Zenith SL-6030-WH5 Support Question
Zenith SL-6030-WH5 Support Question
Find answers below for this question about Zenith SL-6030-WH5 - Heath - Wireless Command Motion Sensor.Need a Zenith SL-6030-WH5 manual? We have 1 online manual for this item!
Current Answers
Related Zenith SL-6030-WH5 Manual Pages
User Guide - Page 1
...operating instructions for switch locations.
( - Heath®/Zenith wireless lighting controls are UL/cUL and/or FCC...appliances, power supplies, low voltage
lighting, or any other , set the code. Features
• Products are designed to the following products: • Wireless Transmitters (Indoor / Outdoor)
- 180° Motion Sensor - 240° Motion Sensor • Receivers - See page...
User Guide - Page 2
Code Switch Locations
Code Switches
DAY NIGHT NIGHT ONLY
1234 CODES
DETECT
180° Motion Sensor
Code Switches
CODES
DETECT
1 2 3 4
DAY NIGHT NIGHT ONLY
240° Motion Sensor
Code
Switches
ON
Wall Switch Receiver
Code Switches
LAMP MODE switches
RAINTIGHT
ã THIS END UP
OUTDOOR USE ONLY.
ON 1 2 3 4
Close-Up of Typical Code ...
User Guide - Page 3
....
Mounting Bracket Socket
Clamp Screw
Swivel Ball Mount
Mounting Bracket
Mounting Screw Nut
Sensor
Installing Motion Sensor (180° Motion Sensor Shown)
Detect Control
DAY NIGHT NIGHT ONLY
1234 CODES
DETECT
CODES
DETECT
1 2 3 4
DAY NIGHT NIGHT ONLY
180° Motion Sensor (Rear View)
240° Motion Sensor (Rear View)
Battery Compartment
598-1306-02
Select Night or 24 Hour...
User Guide - Page 4
... air conditioners. Set the DETECT control switch to the corresponding setting. DualBrite® Dimmer Control (240° Motion Sensor Only)
Light comes on after dusk (Off, 3 or 6 hours, until it opens. 1.
Walk in
front of the motion sensor. To increase sensitivity, turn the RANGE control toward MAX. To decrease sensitivity, turn the RANGE control toward MIN...
User Guide - Page 5
...176; Motion Sensor Coverage Area
Sensor
Sensor
Least Sensitive
Most Sensitive
The detector is most sensitive to motion across its field of view. Motion Sensor Sensitivity
8 ft. (2.4 m)
240°
70 ft. (21 m) Maximum Range
Maximum Coverage Angle
240° Motion Sensor Coverage Area
Aim Sensor Down for Short Coverage
Aim Sensor Higher for Long Coverage
Adjusting Motion Sensor Coverage...
User Guide - Page 6
...When ganging these units, they are secure and that no bare wires are being used to control the light, the 3-Way Wall Switch transmitter will also have the following features and ratings: • Rated ...to secure the wires (see illustration). 8. Mount wall plate on the power to the light switch circuit.
ing upon switch purchased. Connect the second black power wire from receiver to...
User Guide - Page 7
... last setting used. Bulb Replacement Move the power disconnect switch to increase brightness. The light should turn off. 4. Push and release top of a power failure. Set desired ...Note: The DIM setting defaults to decrease brightness. ENGLISH
Operation 1.
The light should turn on
full bright.
The light should turn on at 50% brightness (or last setting). 5. Push and...
User Guide - Page 8
Light instantly comes on effects) available when motion is no longer detected and
after selected ON-TIME.
• FLASH
- Thread the small end of the plastic hanger through the large gasket holes. 5. Secure ...
User Guide - Page 9
... the following information available: Model Number, Date of Purchase, and Place of Industry Canada. Device comes on transmitter and
receiver units. 4. Switch on .
2. Signals from transmitter will reset receiver to... second initialization period
(remote motion sensor). 5. Same as 5, 6, and 7 above .
1. ENGLISH
SYMPTOM Device does not come on transmitter and receiver units do not match.
8.
User Guide - Page 10
... of use, unauthorized service, or return shipping charges. Not Covered - Please keep your dated sales receipt, it is not extended to misuse, abuse or negligence, light bulbs, batteries, and other rights which gives you .
Similar Questions
Sl 6030 Tx Motion Sensor-floodlight
my light does not turn off. The transmitter seems to be functioning..If receiver us faulty, do i nee...
my light does not turn off. The transmitter seems to be functioning..If receiver us faulty, do i nee...
(Posted by Jfalk1 5 years ago)
Replacement For Sl-6030-tx
What is the replacement for the zenith SL-6030-TX motion sensor
What is the replacement for the zenith SL-6030-TX motion sensor
(Posted by F58lrpl75ranger 7 years ago)
Has The Sl-6053 Been Discontinued Or Is It Just Out Of Stock?
(Posted by jclout4153 9 years ago)
How To Wire Health Motion Sensor Sl-5410a
(Posted by ranyog 9 years ago)
Interchangable Sensors
My old unit sensor seems to be in a state of malfunction. If I purchase a new SL 6030 TX, will the n...
My old unit sensor seems to be in a state of malfunction. If I purchase a new SL 6030 TX, will the n...
(Posted by sanks2u 11 years ago)