Insignia NS-TDRG75W1 Support and Manuals
Get Help and Manuals for this Insignia item
View All Support Options Below
Free Insignia NS-TDRG75W1 manuals!
Problems with Insignia NS-TDRG75W1?
Ask a Question
Free Insignia NS-TDRG75W1 manuals!
Problems with Insignia NS-TDRG75W1?
Ask a Question
Popular Insignia NS-TDRG75W1 Manual Pages
Warranty Sheet - Page 1
.... • Modification of any part of the product in the United States and Canada call 1-877-467-4289. REPAIR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS YOUR EXCLUSIVE REMEDY FOR BREACH OF WARRANTY. This warranty is the warranty valid? This warranty does not cover: • Customer instruction/education • Installation • Set up to five (5) pixel...
User Guide - Page 1
USER GUIDE
10-Cycle Electric and Gas Dryers
NS-TDRE75W1/NS-TDRG75W1
Before using your new product, please read these instructions to prevent any damage.
User Guide - Page 2
... options and settings 36 Special laundry tips 38
Maintaining your dryer 39 Cleaning the exterior 39 Cleaning the drum 39 Cleaning the control panel 39 Cleaning and inspecting the exhaust system 39
Troubleshooting 40 Understanding the error codes 41
Specifications 42
ONE-YEAR LIMITED WARRANTY 42
Introduction
Congratulations on the purchase of your new Insignia dryer.
User Guide - Page 4
...'s instructions. • If you cannot reach your gas supplier, call the fire department. • Installation and service must be placed in your dryer until all occupants. • Immediately call your dryer.
Heated foam rubber materials can, under certain circumstances, produce fire by a qualified installer,
service agency, or the gas supplier. SAFETY & PRECAUTIONS
NS-TDRE75W1/NS-TDRG75W1...
User Guide - Page 6
... or solid things.
4 Install and use heat to dry articles containing foam rubber or similarly textured rubber-like materials.
25 Gas leaks may occur in your dryer and the exhaust duct should be cleaned periodically by qualified service personnel.
22 This appliance must be properly grounded. SAFETY & PRECAUTIONS
NS-TDRE75W1/NS-TDRG75W1
19 Clean the...
User Guide - Page 10
...three seconds to load your dryer on the styrofoam base.
Your can be ironed manually, select a lower dryness level. Temperature changes are only available on , the... see Dryer options and settings on the child lock function. For clothes to turn on page 36.
Press and hold for shipping damage.
Press once to turn off the function. INSTALLATION INSTRUCTIONS
# ITEM
8
My ...
User Guide - Page 19
... The National Fuel Gas Code requires that complies with the standard for connectors for instructions on your dryer with ...is recommended and must be design certified by a qualified service technician. The neutral conductor must be reduced to connect ...approved manual gas shut-off valve be installed within 6" of the system.
• Your dryer must be identified by -step instructions on...
User Guide - Page 20
... has been turned on a heat setting will purge the line. For GAS MODELS ONLY: The burner may not be...manual gas valve must be grounded.
INSTALLATION INSTRUCTIONS
COMMONWEALTH OF MASSACHUSETTS INSTALLATION INSTRUCTIONS
Your dryer must be plugged into an appropriate outlet that you purchase and install a UL-approved gas
detector. • Install and use it in accordance with all local codes...
User Guide - Page 21
...Service Personnel - Tools you will need
• 3/8" gas dryer gas line (Gas model only) • 3- Check with the circuit conductors and connected to whether the appliance is properly grounded. • Certain internal parts... and may present a risk of electric shock.
INSTALLATION INSTRUCTIONS
10-Cycle Electric and Gas Dryers
Electric models
WARNING: • For products sold in the ...
User Guide - Page 22
...national and local codes.
See Grounding requirements on page 17. Note: For Canadian models, the power cord comes pre-installed. • Your exhaust ducting (not included) is being installed, you will ...Move your dryer to dry small loads. models, you have a 3/8" gas dryer gas line (if you are installing your dryer is higher than the rear by -step instructions
Note: If a gas dryer is ...
User Guide - Page 39
...; Remove the cleaner residue and dry with a soft, damp cloth. Service Personal: Do not contact the following parts while the appliance is energized: Control Board and Temperature-Regulating Thermistor (located...objects. • Do not place any spills or over-spray immediately.
USER MAINTENANCE INSTRUCTIONS 10-Cycle Electric and Gas Dryers
Maintaining your dryer and make sure that there are ...
User Guide - Page 40
... a cycle other than Air Fluff and a temperature setting that is level.
• Seams, pockets, and...dryer's electrical
connection.
• Your dryer may need to repair your dryer yourself. Clothes are drying large, bulky items, like...INSTRUCTIONS
Troubleshooting
CAUTION: Do not try
repositioning the load to the high velocity of the load has reached the selected dryness level. PROBLEM...
User Guide - Page 41
...setting works best when the items in the dryer load are dried.
SOLUTIONS
Contact authorized service personnel for help.
Your dryer can break up into small pieces that turn into smaller loads for help . USER MAINTENANCE INSTRUCTIONS 10-Cycle Electric and Gas Dryers
PROBLEM...cotton towel) and they should be over dried. ERROR CODE POSSIBLE CAUSE
C9
The PCBs failed. DO NOT ...
User Guide - Page 43
...part of the product • Display panels containing up to three (3) pixel failures (dots that may not function normally.) • Failures or Damage caused by any person not authorized by Insignia to service... OR LOST PROFITS.
USER MAINTENANCE INSTRUCTIONS 10-Cycle Electric and Gas Dryers
• Customer instruction/education • Installation • Set up to five (5) pixel failures...
Marketing Sheet - Page 1
...range: Requires a 120/240 volt, 60Hz AC approved electrical service. INCLUDED • Dryer • User Guide
NS-TDRE75W1 / NS-TDRG75W1
Warranty Dimensions H × W × D
Weight
PRODUCT SPECIFICATIONS
1 year limited 45.8 × 27 × 31... - www.insigniaproducts.com
V1 20-0439 Allows easy program setting. • Safely dry all your garments and linens with 1 of 10
...
Insignia NS-TDRG75W1 Reviews
We have not received any reviews for Insignia yet.