Xw6200 Power Supply Replacement

Safety and Regulatory Information Desktops, Thin Clients, and Personal Workstations

Page 5
... Information ...1 Installation Conditions ...2 Battery Replacement Notice ...2 Headset and Earphone Volume Level Notice 3 German Ergonomics Notice ...3 Laser Safety ...3 CDRH Regulations ...3 Compliance with International Regulations 4 Laser Product Label ...4 Laser Information ...4 Power Supply and Power Cord Set Requirements 4 Power Supply Class I Grounding Requirements 4 Denmark ...4 Norway ...4 Sweden ...5 Power Supply Requirements 5 For Use in Norway 5 Power Cord Set Requirements 5 Japanese Power Cord Requirements 5 Pinch Hazard...

Safety and Regulatory Information Desktops, Thin Clients, and Personal Workstations

Page 10
If you have an LS-120 drive or an LS-260 drive, this product or a Hewlett-Packard authorized replacement. Only use the power cord supplied with appropriate safety standards including IEC 825. Compliance with International Regulations All systems equipped with CD-ROM drives comply ...than 0.2 mW or 10,869 W·m-2 sr-1 ● Polarization: Circular 0.25 ● Numerical Aperture: 0.45 +/- 0.04 Power Supply and Power Cord Set Requirements Power Supply Class I Grounding Requirements For protection from fault currents, the equipment shall be connected to the Class 1 Laser Product label on a...

Safety and Regulatory Information Desktops, Thin Clients, and Personal Workstations

Page 11
... be found at http://www.hp.com/cgi-bin/ hpsupport/index.pl. Japanese Power Cord Requirements For use in user exposure to the plug, electrical outlet, and the point where the cord exits from any line voltage between 1.8 m (6 feet) and 3.6 m (12 feet). Power supplies on any manner, replace it . Mismatched power cords may result in Japan...

HP xw Workstation series Setup and Troubleshooting Guide

Page 50
... Reference Guide for your workstation model for assistance. Replace third-party memory with HP memory. 4. If the system enters the POST, power off and replace one device at a time to ensure all attached devices (such as hard, diskette, or optical drives, and expansion cards.) Power on the graphics card. Plug in the power supply. Six beeps. Seven beeps...

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Page 6
...product hardware, troubleshooting, product specs, as well as instructions for the removal and replacement of the Documentation Library CD, follow these steps: 1. Using the Documentation Library... the documents on the workstation. Canadian, and various international regulations. Click Start > Run. 2. vi www.hp.com Getting Started Guide Windows-based Workstations Insert the CD into ...installation, and power supply. ■ Safety and Comfort Guide (PDF on library CD) Provides safety and ergonomic information to assist you in setting up a safe and comfortable workstation environment. ■...

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Page 42
...turned on, then replace the power supply. 6. If the 5.5 V_aux light on the system board is turned on, then replace the power button harness. 5. OR Press and hold the power button for less than 4 seconds. Check that the voltage selector, located on the rear of the workstation are properly connected...into a working AC outlet. 2. Troubleshooting Problem System does not power on and the LEDs on the front of the power supply, is turned on. If the hard drive LED turns green, then: 1. Replace the system board. 4-8 www.hp.com Getting Started Guide Check to the system board. 4. ...

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Page 48
... board. 3. Proper voltage setting depends on the system. Troubleshooting Activity Red Power LED blinks once every two seconds. Check if a device is causing the failure. Recommended Action 1. Replace the power supply. 5. Beeps None Possible Cause Power failure (power supply is overloaded). Replace the system board. 4-14 www.hp.com Getting Started Guide Continue adding devices one device at a time...

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Page 51
...light on the system board turns on , then replace the power supply. 6. Check to power on. If the 5.5 V_aux light on the system board is plugged into a working AC outlet. 2. Replace the system board. If the hard drive LED ...turns green, then: 1. Getting Started Guide www.hp.com Recommended Action Press and hold the power button for less than 4 seconds. If it is turned on , then replace...

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Page 54
... two-second pause. Open the hood and ensure the 4-wire power supply cable is causing the failure. Replace the device that , only the blinks will continue to ensure all devices are functioning properly. 3. Replace the power supply. 4. Blinks and beeps will be heard through the on-board...if a device is overloaded) 1. If the system enters the POST, then power off and replace one at a time and repeat this procedure, until failure occurs. Replace the system board. 4-20 www.hp.com Getting Started Guide Troubleshooting Activity Possible Beeps Cause Recommended Action NOTE: For ...

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Page 57
... www.hp.com 4-23 Troubleshooting Activity System does not power on and LEDs are properly connected to the system board. 4. Beeps None Possible Cause System unable to see if the 5.5 V_aux light on the system board is turned on. If the 5.5 V_aux light on the system board is turned on , then replace the power supply...

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 4
...Software Updating and Management 43 ROM Flash 44 Asset Tracking and Security 49 Fault Notification and Recovery 60 4 Removal and Replacement Procedures Service Considerations 64 Read Cautions, Warnings and Safety Precautions 64 Electrostatic Discharge Information 64 Tools and Software Requirements 66 ...Sensor) (Optional 76 Hood Lock (Smart Cover Lock) (Optional 77 Front Panel I/O Device Assembly 78 Power Button Assembly and System Speaker 79 System Fan Assembly 80 Power Supply 81 Memory 82 Peripheral Component Interconnect (PCI) Slots 85 IEEE-1394 (Optional 92 Front Fan Removal ...

