Alpine VPX-B104R Support Question
Alpine VPX-B104R Support Question
Find answers below for this question about Alpine VPX-B104R.Need a Alpine VPX-B104R manual? We have 1 online manual for this item!
Question posted by timsgelcoat on June 20th, 2015
Cannot Get Vpass Ecu Into Setup Mode.
The person who posted this question about this Alpine product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TechSupport101 on June 20th, 2015 9:40 PM
Related Alpine VPX-B104R Manual Pages
Owners Manual - Page 1
.... 1-1-8 Nishi Gotanda, Shinagawa-ku,
Tokyo 141-0031, Japan Phone 03-5496-8231
ALPINE ELECTRONICS OF AMERICA, INC. 19145 Gramercy Place, Torrance, California 90501, U.S.A. VISUAL PARKING ASSIST SENSOR SYSTEM (VPASS)
VPX-B104R
• OWNER'S MANUAL
Please read before using this equipment.
• MODE D'EMPLOI
Veuillez lire avant d,utiliser cet appareil.
• MANUAL DE OPERACION
Lealo antes...
Owners Manual - Page 2
... 7 2. Pickup Truck 7
Accessory Parts 8
Component 8 Installation Tool 8
Wire Connection 9 Painting Sensor Cover and
Sensor Unit 10
Sensor Assembly Painting Method....... 10
Sensor Assembly 11 Installation of Sensor 13 Installation of ECU 15 On-Screen Display Set Up 15
Fish-eye Correction Menu 16 Parking Guide Line Adjustment 16 Diagnostic 17
Setup Mode Structure Tree...
Owners Manual - Page 4
... nearest Alpine Service Center for repairing.
To ensure the sensors function accurately, never install accessories in close proximity to the harness. Also, do so may result in an accident.... sensors to help sharpen the driver's detection of the Visual Parking Assist Sensor System (VPASS system) is used when parking in battery failure, performance failure, connector damage, or wire...
Owners Manual - Page 7
...parking assist sensor system alerts you read this Visual Parking Assist Sensor System (VPASS system).
Sound
Onscreen Message
Onscreen Color
Slow beep
No message GREEN
Distance to 6...ft.) Please read and understand the operation and limitations of the VPASS system. Important Information
Before using the VPASS system.
The sensors may be detected.
The backup sensors make ...
Owners Manual - Page 8
... to right.
2. Pickup Truck
• Buzzer can be installed anywhere within 10ft. (3m).
• ECU MUST be installed inside vehicle. • Sensor cable must be installed from left to right. • ...use of the system.
• Buzzer can be installed anywhere within 10ft. (3m).
• ECU MUST be installed inside vehicle. • Sensor cable must be installed from left to alert the ...
Owners Manual - Page 9
... Rubber Ring
~ ~x4
6° Sensor Cap
VISO.t.li'MUIG.U.T..,_. Sensor Unit Box
x1
@ Setup Switch
Without "Grommet" Part
x1
@Buzzer
x1
@Main Harness
- Accessory Parts
Check Accessory Parts.
SUGGESTION
Please confirm the following sensor components are not dirty or damaged. VPX-B104R
x1
x1
® Owner's and
Installation Manual
x2
® Installation Paper
®Registration...
Owners Manual - Page 10
...10m
I j '
Note:
* Connect only one monitor to connect between the VPASS system and video monitor or between VPASS and Alpine camera
9-EN Wire Connection
(Red)
I (Orange/White) I Reverse... RCA video connection
f - cdl
•i
I
I
i r~--H--c-e---e-1-o-4
I
I
JI
- Setup Switch
Sensor Cable
Parking Sensors
For Sedan
For Pickup Truck
Alpine Monitor
HCE-C117D
M5 F5
M6...
Owners Manual - Page 11
... time of the sensors with a soft cloth if they contact any fuel, oil, coolant, battery acid, sealants, adhesives, car care products, or any accessories are missing
and all accessories are aligning/ assembling properly.
3 Remove the spring plate from the
sensor cap box to avoid painting.
4 Remove the rubber ring from the
sensor...
Owners Manual - Page 16
... [+] buttons for
5 seconds continuously to enter the On-Screen Display set-up mode.
4 Each item in Setup mode. 1. Following items can be adjusted in the [Setup mode] can be
selected by pressing the [+], [-] and [ENT] buttons. Calibration sheet
Line up to ground(-) of ECU
On-Screen Display Set Up
1 Align the calibration paper behind the
car...
Owners Manual - Page 17
...'~
Press the [ENT] to enter.
1 4 Use the [+] or [-] button to adjust the
line shift to match the calibration
paper.
15 Press the [ENT] to the [Setup Mode] menu by pressing the [ENT]. Fish-eye Correction
Parking Guide Line Adjustment
To go to Fish-eye correction menu, refer to step 1 through 4 of On...
Owners Manual - Page 18
... Line Length Line Shift
Firmware Version P1002-08-02
Line Slope
60
Line Ratio
05
Sensor
\
8 Select the "RETURN'~ Press the [ENT] to
enter the [Setup Mode].
9 Select the "Exit'~ Press the [ENT] to enter the sub-menu.
J
5 Select the "Function Parameter'~ Press
the [ENT] to enter.
6 Use the[+][-] button to review...
Owners Manual - Page 20
... guide if a problem arises.
b) Check whether the sensor wires are plugged
into the ECU properly.
b) The audible signal does not sound when the shift lever is moved to ... connection to test the functions as described in the reverse position, and the sensors are plugged
into the ECU properly. b) Check whether the sensor wires are not frozen or clogged with the sensor, the system will...
Similar Questions
Cannot Access Setup To Change Out Of Demo Mode
I have an Alpine CDE-151 CD player that I need to change out demo mode in setup but when I push that...
I have an Alpine CDE-151 CD player that I need to change out demo mode in setup but when I push that...
(Posted by dshockey 4 years ago)
Alpine Ive-w530bt, Select Setup
On my carradio Alpine IVE-W530 is under "Setup Select" only "Audio Select" and "Source Select". Why ...
On my carradio Alpine IVE-W530 is under "Setup Select" only "Audio Select" and "Source Select". Why ...
(Posted by elisar22 7 years ago)
Setup Mode
i want to adjust sound volume of navigation but the setup botten on the above bar does work. The but...
i want to adjust sound volume of navigation but the setup botten on the above bar does work. The but...
(Posted by kyosukematsu 10 years ago)