Whirlpool WFG510S0AW Support Question
Whirlpool WFG510S0AW Support Question
Find answers below for this question about Whirlpool WFG510S0AW.Need a Whirlpool WFG510S0AW manual? We have 3 online manuals for this item!
Current Answers
Answer #1: Posted by BusterDoogen on January 10th, 2018 11:07 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,427
Member since:
October 30th, 2011 Points: 28,565,427
Go here for guidance in adjusting the oxygen level.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Whirlpool WFG510S0AW Manual Pages
Installation Guide - Page 1
...SAFETY 2 INSTALLATION REQUIREMENTS 3
Tools and Parts 3 Location Requirements 3 Electrical Requirements 5 Gas Supply Requirements 5 INSTALLATION INSTRUCTIONS 7 Unpack Range 7 Install Anti-Tip Bracket 7 Make Gas Connection 8 Verify Anti-Tip Bracket Is Installed and Engaged 9 Level Range 10 Electronic Ignition System 10 Warming Drawer or Premium Storage Drawer 12 Storage Drawer 12 Oven...
Installation Guide - Page 2
RANGE SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is not followed exactly, a fire or explosion may result causing ...
Installation Guide - Page 3
... bracket must be available. Install anti-tip bracket to floor. Slide range back so rear range foot is the installer's responsibility to comply with your cabinets, check ...plywood under anti-tip bracket. • See installation instructions for details.
Do not operate range without anti-tip bracket installed and engaged. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required ...
Installation Guide - Page 4
... Home - Additional Installation Requirements The installation of the oven door)
IMPORTANT: Range must be raised approximately 1" (2.5 cm) by not less than ¹⁄₄" (0.64 cm) flame retardant millboard covered with leveling
legs screwed all the way in the "Level Range" section. When such standard is covered by adjusting the leveling legs.
**Front...
Installation Guide - Page 5
... that the outlet provides 120-volt power and is correctly grounded.
■ This gas range is equipped with all local codes and ordinances.
See "Gas Conversions" section.
5 Do not...the GFCI breaker is possible due to trip during normal cycling.
■ Performance of the range is adequate.
Explosion Hazard
Use a new CSA International approved gas supply line. If connected...
Installation Guide - Page 10
... back. Check with a Storage Drawer: Use a ¼" drive ratchet, wrench or pliers to adjust leveling legs up or down until the range is level. NOTE: Range must be a steady blue flame approximately ¼" (0.64 cm) high. If a burner does not light at this point, turn each control knob to the gas supply must...
Installation Guide - Page 11
....
2. No yellow tips, blowing or lifting of dark blue, and should occur.
3. If the oven bake flame needs to be clean and soft in the center of the control knob stem until the front of the range. Tighten locking screw. Screws B. Oven bottom
3. Using a mirror: Insert a mirror to one side of
the...
Installation Guide - Page 12
...Lift up the drawer alignment tab from inside the warming drawer or premium storage drawer, and allow the range to cool completely before attempting to the drawer stop notch
2. Drawer alignment tab C. Press CANCEL/OFF ...drawer in the drawer glides on both sides. A
A. If flame needs to the drawer glides. To Remove: 1. Pull the storage drawer straight back to remove the drawer....
Installation Guide - Page 15
...oven frame behind the top left side of the oven door for proper sizing of the screws through the range cooktop to remove. 3. A
A. Burner cap D. LP Gas Orifice Spud Chart for Surface Burners
Burner ...Rating Color
Size
ID Number
14,000 BTU 11,000 BTU 8,000 BTU 5,000 BTU
Yellow/Orange Yellow/Brown Yellow/Black Yellow/White
1.07 mm 0.99 mm 0.85 mm 0.70 mm
L107 L99 L85 ...
Installation Guide - Page 16
...a "53."
16 Bake burner
7. The spud will be stamped with a "49." Remove the oven racks. 2. Flame spreader
5. Insert the tabs on a covered surface. To Convert Oven Bake Burner (Natural Gas to LP Gas)
1.
...Screws B. Oven bottom
4. Lift front of the flame spreader and pull forward to remove tabs from oven and set it aside on front of the ...
Installation Guide - Page 17
...Installation (Natural Gas to ½" (1.3 cm) long. NOTE: Make sure to complete this procedure. Slide range back so rear range foot is very important. B
A
C
A. Gas supply line
2. See the "Storage Drawer" or ...instructions can tip the range and be removed to the gas supply.
2. To range B. Unplug range or disconnect power. The outer cone is moved. LP gas flames have to the "...
Installation Guide - Page 18
...cover B. Washer E. Gas pressure regulator cap
5. NOTE: Reinstall one of the screws through the range cooktop to the following chart for future use and keep with a number on a covered surface. ...,500 BTU 12,000/12,500 BTU 9,500 BTU 8,000 BTU 5,000 BTU
Yellow/Blue Red/Magenta Red/Black Red/Orange Red/Blue Red/Yellow Red/Brown Red/White Red/Brass
2.16 mm 2.10 mm 2.00 mm 1.90 mm 1.85 mm...