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 9
... on headphones, place them around your system is a class I laser product. Always replace the side cover before connecting the headphones or speakers. Remove the Power Protection Device cables before removing the system's side cover. This equipment can hear comfortably and...power cord from unexpected noise or static. When you have installed a sound card in your safety, never remove the system side cover without distortion, leave the volume in compliance with your Ears. If your neck and turn the volume down . To avoid electrical shock, do not open the power supplies...

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 61
... The Prefailure Warranty for ECC memory modules allows you must replace the standard DIMMs with HP ECC DIMMs. Surge-Tolerant Power Supply An integrated surge-tolerant power supply provides greater reliability when the workstation is hit with HP Client Manager Software, this feature, you to throttle. DESKTOP... PE or Neutral to PE) and 1000 V (Line to withstand a power surge of error checking and correcting (ECC) memory errors, the workstation displays a Local Alert message. This power supply is exceeded. The service provider can use this features notifies the network administrator...

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 71
...workstation. Pre-Disassembly (page 68) Locks (page 72)1 Access Panel (page 74) Hood Sensor (page 82) Top Cover (page 76)2 Hood Lock (page 77) Front Bezel (page 75) Front Panel I/O Device Assembly (page 78) Power...(page 96) Diskette Drive (page 98) Bezel Blanks (page 75) System Fan Assembly (page 80) Power Supply (page 81) Memory (page 82) Front Fan Removal (Optional) (page 93) Battery (page 94)...remove it . 2. REMOVAL AND REPLACEMENT OF COMPONENTS 71 Disassembly Order Use the following table to determine the sequence in which to your unit. 6 Restore power to remove the major components....

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 80
...(page 68), remove the access panel (page 74), and lay the workstation on its side with the system board facing up. 2 Disconnect the fan plugs 1 from the system board. 3 Press in on some systems. Refer to the power supply. This duct is only required on the ribbed portion of the fan ... it out of the chassis. This illustration shows the system fan with the duct from the system fan assembly): 1 Install the duct by HP. See the previous image for more information. 2 3 1 To replace a system fan assembly, reverse the previous steps. CAUTION HP only ships DIMMs that is not required.

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 81
... AND REPLACEMENT OF COMPONENTS 81 Chapter 4 2 Reinstall the system fan assembly (page 80). The PCI Express power cable has a black connector and the power cable has a white connector. To see a picture of the PCI Express cable and where it from the power supply. Power Supply 1 Disconnect power from the... system (page 68), remove the access panel (page 74), remove the system fan assembly (page 80), and lay the workstation on page 91. 4 Remove the four screws 1 from the back...

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 82
... memory slots for DIMMS „ 256-MB, 512-MB, 1-GB and 2-GB pairs „ 8 GB maximum configuration (4 GB maximum on Windows and 16 GB maximum on Linux) „ Supports single-channel or dual-channel ...power cord while installing memory, your memory modules might be damaged and the system will not recognize the memory changes. 2 Gently push outwards on the socket levers. 82 REMOVAL AND REPLACEMENT...Module 1 Disconnect power from the system (page 68), remove the access panel (page 74), lay the workstation on the back of the power supply turns off the workstation and unplug the power cord from ...

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 90
... Express card, remove the power supply cable (not illustrated), if required, and move the "hockey stick" lever to release the card and lift it out of the chassis. PCI or PCI Express Removal 1 Disconnect power from the system (page 68), remove the access panel (page 74), lay the workstation on its side with the... pressing down on them and then out. 3 Lift the PCI card out of the chassis. Figure 4-1 PCI Removal Figure 4-1 PCI Express Removal 90 REMOVAL AND REPLACEMENT PROCEDURES Store the card in an anti-static bag. 4 Close the PCI levers.

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 91
If installing a PCI Express card, plug in the power supply cable, if required. 1 2 4 2 1 4 3 3 5 Figure 4-2 PCI Installation Figure 4-2 PCI Express Installation REMOVAL AND REPLACEMENT OF COMPONENTS 91 Verify that the keyed components of the card align with the system board facing up, and remove the ... by first pressing down on its side with the socket. Chapter 4 PCI or PCI Express Installation 1 Disconnect power from the system (page 68), remove the access panel (page 74), lay the workstation on them and then out. 3 Remove the PCI slot cover 2. 4 Lower the PCI 3 or PCI ...

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Page 121
...in -line front panel I/O device assembly connector. 3 Check that the power supply cables are properly connected to your workstation. If not spinning, ensure fan cable is plugged in and seated but not spinning, then replace processor fan. 4 Reseat CPU heatsink and verify fan assembly properly attached...fan spins. DIAGNOSTIC ERROR CODES 121 b Remove all internal power supply cables from the system board. Replace the system board. Blinks RED 2 times, once per Thermal Shutdown: second, then 2 second pause, 2 beeps 1 Ensure the workstation air vents are not blocked and cooling fan is good....

Xw6200 Power Supply Replacement - HP Workstation 2 GB RAM

Related Manual Pages

Safety and Regulatory Information Desktops, Thin Clients, and Personal Workstations

Safety and Regulatory Information Desktops, Thin Clients, and Personal Workstations

Safety and Regulatory Information Desktops, Thin Clients, and Personal Workstations

HP xw Workstation series Setup and Troubleshooting Guide

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

HP Workstation xw6200 Service and Technical Reference Guide (3rd Edition)

Similar Questions

Related Terms

Ask a New Question

Manuals / Documents

Related Items

Points & Prizes

HP Manuals

HP Reviews

Contact Information

Scoreboard Ratings

HP Recalls