Product Manual
Page 11
...LED blinking green for each of the five ports, sequentially. NOTE: The Cable Diagnostic function does not support 10M/100M. D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch LED Indicators The LED indicators of the network. If a cable fault is detected, it is first applied to a 1000Mbps Ethernet... greater than the specified 100 ohms). The Switch is in an Ethernet cable connecting the Switch to reset. This process is first powered on). Note: There is no display of cable faults detected by a combination of the Speed and the Link/Act LEDs, as follows: Open, Short,...
...LED blinking green for each of the five ports, sequentially. NOTE: The Cable Diagnostic function does not support 10M/100M. D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch LED Indicators The LED indicators of the network. If a cable fault is detected, it is first applied to a 1000Mbps Ethernet... greater than the specified 100 ohms). The Switch is in an Ethernet cable connecting the Switch to reset. This process is first powered on). Note: There is no display of cable faults detected by a combination of the Speed and the Link/Act LEDs, as follows: Open, Short,...
Product Manual
Page 15
This blinking of the LED indicators represents a reset of the Switch and the other end into the local power source outlet. Power Failure As a precaution, in . 8 8 When power is powered on, the LED indicators will momentarily blink. After the Switch is resumed, plug the Switch back in the event of a power failure, unplug the Switch. D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Power On Plug one end of the AC to DC power converter into the power connector of the system.
This blinking of the LED indicators represents a reset of the Switch and the other end into the local power source outlet. Power Failure As a precaution, in . 8 8 When power is powered on, the LED indicators will momentarily blink. After the Switch is resumed, plug the Switch back in the event of a power failure, unplug the Switch. D-Link DGS -1008D Unmanaged Gigabit Ethernet Switch Power On Plug one end of the AC to DC power converter into the power connector of the system.