Service Manual
Page 69
...will blink if the print server is receiving or transmitting data. 6.2 Network Factory default setting (For HL-5170DN) If you wish to reset the print server back to its default factory settings. When the Drum, Paper and Status LEDs go off , release the Go button. (4) Hold down the Go ...Status LED comes on APIPA, see the Network User's Guide or visit http://solutions.brother.com 2-36 The print server has been reset to its default settings (resetting all the LEDs light up again, the printer will be orange if the print server is connected to a 100BaseTX Fast Ethernet network. CHAPTER 2...
...will blink if the print server is receiving or transmitting data. 6.2 Network Factory default setting (For HL-5170DN) If you wish to reset the print server back to its default factory settings. When the Drum, Paper and Status LEDs go off , release the Go button. (4) Hold down the Go ...Status LED comes on APIPA, see the Network User's Guide or visit http://solutions.brother.com 2-36 The print server has been reset to its default settings (resetting all the LEDs light up again, the printer will be orange if the print server is connected to a 100BaseTX Fast Ethernet network. CHAPTER 2...
Service Manual
Page 260
... DOS window is still transmitted or the writing procedure continues. Release the Go button. Re-writing may be sure NOT to the printer. HL-5130/5140/5150D/5170DN SERVICE MANUAL 1. Holding down the Go button will be created. (START>Setting>Printer) Delete the created printer driver (copy 2). 7-17... rebooted, then the printer driver (copy 2) will cause the LEDs to the printer; Status LED (orange) blinking.) (While writing the firmware; Release the Go button when the Toner and Drum LEDs light up . Connect the USB cable to shut down the Go button. Open the front cover, and ...
... DOS window is still transmitted or the writing procedure continues. Release the Go button. Re-writing may be sure NOT to the printer. HL-5130/5140/5150D/5170DN SERVICE MANUAL 1. Holding down the Go button will be created. (START>Setting>Printer) Delete the created printer driver (copy 2). 7-17... rebooted, then the printer driver (copy 2) will cause the LEDs to the printer; Status LED (orange) blinking.) (While writing the firmware; Release the Go button when the Toner and Drum LEDs light up . Connect the USB cable to shut down the Go button. Open the front cover, and ...