Icom A220 TSO Support and Manuals
Get Help and Manuals for this Icom item
View All Support Options Below
Free Icom A220 TSO manuals!
Problems with Icom A220 TSO?
Ask a Question
Free Icom A220 TSO manuals!
Problems with Icom A220 TSO?
Ask a Question
Popular Icom A220 TSO Manual Pages
Instruction Manual - Page 2
...RWARNING! i
If disregarded, inconvenience only.
Icom, Icom Inc. SAVE THIS INSTRUCTION MANUAL - S'il n'a pas été installé conformément aux instructions, il peut par ailleurs créer...233;glementation FCC.
and Icom logo are designed to this transceiver, not expressly approved by Icom Inc., could void your authority to part 15 of personal injury, fire ...
Instruction Manual - Page 10
... menu mode items in the menu mode.
w TX INDICATOR
u STANDBY FREQUENCY READOUT
Displayed while transmitting. (p. 5)
➥ Displays the standby frequency. (p. 5)
e RX INDICATOR
➥ Displays the setting values in use. o MEMORY CHANNEL READOUT
quency during Dualwatch operation. (p. 14)
Displays the selected memory channel number in the
➥ Displayed when opening the active...
Instruction Manual - Page 11
...
The flow chart below shows the basic operating procedures. change the active frequency for details.
• Set the frequency normally • Set the frequency directly
Set the standby frequency. Set the operating frequency.
01
Set the frequency normally
02
Set the desired frequency which will be used
frequencies into memory channels. There are two ways to...
Instruction Manual - Page 13
...mode readout "MN" or "AU" blinks. BASIC OPERATION 2
■■Directly setting the frequency
You can also directly set to "USER SET."
eePush [RCL] to mute undesired noise when no signal
received.
wwRotate...the squelch test function is
turned OFF.
• MN (manual): Uses the squelch level set in the Configuration menu (p. 22) is heard.
121.80
• Rotate [VOL] to be...
Instruction Manual - Page 14
... memory channels can be 4 memory types, depending on the transceiver version. version transceivers.)
GPS memory channels (GPS) Up to 10 GPS memory channels can easily set the desired frequency by selecting the channel from the memory.
Memory
Regular memory channels CH01:127.00 CH02:127.10
CH20: 128.575
...
...
Group memory...
Instruction Manual - Page 15
....005
CH01
push [DIAL] and then rotate [O- CH TAG (For only group memory channel) Sets the channel tag to the selected memory channel. (Selecting the group memory channel is also displayed if...There are memory mode menus to exit the memory mode with- They contain the following items.
REPLACE (p. 9) Enter the selected memory channel frequency to its previous state. REVIVE Returns the selected ...
Instruction Manual - Page 18
... then rotate [O-DIAL] to page 24 for separating memory types. yyHold down [RCL] to set the channel tag.
wwPush [DIAL] and then rotate [O-DIAL] to select a memory group ...YES Common Traffic Advisory Frequency
DEP YES YES
Departure
FSS YES YES
Flight Service Station
RFS YES YES Remote Flight Service Station
UNI YES YES
Unicom frequency
MF YES YES
Mandatory frequency
OTH YES...
Instruction Manual - Page 20
...details.
13 rrPush [MEM] to store the GPS memory channel data to set a desired GPS memory channel. eeRotate [DIAL] to the selected group ...replacing, and so on) of the regular memory and group memory. wwRotate [O-DIAL] to enter the memory mode. wwRotate [O-DIAL] to the GPS receiver's instruction manual for available GPS receiver details. qqPush [RCL] to select "GPS." Airport code...
Instruction Manual - Page 23
... is strictly prohibited and shall not be used in the Settings menu. (p. 20)
■■Opening the squelch for test
This function manually opens the squelch for details. *Connect pins L, 10,...the rear panel to the switches connected to "INSTALLATION GUIDE" for two seconds to enter the Settings menu.
04
wwRotate [O-DIAL] to exit the Settings menu. Refer to the power ground.
ww...
Instruction Manual - Page 24
...receiving a signal on the active frequency. ttHold down [VOL] for weather channel signals. You can set the interval time (scan speed) for two seconds to page 22 for three times and the scan is ...mode, and then rotate [O-DIAL] to "WX10" channels for details.
Refer to cancel the scan manually. RX
DUAL WEATHER
RX
122.00 161.655
WX08
17 rrWhen no signal is displayed even searches ...
Instruction Manual - Page 27
... while receiving, such as [VOL]. • OFF (0): Mutes the headphone. • 001 to 080: Sets the audio level to set to "USER SET." • MN (manual): U se "SQL LEVEL" to between 1 and 80. el.
20 MENU MODE 5
■■Settings menu items
DDAM squelch level "SQL LEVEL"
Adjust the squelch level for FM mode operation...
Instruction Manual - Page 28
... of 8.33 kHz Channel Spacing of this ra- dio is OFF.
• 001 to 080: Sets the sidetone level to between 1 and 80. Sets the brightness manually to suit your dealer in the Configuration menu (p. 24) is set at a desired beep level. • OFF (0): The beep tone is disabled. • 001 to...
Instruction Manual - Page 30
... your preference. • OFF: The dimmer function is OFF. • AUTO: Automatically sets the dimmer according to the current
lighting condition. • MANUAL: M anually sets the dimmer in the Manual dimmer control
"DISP MAN" item. (p. 21)
DDDimmer auto mode "DISP AUTO"
Sets the method to automatically control the dimmer brightness.* *Displayed only when the Dimmer...
Instruction Manual - Page 31
.... t P ush [MEM] again to select the next input digit.
DDExternal input "AUX IN"
Set the audio usage input from the intercom 2's
05
headset when:
-
Refer to 'INSTALLATION GUIDE' for audio usage input is set to "AUTO." • 050 to 100: Sets the maximum dimmer brightness level to be- q Push [MEM] to select a desired character. While...
Instruction Manual - Page 38
... 20 Intercom 2 squelch level 22 Intercom usable setting 24 Interlock 25 Interlock mode 25
L Lock function 15 Lock mode 20
M Manual dimmer control 21 Memory clear 25 Memory operation ...16 Remote exchange 25 Remote incom 25 Remote recall 25
S Settings menu items 20 Settings menu 18 Sidetone level 21 Specifications 27 Squelch settings 6 Squelch test 16 Squelch mode 20
T Time-Out-...
Icom A220 TSO Reviews
We have not received any reviews for Icom yet.