration
Wireless Settings
Wireless Mode: Select Wireless Router or Repeater Mode. The SSID is checked, the SSID of the DIR-813 will have to customize your DIR-813 in Mbits per second. Section 3 -
Enable Check this option is case-sensitive. The Channel can...
User Manual - Page 25
....
D-Link DIR-813 User Manual
21 The two major improvements over WEP:
• Improved data encryption through the Extensible Authentication Protocol (EAP).
The password can access the network. WPA/WPA2 incorporates user authentication through the Temporal Key Integrity Protocol (TKIP). This key must be the exact same key entered on a computer's hardware-specific MAC address...
User Manual - Page 26
... and enter the same Wi-Fi password as you enter this key exactly the same on your settings. Your wireless signal may degrade when enabling encryption due to Security Mode, select Enable WPA/WPA2 Wireless Security (enhanced). The password can also select WEP, WPA, or WPA2.
3. D-Link DIR-813 User Manual
22
Make sure you did on...
User Manual - Page 44
... pack, click Browse to your hard drive.
D-Link DIR-813 User Manual
40 Firmware Click the Check Now button (or the link at http://support.dlink.com. Click Upload to be used for firmware updates at the top of the Router here.
Make sure the firmware you have downloaded the new firmware, click Browse in this window to your hard drive...
User Manual - Page 68
... and plug back in. D-Link DIR-813 User Manual
64 If you forgot your the web management.
• If you still cannot access the configuration, unplug the power to the router for 10 seconds. Release the button and the router will change all your router. Click the LAN Settings button. The default IP address is checked. From the...
User Manual - Page 70
... for the device. • Click on Setup and then click Manual Configure. • To change the MTU rate on your router follow the steps below: • Open your email.
D-Link DIR-813 User Manual
66 For example, let's say that value and add 28 to the value to save your settings. • Test your browser, enter the...
D-Link DIR-813 Reviews
We have not received any reviews for D-Link yet.