Whirlpool UXT4130ADS Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool UXT4130ADS manuals!
Problems with Whirlpool UXT4130ADS?
Ask a Question
Free Whirlpool UXT4130ADS manuals!
Problems with Whirlpool UXT4130ADS?
Ask a Question
Popular Whirlpool UXT4130ADS Manual Pages
Warranty Information - Page 1
..., operator or installation instructions.
2. Pick-up or delivery. Travel or transportation expenses for Factory Specified Replacement Parts and repair labor to province. trim, decorative panels, flooring, cabinetry, islands, countertops, drywall, etc.) that comes with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will be addressed without service. The cost...
Installation Guide - Page 1
... followed. 30" (76.2 CM) AND 36" (91.4 CM) RANGE HOOD
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www.whirlpool.com
In Canada, call 1-800-807-6777 or visit our website at www.whirlpool.ca
HOTTE D'ASPIRATION DE 30" (76,2 CM) ET 36...
Installation Guide - Page 2
...settings.
■ Always turn off at high settings...service panel.
■ Installation work and electrical wiring must always be sure to duct air outside - READ AND SAVE THESE INSTRUCTIONS
TABLE OF CONTENTS
RANGE HOOD SAFETY 1 INSTALLATION REQUIREMENTS 3 INSTALLATION INSTRUCTIONS 6 RANGE HOOD USE 10 RANGE HOOD CARE 10 WIRING DIAGRAM 11 ASSISTANCE OR SERVICE...the local code authorities.
&#...
Installation Guide - Page 3
...located inside the range hood on ordering, see the "Assistance or Service" section. Models that are shown must be used. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before making any tools listed here.
Given dimensions provide minimum clearance. Consult the cooktop/range manufacturer installation instructions before starting installation. Read and...
Installation Guide - Page 4
....4 cm) models.
B. Makeup Air Local building codes may require ...installations.
■ Do not terminate the vent system in your HVAC professional for this model.
The specified CFM varies from gas cooking surface. 30" (76.2 cm) suggested maximum above the cooking surface. Plastic or metal foil vent is optional for specific...installation requirement. The break should be as close as part...
Installation Guide - Page 5
... of the range hood.
■ Wire sizes must have a damper. The model/serial plate is located behind the filter on the model/serial rating plate. If roof or wall cap has a damper, do not use damper supplied with National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22...
Installation Guide - Page 6
... INSTRUCTIONS
NOTES: ■ Depending on a covered surface.
■ Using a #2 Phillips screwdriver, remove the rectangular damper attached with the exterior edges of the upper cabinet. Replace all parts and panels before the range hood is installed. IMPORTANT: The brackets should touch the upper cabinet. With a pencil, mark the upper holes on the brackets.
■ Set the range hood...
Installation Guide - Page 7
... each of the dots marked previously on the rear of the range hood. Using the outside edges of the range hood. Mark the hole at the electrical strain relief. For a non-vented (recirculating) installation: Go to Step 7. Remove the range hood and set it aside.
For a rear vented installation: Mark the 4 vent hole locations (D) on either the wall or...
Installation Guide - Page 8
...
x2 E
D C B A
10. There must be enough wiring from the fused disconnect (or circuit breaker) box to the range hood.
■ Seal joints with the rectangular damper, remove the rectangular damper flap.
8
Mount Range Hood
■ Install Strain Relief
Install a UL Listed/CSA Approved ¹⁄₂" (13 mm) strain relief (A). ■ Mounting Tabs
Start a #8-18 x 4.2 x 16...
Installation Guide - Page 9
... the screw securely. For vented installations: Install a metal filter. - NOTE: To get the most efficient use with this model range hood.
13.
Failure to the green ground screw in the "Range Hood Care" section.
- If the range hood does not operate, check to green ground screw in the "Range Hood Care" section.
■ If removed previously, replace the filter.
12. Disconnect the...
Installation Guide - Page 10
..., Part Number 31462A (not included): See the "Assistance or Service" section to turn the light Off. To avoid damage to release the filter. Turn the grease filter retainer to the stainless steel, do not use . A. To Replace the Filter:
1. Push the filter into the channel at the rear of old charcoal filter. RANGE HOOD CARE...
Installation Guide - Page 11
... the slots.
5. If the new light does not operate, make sure the light bulb is inserted correctly before calling service. WIRING DIAGRAM
Light Switch On - Reconnect power. Replacing the Incandescent Light Bulb
Turn off the range hood and allow the light bulb to cool. 1. Squeeze the plastic lens cover and remove it from the...
Installation Guide - Page 12
... in this manual
If you need replacement parts If you need to order replacement parts, we recommend that you can write to Whirlpool Corporation with : ■ Scheduling of appliances.
■ Use and maintenance procedures.
■ Accessory and repair parts sales.
■ Referrals to local dealers, repair parts distributors, and service companies. In Canada
Call the Whirlpool Canada LP...
Installation Guide - Page 13
..., acts of God or use inconsistent with electrical or plumbing codes or correction of the appliance.
8. Food or medicine loss due to review the Troubleshooting or Problem Solver section of inaccessible appliances or built-in accordance with published user, operator or installation instructions.
2. trim, decorative panels, flooring, cabinetry, islands, countertops, drywall, etc.) that...
Whirlpool UXT4130ADS Reviews
We have not received any reviews for Whirlpool yet.