Acer VW257 Support and Manuals
Get Help and Manuals for this Acer Computers item
Popular Acer VW257 Manual Pages
User Manual - Page 2
...of this manual or supplementary documents and publications. All correspondence concerning your computer. No part of Acer Incorporated. All Rights Reserved. Record the model number, ...specifically disclaims the implied warranties of such revisions or changes. Acer LCD Monitor User Guide
Model number Serial number Date of purchase Place of Acer Incorporated. The serial number and model...
User Manual - Page 5
...power cord meets the following the operating instructions Note: The grounding pin also provides good protection from the wall outlet and refer servicing to qualified service personnel when: • the power...cord plug. The overall system load must not exceed 80% of all servicing to replace the power cord set .
Unplug this product yourself, as opening or removing covers may interfere with...
User Manual - Page 9
.... Via Lepetit, 40, 20020 Lainate (MI) Italy Tel: +39-02-939-921 ,Fax: +39-02 9399-2913 www.acer.it
Product: Trade Name: Model Number: SKU Number:
LCD Monitor Acer VW257 VW257 XXXXXX; ("x" = 0~9, a ~ z, A ~ Z, or blank)
We, Acer Incorporated, hereby declare under our sole responsibility that the product described above is in
conformity with the relevant Union...
User Manual - Page 10
...acer.com
Federal Communications Commission Declaration of Conformity
This device complies with Part 15 of Responsible Party:
Contact Person: Phone No.: Fax No.:
LCD Monitor
VW257
VW257 xxxxxx ("x" = 0~9, a ~ z, or A ~ Z)
Acer... and (2) this declaration:
Product: Model Number: SKU Number: Name of Responsible Party:
Address of the FCC Rules. English
Acer America Corporation 333 West San Carlos ...
User Manual - Page 11
...(for selected models)
2
Screen position adjustment
3
Connecting the adapter and AC Power cord
3
Power saving
Display Data Channel (DDC)
Connector pin assignment
4
19-pin color display signal cable
4
20-pin color display signal cable
5
Standard timing table
6
Installation
7
Users controls
8
Panel controls
8
Using the Shortcut Menu
9
The Function page
10
Troubleshooting
15...
User Manual - Page 14
...For units using 120 V AC: Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V.
• For units using 220/240 V AC: Use a cord set should have the appropriate safety approvals for the country in either 100... power supply that the power cord you use is activated. The cord set consisting of the AC power cord to make sure that allows operation in which the equipment will be...
User Manual - Page 15
... DDC2B standard.
20-pin color display signal cable
PIN No. English
Display Data Channel (DDC)
To make installation easier, so long as your system supports the DDC protocol, the monitor is a communication protocol through which the monitor automatically informs the host system about its capabilities; Description 2 GND 4 ML_Lane 1+ 6 ML_Lane 18 ...
User Manual - Page 18
... monitor and the line-out port on the signal cable connector. 3. Please check user manual for audio output model. Then tighten the thumbscrews on the computer with the audio cable. 4. Note: Audio output is only for more instruction. Connect the power adapter and power cord to the monitor, then to the VGA and...
User Manual - Page 19
... Power
Input Switch Hot Key Main Menu Hot Key Power on/off the monitor
VESA Adaptive SYNC (HDMI/DP):
It can allow a VESA Adaptive SYNC supported graphics source to dynamically adjust display refresh rate based on typical content frame rates for power efficient, virtually stutter free and low-latency display...
User Manual - Page 20
Actual product specifications may vary. You can be used to adjust the settings of your preferred brightness setting . For advanced settings, please refer to adjust the picture quality, OSD position and general settings. Hot Key1
Modes, Brightness, Volume, Gamma,
Contrast, Blue Light, Over Drive
2. Hot Key3
Input Switch Hot Key
4. When you are done, press the...
User Manual - Page 22
...which 50% is in the best state and has been tested by increasing the brightness without changing lighter shades.
8.
Note: Set to dynamic contrast adjustment.
10. ACM: Turn ACM on the current screen to "On", will be based on or off.... by TÜV Rheinland and meet the requirements of the original source to 100 Note: Sets the degree of difference between light and dark shades.
6.
User Manual - Page 24
English
1. Note: If FreeSync set "On" you can be changed from blue light to orange light.
• Press any key except power key more ... up or down button to enter it .
3. Then press enter button to select OSD from the OSD. Language: Set the OSD menu language.
5. Note: OSD Locked:
• Set the OSD Lock to "On" by the OSD option and press "Enter" to execute the All Key lock function...
User Manual - Page 25
...the OSD. Note: Surround application must set HDMI black level.
10. DDC/CI: Allows the monitor settings to control functions.
4. Quick start ...mode: Select Off or On. Press up boot speed. Auto Source: The default is "Off".
6. The options are using. Toggle to the left or right to be sent via software.
9. Wide mode: You can support...
User Manual - Page 26
... future when you , save them and system will be able to enter it.
3. When you have decided what settings suit you turn on User mode . Press up or down button to select "Save Setting to open the OSD.
2. Press the MENU key to ..." from the OSD. Mode - User
Mode: sRGB Mode: Reading...
User Manual - Page 27
VGA/HDMI/DP Mode (Optional)
Problem No picture visible
LED status Blue
Off
Remedy
Using the OSD menu, adjust brightness and...Lock is properly connected to their default setting. Check the power switch. Amber
Check if the AC power cord is On, the LED status set Amber. Troubleshooting
Before sending your LCD monitor for servicing, please check the troubleshooting list below to see if you can...
Acer VW257 Reviews
We have not received any reviews for Acer yet.