Installation Guide - Page 19
... and lower the rear of the bake burner off the oven orifice, and set it aside on the rear of the flame spreader into the front of oven. Reattach the oven bottom panel with 2 screws. 11.
The spud will be stamped with...orifice, and slide the tab on front of the bake burner into the rear
of the flame spreader to remove tabs from the front tabs of oven and set the bake burner aside.
...
Installation Guide - Page 20
....
9. Refer to the "Electronic Ignition System" section for proper cooktop, bake and broil burner flame is a trademark of this manual to "Complete Installation" in the "Installation Instructions" section of ...drawer.
IMPORTANT: You may have to adjust the "LO" setting for properly connecting the range to save the orifices that have yellow tips.
3. Complete Installation (LP Gas to ...
Use & Care Guide - Page 3
... passages
in an oven or near surface units.
■ Top burner flame size should be killed. Verify the anti-tip bracket has been properly installed and engaged per installation instructions. Aluminum foil linings may cause carbon monoxide poisoning. The range, when installed, must be electrically grounded in accordance with local codes or...
Use & Care Guide - Page 5
... displayed. 4. A tone will sound, and "Loc" will help avoid poor ignition and
A
uneven flames. Failure to turn knob to light properly. After burner lights, turn on at a certain time of... Delayed Timed Cook, see "Cook Time" section.
REMEMBER: When range is off all controls when not cooking. Burner cap B. A good flame is used for an oven function with the
controls locked. Only ...
Use & Care Guide - Page 7
...cycle tones
Three tones ■ Invalid pad press
Four tones ■ End of the range will include several times until the oven display
shows the current setting, for your local ...contact your cooking needs. Press CANCEL to certain birds. Press and hold TIMER for 5 seconds until a flame is sensed
■ a "poof" sound is open. Press CANCEL to exit. Electronic Oven Controls
Control...
Use & Care Guide - Page 12
... knob before turning to follow these instructions can result in the gas lines
Clogged burner ports Clogged burner ports Burner caps positioned improperly Range converted improperly
Cookware and flame are uneven, yellow and/or noisy
Excessive heat around cookware on any one of a service call an electrician.
Control is in the gas...
Use & Care Guide - Page 13
...Be sure that batter is in the "Electronic Oven Controls" section. PROBLEM Oven burner flames are yellow or noisy Oven temperature too high or too low Convection fan not working
Display... . The convection fan will not operate
Oven cooking results not what expected
POSSIBLE CAUSES
Range converted improperly
Oven temperature needs adjustment. Clear the display. Depending on bottom.
See the...
Use & Care Guide - Page 14
... Broiler Pan and Roasting Rack Order Part Number W10123240 www.whirlpool.com/broilerpan
14
Range converted improperly
This is normal. The igniters will make a single pop when it... information. Noises PROBLEM Surface burner making popping noises Gas range noises during the cycle. Pop
Click
Woosh or poof Oven burner flames are some models). Convection fan relay is normal.
This...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The tone pitch on my gas range is too loud
... some models): Press and hold Bake for 5 seconds. The oven burner flames on my gas range are yellow or noisy Tone pitch: The pitch is too loud. Repeat to low. What do I control the tones on my Style 1 electric range? A tone will sound, and "Snd Lo" will appear on the display. On... -
Gas surface burner performance
... simmer/heat setting Melt chocolate or butter Surface burners fail to ignite My gas range cooktop burners are not functioning My cooktop cooking results on my gas range are not what I expected The oven burner flames on my gas range are turned to Lite will click. Settings and recommended use Lite: Light the... -
My cooktop cooking results on my gas range are not what I expected
...control knob turned to Ignite. All four surface burners will not operate when the range is fully on some models) The right rear burner has an adjustable heat setting for...more precise simmering and low temperature cooking. Only the burner with a nonstick finish will produce a flame. Burner (on . After burner lights, turn knob counterclockwise to Ignite will take on the grate...
Similar Questions
Burner Knobs Turn But Do Not Adjust Flame
I know how to turn burners on. However, the flame does not adjust when going from high to low/simmer...
I know how to turn burners on. However, the flame does not adjust when going from high to low/simmer...
(Posted by chevygirl1002 8 years ago)
Can I Adjust The Burner Flames. They Are Too High.
(Posted by audreyback 9 years ago)
How Do I Adjust The Burner Flame
None of the burner flame are hig enough takes 1/2 hr to boil water. natural gas
None of the burner flame are hig enough takes 1/2 hr to boil water. natural gas
(Posted by dicdunn 11 years ago)
Odd Smell, And Yellow In The Flames...
We have a Whirlpool range that gives off an odd odor when the oven is in use, and there is yellow co...
We have a Whirlpool range that gives off an odd odor when the oven is in use, and there is yellow co...
(Posted by ts3 12 years ago)