Poulan PP1130ES Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PP1130ES manuals!
Problems with Poulan PP1130ES?
Ask a Question
Free Poulan PP1130ES manuals!
Problems with Poulan PP1130ES?
Ask a Question
Popular Poulan PP1130ES Manual Pages
User Manual - Page 1
Always Wear Eye Protection During Operation
199338 07.05.05 BY Printed in serious injury. IMPORTANT MANUAL
Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PP1130ES
SNOW THROWER
WARNING:
Read the Owner's Manual and follow all Warnings and Safety Instructions.
Failure to do so can result in U.S.A.
User Manual - Page 2
... instructions could result in moving parts.
Know how to operate the equipment. Preparation
1.
WARNING: Always disconnect spark plug wire and place it where it on a trailer with electric drive motors or electric starting when setting up spilled fuel.
(h) If fuel is generally a warning of California to the State of trouble. WARNING: Snow throwers have exposed rotating parts...
User Manual - Page 3
...
DATE OF PURCHASE
THE MODEL AND SERIAL NUMBERS WILL BE FOUND ON A DECAL ATTACHED TO THE REAR OF THE SNOW THROWER HOUSING. TABLE OF CONTENTS
SAFETY RULES 2-3
MAINTENANCE SCHEDULE 14
PRODUCT SPECIFICATIONS 3
SERVICE AND ADJUSTMENTS 16-18
CUSTOMER RESPONSIBILITIES 3
STORAGE 18
ASSEMBLY / PRE-OPERATION 5-7
TROUBLESHOOTING 19
OPERATION 8-13
REPAIR PARTS 20-31
MAINTENANCE 14...
User Manual - Page 5
...and check carton thoroughly for additional loose parts.
Remove all parts and hardware you attempt to ensure proper tightness.
All parts such as necessary to assemble or operate your snow thrower. Your new snow thrower has been assembled at .
3. Remove snow thrower from carton.
2.
ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you assemble...
User Manual - Page 7
...
5/16-18 CARRIAGE
BOLT
FLAT WASHER 5/16-18 LOCKNUT
FIG. 9
INSTALL WEIGHT BAR (See Fig. 10) Though seldom required, the weight bar will reduce the tendency of snow thrower.
2. Secure weight bar to ride up on threaded stud and tighten securely. Should conditions require it, install as shown. Position chute rotater head over chute bracket.
User Manual - Page 8
... TO START
AND RUN, PULL OUT TO STOP. IGNITION KEY.
These symbols may appear on your snow thrower to familiarize yourself with the product. Learn and understand their meaning.
Save this manual for future reference.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. OPERATION
KNOW YOUR SNOW THROWER
READ THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR...
User Manual - Page 10
... forward
or reverse movement of any adjustments or repairs. Do not use to stop . Keep the...snow. ENGINE 1. Move throttle control to disengage. OFF
FULL
FIG. 14
TO CONTROL SNOW DISCHARGE (See Fig. 15)
WARNING: Snow throwers have exposed rotating parts, which snow...snow is thrown is in which can result in the OPEN position. Set the deflector low to unclog the chute and/or auger. set...
User Manual - Page 12
...service before storage of 87 octane. Replace a damaged or worn scraper bar.
household current. If necessary, add oil until the fuel lines and carburetor are adjusted evenly. Do not overfill.
• Be sure your house is not recommended to operate the snow thrower...with snow thrower on each side of this manual.
three-wire grounded system.
Your snow thrower ...
User Manual - Page 13
... - WARNING: Do not operate snow thrower if weather conditions impair visibility. ...manual.
6. DO NOT push the primer. Rotate choke control to the engine.
2.
WARM START -
Allow the engine to remove snow is the early morning. DO NOT turn the key. Push starter button until it falls.
• The best time to warm up of the starter, proceed as follows:
13
Clean the entire snow thrower...
User Manual - Page 14
... must maintain snow thrower as instructed in this manual). Check controls to be made periodically to slip from wear. (See "TO REMOVE BELT COVER" in this manual. The V-belts on this unit. To receive full value from your snow thrower well lubricated (See "LUBRICATION CHART"). NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this snow thrower does not cover...
User Manual - Page 15
... of each season or after every 100 hours of your snow thrower after each use . Refill engine with API service classification SG-SL. MUFFLER
Inspect and replace corroded muffler as it cannot come in the "PRODUCT SPECIFICATIONS" section of this manual.
9.
Clean the outside of any oil trapped inside the...
User Manual - Page 16
... CONTROL SNOW DISCHARGE" in impeller shaft and install two (2) new 1/4-20 x 1-5/8" capscrew/shear bolts. belts are not adjustable. It is secured to stop . Install 1/4-20 locknuts and tighten securely. Disconnect spark plug wire from spark plug and place
drive belt be replaced. Connect spark plug wire to frame. 2. Wait for all moving parts to any service...
User Manual - Page 17
... while bringing snow thrower together),
separate the snow thrower and repeat step 10. KLIK PIN (INSTALL IN OUTER HOLE OF AXLE ONLY)
OUTER HOLE
11.
Wipe up on the auger belt and squeeze sides together above pulley so belt is important that an assistant stand in this section of belts.
SERVICE AND ADJUSTMENTS
WARNING: Belt replacement requires...
User Manual - Page 18
... if your snow thrower to separation and formation of this manual). Also, alcohol blended fuels (called gasohol or using fuel stabilizer.
Pour one season to another.
• Replace your gasoline can starts to form and will void the warranty. SERVICE AND ADJUSTMENTS
ENGINE
See engine manual. Overspeeding the engine above the factory high speed setting can damage...
User Manual - Page 19
.... 5. Auger belt is worn. 3. Fuel shut-off of pulley. 2. Prime as instructed in manual unless directed to a qualified service centre. Replace spark plug. 10.
Remove ice and snow on and around fuel tank cap.
4. Choke is hard to OFF position. 2.
Tighten all fasteners. Replace damaged parts.
Augers / impeller jammed.
1. Check / reinstall auger belt. 2. Clean...
Poulan PP1130ES Reviews
We have not received any reviews for Poulan yet.