Whirlpool WVU57UC0F Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WVU57UC0F manuals!
Problems with Whirlpool WVU57UC0F?
Ask a Question
Free Whirlpool WVU57UC0F manuals!
Problems with Whirlpool WVU57UC0F?
Ask a Question
Popular Whirlpool WVU57UC0F Manual Pages
Owners Manual - Page 1
30" (76.2 CM) AND 36" (91.4 CM) RANGE HOOD
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www.whirlpool.com
In Canada, call 1-800-807-6777 or visit our website at www.whirlpool....
Owners Manual - Page 3
... others are not followed.
3
These words mean:
DANGER
You can be killed or seriously injured if you don't immediately follow instructions.
We have provided many important safety messages in this manual and on your appliance. All safety messages will tell you what the potential hazard is the safety alert symbol.
Always read...
Owners Manual - Page 4
... such persons are supervised or are trained to the outdoors.
For General Ventilating Use Only. READ AND SAVE THESE INSTRUCTIONS
4 Do Not Use
To Exhaust Hazardous Or Explosive Materials And Vapors. IMPORTANT SAFETY INSTRUCTIONS
Ducted fans must always be vented to operate the appliance by a person who accepts responsibility for their safety.
Owners Manual - Page 5
... to comply with local codes.
UL Listed wire connectors ■ Vent clamps/duct tape as non-vented (recirculating) require charcoal filters. Given dimensions provide minimum clearance. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before making any tools listed here. For information on the model/serial/rating plate. The model/serial/rating plate...
Owners Manual - Page 6
...set to exhaust the air to cooking surface C. 30" (76.2 cm) minimum cabinet opening width for 30" (76.2 cm)
models...Installations
An additional back draft damper should be installed to minimize backward cold air flow and a thermal break should be as close as part of the thermal break. Makeup Air
Local building codes... of 50 ft (15.2 m) for specific requirements in an attic or other enclosed area...
Owners Manual - Page 7
...used , it is recommended that a qualified electrician determine that the electrical installation is adequate. Ensure that the ground path is adequate and in the ... local codes and ordinances.
If codes permit and a separate ground wire is used in conformance with National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and...
Owners Manual - Page 8
.... Lift the range hood and set it upside down onto covered surface. Aluminum/copper connection must conform with the rating of the National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22. 1-94, Canadian Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all parts and panels before servicing. Select a flat surface for...
Owners Manual - Page 10
...remove the tape from the Vented option with a T10 TORX® screwdriver and set aside.
Vent knockouts D. Horizontal air transition
Only for ordering.
1.
Use caulking ...the "Accessories" section)
B. 3.5 x 9.5 mm screws C. 7" (17.8 cm) round vent mounting plate D. Install Vent System
1. Round vent knockout B. Remove each filter by pulling the spring-release handle and then pulling down the...
Owners Manual - Page 11
... cover. A. A
6. Bend spring clips back into top side of metal filter. Place charcoal filter into place to secure the charcoal filter to the metal filter. Replace the venting method screw on No Vented option 4. Non-vented (recirculating) vent cover
11
A
8. A.
A
9. 3. Slide the venting lever down as shown in the following image...
Owners Manual - Page 12
...installation is recommended that are started into the mounting tab (A) on the brackets.
5.
Remove the power supply knockout from the fused disconnect (or circuit breaker) box to the National Electric Code or CSA standards and local codes... mounting tab upward approximately 45°. A
4. Install Range Hood
1. NOTE: For installation to the cabinet side walls.
8. Tighten the ...
Owners Manual - Page 13
... ground the blower. Remove
terminal box cover and set aside. Power Supply Cable Installation
1. Remove the screw from power supply to make the connection in the "Make Electrical Connections" section. Screw
F
A. Use UL Listed wire connectors and connect white wires (A) together.
3. Replace all parts and panels before servicing. Terminal box cover B. Use UL Listed wire...
Owners Manual - Page 14
...replace the grease filter. Off button Press OFF to turn off after the cooking is designed to disable the function.
■ After 40 hours of the range hood fan and light.
Power Cord Kit Installations
For optional power cord kit installations, follow the instructions supplied with this model... should be set to see whether a circuit breaker has tripped or a household fuse has blown.
LED...
Owners Manual - Page 15
...into upper track.
4.
Replacing an LED Lamp
■ For stainless steel models, Stainless Steel Cleaner and polish Part Number 31462A (not included): See the "Assistance or Service" section to avoid ...contain chlorine. To avoid damage to the following instructions. Insert aluminum filter into place. 6. See the "Warranty" for service contact information.
■ All-purpose cleaner: ...
Owners Manual - Page 16
...
BU BK
YL/GN WH BK
CN3
WIRING DIAGRAM
L N GND
TR1
K2
CN1
BU
K1
RD
CN5
GY
CN2
WH
K3
BK
User Interface
MOTOR SPECIFICATIONS
POWER SUPPLY
120 VAC
FREQUENCY
60 Hz
POWER ABSORTION 210 W
MOTOR RESISTANCE (Ω)
(SPEED 4) BLUE / BLACK 31.1
(SPEED 3) BLUE / GREY 35.5
(SPEED 2) BLUE / RED 45...
Owners Manual - Page 17
...; Use and maintenance procedures.
■ Accessory and repair parts sales.
■ Referrals to local dealers, repair parts distributors, and service companies. In Canada
If you need replacement parts
If you need to local dealers.
■ Installation information.
■ Use and maintenance procedures.
■ Accessory and repair parts sales.
■ Specialized customer assistance (Spanish...
Whirlpool WVU57UC0F Reviews
We have not received any reviews for Whirlpool yet.