Acer B277D Support and Manuals
Popular Acer B277D Manual Pages
User Manual - Page 2
... means, electronically, mechanically, by any person of this manual or supplementary documents and publications. Acer Incorporated. No part of this publication without the prior written permission of Acer Incorporated. The serial number and model number are registered trademarks of Acer Incorporated. Acer LCD Monitor User Guide
Model number Serial number Date of purchase Place of...
User Manual - Page 3
... for a few hours. • Visit Acer Support website to download IR webcam driver: https://www.acer.com/worldwide/support/
Cleaning your safety and comfort
Safety instructions
Read these guidelines when cleaning the monitor: •...monitors
The following are normal with the LCD monitor and do not indicate a problem. • Due to the nature of the previous screen may remain
after switching...
User Manual - Page 5
... used, the load should not exceed 80% of all servicing to replace the power cord set . Contact your electrician for service • the product does not operate normally after following ...servicing
Do not attempt to service this product.
• Use the product only with the supplied power supply cord set , make sure that the new power cord meets the following the operating instructions...
User Manual - Page 9
...,2019 Date Viale delle Industrie 1/A, 20020 Arese (MI), Italy Tel: +39-02-939-921 ,Fax: +39-02 9399-2913 www.acer.it
Product: Trade Name: Model Number: SKU Number:
LCD Monitor Acer B277 B277 XXXXXX; ("x" = 0~9, a ~ z, A ~ Z, or blank)
We, Acer Incorporated, hereby declare under our sole responsibility that the product described above...
User Manual - Page 11
...emissions by meeting strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. More information refers to offer products and services worldwide that help customers save money, ...Products that could exceed the ENERGY STAR specified limit.
Changing the factory default settings or enabling other features may increase power consumption that are registered U.S. What ...
User Manual - Page 19
If the user uses the power frequency of 50 Hz, it is necessary to set the frequency of the camera is turned on. English
Standard timing table
MODE 1 2 3 4 5 6 7 8 9 10 11...1920x1080 1920x1080
60Hz 66.66Hz 70Hz 56Hz 60Hz 60Hz 70Hz 75Hz 60Hz 60Hz 60Hz 60Hz 60Hz 60Hz 75Hz
The default factory setting of the camera to 50 Hz to reduce the flicker, so as to avoid the ripple interfering with ...
User Manual - Page 20
...monitor. 6. Plug the power cords of replaceable parts, please refer to the above installation instructions. *Users may go to the local service network to the VGA and /or HDMI1... support For local service centers and service contacts, please refer to port. 4. Please check user manual for more instruction. *POWER CORD specifications refer to port for audio output model. English
Installation
...
User Manual - Page 21
...
information for power efficient, virtually stutter free and low-latency display update. Dark gray indicates inoperable.
To move the cursor, simply toggle the...your monitor and current input or reset the custom color settings to the factory defaults.
Bright gray indicates operable. ...DP):
It can allow a VESA Adaptive SYNC supported graphics source to enter next function in four ...
User Manual - Page 22
...
Hot Key3
Input Switch Hot Key
4.
You can be used to adjust the settings of your preferred brightness setting .
Hot Key2
Modes, Brightness, Contrast, Volume,
Gamma, Blue Light, Over Drive... your LCD monitor. Actual product specifications may vary. When you are done, press the joystick to adjust the picture quality, OSD position and general settings.
The OSD (onscreen display) ...
User Manual - Page 24
... scales.
4. Toggle the joystick to the up or down to select Picture from 0 to 100 Note: Sets the degree of TÜV Rheinland's "Low Blue Light Content" standard.
9. Brightness: Adjust the brightness from 0 to 10. Note: Set to "On", will be used to 100 Note: Adjusts the balance between light and dark areas...
User Manual - Page 26
... sliding scales. 4.
Adaptive Sync:To choose Adaptive Sync on the screen. Refresh rate num: Display the panel's current refresh rate on /off . Note: If FreeSync set "On" you wish to adjust and press the joystick to open the OSD. 2. Performance
Mode - English
Audio
Picture Color Audio Performance OSD System
Mode - Over...
User Manual - Page 27
...Off
10
X
Move
Enter
1. Toggle to the left or right to open the OSD.
2. Language: Set the OSD menu language.
5. The transparency can be changed from the OSD.Then toggle to the right to ...blue light. OSD Lock: To choose OSD lock on/off the OSD menu.
6. Note: OSD Locked:
• Set the OSD Lock to "On" by the OSD option and press "Enter" to execute the All Key lock function....
User Manual - Page 28
..., Over Drive).
8. Power-off USB Charge: Turn On or Off. Wide mode: You can support auto search for Display Data Channel/Command Interface, which screen aspect you wish to adjust and press...: The default is "Off".
6. DDC/CI: Allows the monitor settings to be sent via software.
9. Note: Surround application must set through the software on to speed up or down to select System from...
User Manual - Page 29
... the element you wish to adjust and press the joystick to ..." Toggle the joystick to the up or down to select "Save Setting to enter it.
3. When you have decided what settings suit you turn on gaming mode . User
Picture
Mode: sRGB
Color
Mode: Reading
Audio
Mode: Darkroom
Performance
OSD
System
X
Save...
User Manual - Page 30
.... Check if the computer system is On, the LED status set Amber. Amber
Check if the AC power cord is purposed for servicing, please check the troubleshooting list below to see if you can self-diagnose the problem.
VGA IN/HDMI1.4/DP Mode (Optional)
Problem No picture visible
LED status Blue
Off
Remedy
Using the...
Acer B277D Reviews
Do you have an experience with the Acer B277D that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Acer yet.
Earn 750 points for your review!