Release Notes
Page 7
This feature is enabled by default if using phones with Cisco™ devices running CDP....routers, bridges, access servers, and switches). The miscreant sends ARP requests or responses mapping another station's IP address to its own MAC address. ¾ Multiple LLDP Neighbors per Interface This feature allows support for multiple neighbors on a single ...intended to receive the data (instead of being flooded to all its hosts residing on its unsuspecting neighbors. PowerConnect 6224/6224F/6224P/6248/6248P Release Notes ¾ MLD Snooping (RFC2710) In IPv4, Layer 2 switches can use IGMP ...
This feature is enabled by default if using phones with Cisco™ devices running CDP....routers, bridges, access servers, and switches). The miscreant sends ARP requests or responses mapping another station's IP address to its own MAC address. ¾ Multiple LLDP Neighbors per Interface This feature allows support for multiple neighbors on a single ...intended to receive the data (instead of being flooded to all its hosts residing on its unsuspecting neighbors. PowerConnect 6224/6224F/6224P/6248/6248P Release Notes ¾ MLD Snooping (RFC2710) In IPv4, Layer 2 switches can use IGMP ...
Release Notes
Page 9
... Firmware Version 3.2.0.6 Page 7 OSPF accepts packets received on point-to-point interfaces even if the source IP address is not on the link. This mode of operation is a broadcast network. OSPF does not elect ...default route configured on a router). • A preventive measure against a DOS attack on the interface to AllSPFRouters. This feature can avoid situations where a routing loop can be initiated via SNMP using the MIB defined in a network. ¾ OSPF v2/v3 Passive Interfaces Allows passive interfaces for a particular set of IP prefixes. PowerConnect 6224/6224F/6224P...
... Firmware Version 3.2.0.6 Page 7 OSPF accepts packets received on point-to-point interfaces even if the source IP address is not on the link. This mode of operation is a broadcast network. OSPF does not elect ...default route configured on a router). • A preventive measure against a DOS attack on the interface to AllSPFRouters. This feature can avoid situations where a routing loop can be initiated via SNMP using the MIB defined in a network. ¾ OSPF v2/v3 Passive Interfaces Allows passive interfaces for a particular set of IP prefixes. PowerConnect 6224/6224F/6224P...