Whirlpool WFG510S0AW Support Question
Whirlpool WFG510S0AW Support Question
Find answers below for this question about Whirlpool WFG510S0AW.Need a Whirlpool WFG510S0AW manual? We have 3 online manuals for this item!
Question posted by audreyback on January 9th, 2015
Can I Adjust The Burner Flames. They Are Too High.
The person who posted this question about this Whirlpool product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by BusterDoogen on January 9th, 2015 4:10 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,407
Member since:
October 30th, 2011 Points: 28,565,407
- Excessive heat around cookware on cooktop
- Cookware and flame are not matched.
- Clogged burner ports Burner caps positioned improperly Range converted improperly
- See "Sealed Surface Burners" section. See "Sealed Surface Burners" section. If propane gas is being used, contact a service technician or see cover for contact information.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Whirlpool WFG510S0AW Manual Pages
Installation Guide - Page 4
...left side of the oven door)
IMPORTANT: Range must be raised approximately 1" (2.5 cm) by not less than ¹⁄₄" (0.64 cm) flame retardant millboard covered with local codes.
upper cabinet... by adjusting the leveling legs.
**Front of this range is not recommended. *Range can be level after installation. Mobile home installations require: ■ When this range must ...
Installation Guide - Page 6
...). This valve should be used . B
Gas Pressure Regulator
The gas pressure regulator supplied with the range connection.
Gas Supply Line
■ Provide a gas supply line of E.I .D., flexible metal appliance.... Burner Input Requirements
Input ratings shown on the model/serial rating plate are reduced at ½ psi gauge (14" WCP) or lower The range must be level with this range must...
Installation Guide - Page 7
... installed on either the left side or right side of the cutout. If you are installing the range in a mobile home, you can result in death or serious burns to adjust the rear legs from range. 2. The mounting can result in back or other injury.
1. B
Centerline
A
A. 12 31.9 cm) B. See the following illustrations...
Installation Guide - Page 10
... contact your dealer or authorized service company for assistance.
High flame
To adjust standard burner: The flame can be installed correctly. Check with the range. Place a standard flat rack in and turn the control knobs to the "LITE" position.
Check Operation of the level. The cooktop "low" burner flame should light within 4 seconds. A
B
3. If you have AquaLift™...
Installation Guide - Page 11
... on a covered surface. Using a mirror: Insert a mirror to the Use and Care Guide or User Instructions for each setting. 5. Control knob stem B.
If the "low" flame needs to be adjusted, locate the air shutter near the center rear of the range. Refer to one side of the burner.
Installation Guide - Page 12
...burner.
2.
Loosen the lock screw on some models)
The storage drawer can be adjusted...:
1.
Open the warming drawer or premium storage drawer to its
fully open and close the warming drawer or premium storage drawer to the drawer glides. A
B
B
A.
Lock screw B. Drawer glide notch
2. To Remove: 1. Flat-blade screwdriver B. A
A. If flame... and allow the range to cool completely...
Installation Guide - Page 16
... tabs from the front tabs of the oven bottom panel into the rear
of
the panel is away from the broil burner orifice hood. Flame spreader
5. Position the back of the bake burner over the oven orifice, and slide the tab on a covered surface. Reattach the oven bottom panel with a "57" spud.
Lift...
Installation Guide - Page 17
... cone is moved. Refer to ½" (1.3 cm) long. Install anti-tip bracket to the "Electronic Ignition System" section for proper burner ignition, operation and burner flame adjustments. Re-engage anti-tip bracket if range is not as distinct as the inner cone.
To Convert Gas Pressure Regulator (LP Gas to LP Gas)
1. IMPORTANT: Do not...
Installation Guide - Page 19
... the "090" hood with a "49" spud. Lift front of oven and set the bake burner aside.
Screws B. Flame spreader
5. Position the back of the bake burner over the oven orifice, and slide the tab on the rear of the flame spreader into the front of the oven. 12. Insert the tabs on front of...
Installation Guide - Page 20
.... Refer to save the orifices that have yellow tips.
3. Refer to the "Electronic Ignition System" section for properly connecting the range to adjust the "LO" setting for proper cooktop, bake and broil burner flame is a trademark of Whirlpool, U.S.A.
1/12 Printed in the "Installation Instructions" section of this manual to Natural Gas)
1. IMPORTANT: You may...
Use & Care Guide - Page 1
...oven door.
You will need assistance, call us at www.whirlpool.com for purchasing this high-quality product. Para obtener acceso a "Instrucciones para el usuario de la estufa a gas...on the oven frame behind the top left side of Contents
RANGE SAFETY 2 The Anti-Tip Bracket 3
FEATURE GUIDE 4 COOKTOP USE 5
Sealed Surface Burners 5 Burner Size 6 Cookware 6 Home Canning 7 OVEN USE 7 ...
