Cisco CISCO7120-AT3 - 7120 Router Support and Manuals
Get Help and Manuals for this Cisco item
This item is in your list!
View All Support Options Below
Free Cisco CISCO7120-AT3 manuals!
Problems with Cisco CISCO7120-AT3?
Ask a Question
Free Cisco CISCO7120-AT3 manuals!
Problems with Cisco CISCO7120-AT3?
Ask a Question
Popular Cisco CISCO7120-AT3 Manual Pages
Configuration Guide - Page 2
...(UCB) as part of UCB's ... SET ...SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. The use of actual IP addresses in this document are shown for illustrative purposes only. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS. Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x © 2009-2011 Cisco...
Configuration Guide - Page 5
... Availability 3-7 Virtualization Support 3-7 Default Interfaces 3-7 SVI Autostate Exclude 3-7 Licensing Requirements for Layer 2 Port Modes 3-8 Prerequisites for Layer 2 Interfaces 3-8 Guidelines and Limitations 3-8 Default Settings 3-9 Configuring Access ... 4-1 Information About Layer 3 Interfaces 4-1
OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
v
Configuration Guide - Page 9
... document comments to nexus7k-docfeedback@cisco.com
Configuring vPC Peer Links and Links to the Core on a Single Module 7-19 vPC Interactions with Other Features 7-20 Virtualization Support 7-27 vPC Recovery After an Outage 7-27 High Availability 7-28 Licensing Requirements for vPCs 7-29 Guidelines and Limitations 7-29 Default Settings 7-30 Configuring vPCs 7-30 Enabling...
Configuration Guide - Page 16
...in italics.
A nonquoted set of code
indicates a comment line.
Document Conventions
Preface
Send document comments to nexus7k-docfeedback@cisco.com
Chapter
Description
Chapter 8, "Configuring IP Tunnels"
Describes how to configure IEEE 802.1Q-in-Q (Q-in-Q) VLAN tunnels and Layer 2 protocol tunneling. Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
xvi
OL...
Configuration Guide - Page 17
....html Subscribe to be careful. The RSS feeds are a free service. OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
xvii
In this situation, you might do something that could result in Cisco Product Documentation as an RSS feed and set content to the What's New in equipment damage or loss...
Configuration Guide - Page 19
... Configuration Guide, Release 5.x
1-1
Most of the interface types supported by the Cisco NX-OS software. Table 1-1
Interface Parameters
Feature Basic parameters
Layer 2
Parameters
Further Information
description, duplex, error disable, flow control, MTU, beacon
Chapter 2, "Configuring Basic Interface Parameters" of this document
Layer 2 access and trunk port settings
Chapter...
Configuration Guide - Page 23
... Context Configuration Guide, Release 5.x. You must install this license on every system that interface if you can only configure that enables IP tunnels. After the switchover, Cisco NX-OS applies the runtime configuration after the switchover. Each VDC is allocated to a VDC, you can allocate interfaces. Licensing Requirements for Interfaces
Interfaces support stateful and...
Configuration Guide - Page 37
...remote port send parameter is configured to a value other than auto.
OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
2-13 By default, each port is configured, set...manually for the combinations of pause frames, set the Ethernet port speed to auto, the device automatically sets...command.
• When configuring flow control for example, 10, 100, or ...
Configuration Guide - Page 52
... or set the speed before setting the duplex mode. If you want to set the local port to use a specific speed, you must set the remote port...supports your changes for the local port. BEFORE YOU BEGIN
Make sure that the remote port has a speed setting that you specify 10- interface interface 3. copy running-config startup-config
2-28
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide...
Configuration Guide - Page 132
... Guide.
For the echo response packet, BFD sets the TTL value to the BFD peers. For a complete explanation of BFD packets. Beginning with Cisco NX-OS Release 5.2, you to upgrade software without impacting forwarding.
After a reboot or supervisor switchover, Cisco DC-OS applies the running configuration and BFD immediately sends control packets to 254.
Virtualization Support...
Configuration Guide - Page 223
.... We also recommend that you set all the vPC peer link interfaces...correctly configured. We recommend that you manually configure the system priority on the ...links in each channel.
series modules and LACP, vPC peer link supports 16 LACP interfaces: 8 active ... vPC peer links. See the Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.x, for information about ...
Configuration Guide - Page 225
...feature allows a pair of the Cisco Fabric Service over Ethernet (CFSoE) protocol....Cisco Nexus 7000 Series devices to appear as STP edge ports. (See the Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide...settings are sent from the STP computation. The Cisco NX-OS software fully supports PIM ASM on vPC. See the Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide...
Configuration Guide - Page 228
... displays an error message.
7-26
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x...Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 5.x, for the CFSoE feature to flow seamlessly. CFSoE
The Cisco Fabric Services...The CFSoE transport is not supported on the restored vPC peer ... -bia) for HSRP or manually configuring virtual MAC addresses for many...
Configuration Guide - Page 230
...setting in the startup configuration. vPC Peer Roles After Recovery
When the other available role. 2. Note See the Cisco Nexus 7000 Series NX-OS High Availability and Redundancy Guide, Release 5.x, for the local vPC ports. High Availability
During an In-Service Software Upgrade... configure the Cisco Nexus 7000 Series device to restore vPC services when its peer fails to come online by using ...
Configuration Guide - Page 283
...Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
9-7 You must disable IGMP snooping on the tunnel VLANs.
• Control Plane Policing (CoPP) is not supported...Dot1x tunneling is not supported.
• You should perform an EPLD upgrade to newer versions in... limitations:
• Switches in the service-provider network must manually configure the 802.1Q interfaces to be...
Cisco CISCO7120-AT3 Reviews
Do you have an experience with the Cisco CISCO7120-AT3 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Cisco yet.
Earn 750 points for your review!