Operating Instructions
Page 6
... black dots may appear or bright points of light (red, blue, or green) may cause a problem with a solution of mild detergent and water. appeared on the screen, • the lamp replacement indicator on the front panel blinks in the rear cover area may appear constantly on your local ... to reflections from the wall outlet and refer servicing to qualified service personnel. Installation s If direct sunlight or other hazards. Projection Lamp s Your TV uses a projection lamp as thinner or benzine for Antenna Grounding. s In rare instances, the bulb may pop inside the lamp unit, but...
... black dots may appear or bright points of light (red, blue, or green) may cause a problem with a solution of mild detergent and water. appeared on the screen, • the lamp replacement indicator on the front panel blinks in the rear cover area may appear constantly on your local ... to reflections from the wall outlet and refer servicing to qualified service personnel. Installation s If direct sunlight or other hazards. Projection Lamp s Your TV uses a projection lamp as thinner or benzine for Antenna Grounding. s In rare instances, the bulb may pop inside the lamp unit, but...
Operating Instructions
Page 12
... of three blinks at a time until the lamp door or the lamp is ready, the green indicator stays on. To avoid eye discomfort or injury, do not look into the light housing when ... the Setup Settings (see page 76 and 73). ✍ The light emitted from the lamp is quite bright when your TV, it with a new Sony XL-2400 replacement lamp (not supplied). ❑ After lamp is... appears. ❑ When the projection lamp wears out, the screen goes dark. POWER flashing green : The lamp for the light source is a change in the condition or a problem with green indicator. red : The lamp door or the...
... of three blinks at a time until the lamp door or the lamp is ready, the green indicator stays on. To avoid eye discomfort or injury, do not look into the light housing when ... the Setup Settings (see page 76 and 73). ✍ The light emitted from the lamp is quite bright when your TV, it with a new Sony XL-2400 replacement lamp (not supplied). ❑ After lamp is... appears. ❑ When the projection lamp wears out, the screen goes dark. POWER flashing green : The lamp for the light source is a change in the condition or a problem with green indicator. red : The lamp door or the...
Operating Instructions
Page 17
...setting. Press to activate the , B, b, v, and V buttons. Press to cycle through channels, press and hold either - If the LED blinks in red when the lamp for the light source has burned out. Do not put anything near the sensor, as a reference when operating the TV. 17 Use the tactile dot...). VOLUME + and - For details, see page 72. CHANNEL+ buttons. Flashes in red continuously, this LED will remain lit even if the TV is not securely attached (see contacting Sony information on . When the red LED blinks only three times, the lamp door of the timers is set , this may be ...
...setting. Press to activate the , B, b, v, and V buttons. Press to cycle through channels, press and hold either - If the LED blinks in red when the lamp for the light source has burned out. Do not put anything near the sensor, as a reference when operating the TV. 17 Use the tactile dot...). VOLUME + and - For details, see page 72. CHANNEL+ buttons. Flashes in red continuously, this LED will remain lit even if the TV is not securely attached (see contacting Sony information on . When the red LED blinks only three times, the lamp door of the timers is set , this may be ...