IBM 84885BU Support and Manuals
Get Help and Manuals for this IBM item
Popular IBM 84885BU Manual Pages
User Manual - Page 7
... failure 18 Erasing a lost or forgotten password (clearing CMOS 19 Updating Remote Supervisor Adapter II firmware 20 Power checkout 21 Troubleshooting the Ethernet controller 21 Network connection problems 21 Ethernet controller troubleshooting chart 22 Ethernet controller messages 23
Chapter 4. Customer replacement units 25 Installation guidelines 25
System reliability guidelines 25...
User Manual - Page 19
... the startup-device sequence, set the date and time, and set in the IBM xSeries User's Guide on the system board.
v SCSISelect Utility program (some models) For general configuration, use ServeRAID Manager to enable HostRAID must install a device driver. v IBM ServerGuide Setup and Installation CD The ServerGuide program provides software-setup tools and installation tools that are...
User Manual - Page 29
... jumper from pins 1 and 2 and set the CMOS recovery jumper and erase a forgotten password:
1. Replace the frame-support bracket (see the User's Guide on the IBM Documentation CD. Connect the server to lost or forgotten passwords. After the update session is completed, turn on page 32). 10. Disconnect all external cables and power cords and turn off the server...
User Manual - Page 30
... "Removing and installing the support bracket" on password will be found in the Remote Supervisor Adapter II User's Guide.
20 xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide You can now start the server one time, without having to use the power-on page 29). The Configuration/Setup Utility program starts.
14. Replace any adapters that...
User Manual - Page 46
...and 8648: Hardware Maintenance Manual and Troubleshooting Guide Insert the DIMM into the connector by applying pressure on the server model, one or more of this section. Installing a drive
Depending on...the microprocessor air baffle" on page 33), replace the support bracket (see "Removing and installing the support bracket" on page 32), and go to install or remove, do so now;
b. 7....
User Manual - Page 64
...installation" on page 32) and go to external hard disk drives. If the server model supports internal SATA hard disk drives, installing...replace the frame-support bracket (see "System board internal connectors" on the rear of the
signal-cable connectors on page 86).
54 xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide...complete instructions for installing a...
User Manual - Page 69
... 4. 10. If you install or remove a power supply, observe the following steps to replace a hot-swap power supply, but you suspect a problem with two hot-swap power supplies. Complete the following precautions. Start the Configuration/Setup Utility program and set it aside. Hazardous voltage, current, and energy levels are no serviceable parts inside any part that has this label...
User Manual - Page 110
...8648: Hardware Maintenance Manual and Troubleshooting Guide System board.
188 (EEPROM CRC #2 damaged.)
1. System board.
163 (Real-time clock error)
1.
System board.
164 (Memory configuration changed.)
1. Make sure that the latest firmware is installed.
2. System board.
189
1. Microprocessor.
199 (Microprocessors not in the Configuration/Setup Utility program. 2.
User Manual - Page 111
... service technician. Keyboard 2. System board.
602 (Invalid diskette boot record)
1. System board.
662 (Diskette drive configuration error)
1. Download and install latest level of BIOS code. 2. Run the Configuration/Setup Utility program. 4. Hard disk cables 2. Hard disk adapter 3. Microprocessor 2. Diskette 2. System board.
1601 (BIOS code update needed)
1. Error code/symptom...
User Manual - Page 116
....
2. System board.
165-201-000 (Service Processor: Failed)
1. Run the diagnostic test again.
(Unable to the error log and diagnostic panel.
3. It may be keeping the Remote Supervisor Adapter II busy. DIMMs. 4. Reseat the Remote Supervisor Adapter II. 3. Remote Supervisor Adapter II.
106 xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide
User Manual - Page 126
... (CRU), and which components must be replaced by a field service technician (FRU). Start the CD from the primary drive.
v The serial port is enabled and is complete.
116 xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide
the option is not
system is supported, either there is supported by the ServerGuide program. Run the...
User Manual - Page 127
..." on page 4). Power supply. see "Server controls, connectors, LEDs, and power" on page 131 to be lit is lit, replace the adapters and devices one at a time until you isolate the problem.
3. If the dc good LED is : v Power supply v Power cage assembly, if installed. On
On
Power is lit, press Ctrl+Alt+Delete.
If you received any error messages when...
User Manual - Page 129
... BIOS and firmware for controller. Install download jumpers, flash latest level BIOS code and firmware for controller. Install download jumpers, flash latest level BIOS code
and firmware for more information.
3E20 (ServeRAID-5i only)
1. Remove jumpers.
2. Remove jumpers.
2. ServeRAID error codes
In the following error codes, x can be replaced by a field service technician.
Verify...
User Manual - Page 134
...
steps1 and 2 are not followed. Power supply. 3. Power cage assembly, if installed.
124 xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide power good signal not detected
for x 1. fan v Replace power supply x. Power supply x 3.3 V fault (level-critical; 3.3 V power supply x had an error)
System running non-redundant power (level-noncritical; system does not...
User Manual - Page 194
...-swap power supply 117 POST (ISPR) 121 SCSI 118 ServeRAID 119 service processor 118 Ethernet activity LED 5 cabling 64 connector 64 controller, messages 23 controller, troubleshooting 21 link status LED 5
external options, connecting 62 external SCSI connector 65
F
fan connectors 86 front, removing 78 rear, removing 80
features and specifications, server 3 filler panel 38, 41 firmware, updating...
IBM 84885BU Reviews
We have not received any reviews for IBM yet.