ZyXEL EM-422 Support and Manuals
Get Help and Manuals for this ZyXEL item
View All Support Options Below
Free ZyXEL EM-422 manuals!
Problems with ZyXEL EM-422?
Ask a Question
Free ZyXEL EM-422 manuals!
Problems with ZyXEL EM-422?
Ask a Question
Popular ZyXEL EM-422 Manual Pages
User Guide - Page 2
... installing the EM-422 in the EM-422. Transceiver Installation
5 How to install an XFP transceiver in a switch, the switch can have 10 Gigabit connections to solve problems you set up and use with high-speed switches, such as the XGS4528F. Transceiver Removal
6 How to install the EM-422 in a switch's
expansion slot.
Specifications
7
Information about your EM-422.
This guide...
User Guide - Page 3
... the new module. You can put the cover plate back on the switch. EM-422 User's Guide
1 Hardware Installation
Follow these steps to avoid touching the onboard circuit components.
3 " Modules are...discharge any bodily static electricity.
3 Remove the EM-422 from its edge to install the EM-422 in a switch. Hold the EM-422 by its protective anti-static packaging.
Do not discard the cover plate....
User Guide - Page 4
... automatically detects the installed EM-422. Press it firmly until the EM-422 snaps into the expansion slots.
5 Secure it to verify that it is functioning properly.
4 Connect any necessary network cables to the EM-422 and check the LEDs to the switch with the retaining screws.
6 Turn on the switch.
EM-422 User's Guide 4 Insert the EM-422
into an available...
User Guide - Page 5
Check the LEDs to install an XFP transceiver. 1 Insert the transceiver into place. 3 The EM-422 automatically detects the installed
transceiver. EM-422 User's Guide
2 Transceiver Installation
Use the following steps to verify that it clicks into the slot with the exposed section of PCB board facing down.
2 Press the transceiver firmly until it is functioning properly.
3 LEDs (Lights)
5
User Guide - Page 6
EM-422 User's Guide
The following steps to remove an XFP transceiver. 1 Open the transceiver's latch (latch styles vary).
2 Pull the transceiver out of the slot.
6 Blinking The port ... Status Description
LNK/ Blue On ACT
The port is connected to an Ethernet
device.
4 Transceiver Removal
Use the following table describes the LEDs on the EM-422 panel.
User Guide - Page 7
... on after I install the EM422 and connect it to a network device.
• Make sure the EM-422 is properly installed in a switch. • Make sure that you are accurate at the time of the lights turn on . • If the problem continues, contact your vendor.
6 Specifications
Specifications are using the XFP transceivers to con-
EM-422 User's Guide
5 Troubleshooting
VNone of writing...
User Guide - Page 8
EM-422 User's Guide
Feature Switching
Approvals
Specification
• Maximum frame size: 1522 bytes including tag/ CRC • Store and forward
FCC Part 15 of electric shock from lightning. • Connect ONLY suitable accessories to the device. • ONLY qualified service personnel should service... and instructions.
&#...install, use, or service this device before servicing or disassem-
User Guide - Page 9
... interference in accordance with the instruction manual, may cause harmful interference to comply with Part 15 of this product may be...EM-422 User's Guide
• This product is a class A product. Operation of FCC rules. FCC Warning
This device has been tested and found to radio communications. This device generates, uses, and can radiate radio frequency energy and, if not installed...
User Guide - Page 10
..., ZyXEL will be solely at its discretion, repair or replace the defective products or components without charge for either parts or...ZyXEL Limited Warranty
ZyXEL warrants to the original end user (purchaser) that product's page. 3 Select the certification you wish to view from this product is free from the date of ZyXEL. PRODUIT CONFORME SELON 21 CFR 1040.10 ET 1040.11. EM-422 User's Guide...
User Guide - Page 11
... of this publication may also have other support materials. It is the exclusive remedy of ZyXEL Communications Corporation.
11 Thank you . Copyright
Copyright © 2007 by ZyXEL to receive e-mail notices of ZyXEL) and the customer will be shipped by ZyXEL Communications Corporation.
EM-422 User's Guide
Note
Repair or replacement, as a whole, transcribed, stored in a retrieval...
User Guide - Page 12
... ready when you contact customer support.
• Product model and serial number. • Warranty Information. • Date that you received your device. • Brief description of the problem and the steps you dial to change without notice. Corporate Headquarters (Worldwide)
• Support E-mail: support@zyxel.com.tw • Sales E-mail: sales@zyxel.com.tw • Telephone: +886...
User Guide - Page 16
...grak-Noi, Muang, Nonthaburi 11000, Thailand. EM-422 User's Guide
• Regular Mail: ZyXEL Communications, Arte, 21 5ª planta, 28033 Madrid, Spain
Sweden
• Support E-mail: support@zyxel.se • Sales E-mail: sales@zyxel.se • Telephone: +46-31-744-7700 • Fax: +46-31-744-7701 • Web: www.zyxel.se • Regular Mail: ZyXEL Communications A/S, Sjöporten 4, 41764...
ZyXEL EM-422 Reviews
We have not received any reviews for ZyXEL yet.