Use & Care Guide - Page 3
... bottom or cover an entire rack with local codes or, in an oven or near surface units.
■ Top burner flame size should be adjusted so it does not extend beyond the edge of a range -
WARNING
Tip Over Hazard A child or adult can result in or on the backguard of the cooking utensil. Failure...
Use & Care Guide - Page 5
... sound, and "Loc" will produce a flame.
2. Turn off . 2. REMEMBER: When range is in use, the entire cooktop area may not bake properly. Burner base C. All surface burners will click. KEYPAD
FEATURE
START TIME Delayed... HIGH and LOW.
Check that the oven is off all controls when not cooking. Turn knob to enter the burner ports.
5 Electric igniters automatically light the surface burners ...
Use & Care Guide - Page 6
...the cookware. Correct
5.
Burner Size
Select a burner that best fits your... cookware. Use the following illustration and chart. Do not use a wooden toothpick. Do not use oven cleaners, bleach or rust removers.
1. Contact a trained repair specialist. Ideal cookware should have a flat bottom, straight sides and a wellfitting lid, and the material should be adjusted...
Use & Care Guide - Page 7
...adjusted so that may be heard each time the Bake or Broil burners ignite during the cooking cycle:
■ gas valves may make a "popping" sound when opening the oven door may cook faster or slower than your local agricultural extension office, or refer to the USDA Home Canning Guides. The flame... pad press
Four tones ■ End of the range will "click" several noises that it does not ...
Use & Care Guide - Page 10
...Once the oven has completely cooled, remove ash with Adjustable Clean Time (on some birds is extremely sensitive to cook.
5. If the temperature is too high, the oven door will remain locked and "cool... door is completely closed and well-ventilated room. Food Poisoning Hazard
1. Press START.
RANGE CARE
Self-Cleaning Cycle
WARNING
Burn Hazard Do not touch the oven during the self-cleaning...
Use & Care Guide - Page 11
... and tomato, should be cleaned when oven cools.
At high temperatures, foods react with porcelain and staining, etching, pitting..., gritty washcloths or abrasive paper towels.
METALLIC PAINT (on burners while wet. Do not reassemble caps on some models)
Food...clean water and dry with soft, lint-free cloth.
Unplug range or disconnect power.
4. CONTROL PANEL AND OVEN DOOR EXTERIOR ...
Use & Care Guide - Page 12
... the Installation Instructions. See "Electronic Oven Controls" section.
12 The range is in Demo Mode.
Electronic oven control set correctly.
The flame should be adjusted so that it does not extend up the sides of the surface burner knobs to incorrect heat level Range is not level Air in death, fire, or electrical shock. Press...
Use & Care Guide - Page 13
... section. Level the range. See "Oven Temperature Control" in the "Electronic Oven Controls" section.
PROBLEM Oven burner flames are yellow or noisy Oven temperature too high or too low Convection... in the oven. A Timed Cooking function has been entered. Oven temperature needs adjustment. Oven was incorrect. Not enough air circulation around bakeware Darker browning of food ...
Use & Care Guide - Page 14
... W10123240 www.whirlpool.com/broilerpan
14
Noises PROBLEM Surface burner making popping noises Gas range noises during Bake and Broil operations The following are normal operational noises that can visit our website at www.whirlpool.com/cookingaccessories. Pop
Click
Woosh or poof Oven burner flames are short clicking sounds like tapping a nail onto a piece...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The tone pitch on my gas range is too loud
... and off . Tone pitch: The pitch is preset at high, but can be adjusted or turned off ? A tone will sound, and "Snd Lo" will appear on my Style 1 electric range? The oven burner flames on my gas range is too loud. The tone pitch on my gas range is too loud The tone pitch on my gas... -
The oven temperature on my gas range is either too high or too low
... Model # What is either too high or too low The oven temperature on my gas range is the Oven Temperature Control feature on my gas range and how does it may cook faster...displayed amount. To review temperature calibration and adjustment guides on my gas range are not what I expected Temperature not accurate - calibration The oven burner flames on other Whirlpool appliances, enter ... -
How do I regulate the flames sizes on my gas modular downdraft cooktop?
...-on my gas range is cool. Front-load washer The burner flames of the flames on my gas modular downdraft cooktop are noisy when turned off If flames lift off and the cooktop is either too high or too low The burner flames on different settings. Do not allow foods containing acids (such as shown. To adjust, change setting...
Similar Questions
How Do I Adjust The Burner Flame
None of the burner flame are hig enough takes 1/2 hr to boil water. natural gas
None of the burner flame are hig enough takes 1/2 hr to boil water. natural gas
(Posted by dicdunn 11 years ago)
Burner Flame
There seems to be very little difference between high and simmer setting on the burners. Is this ad...
There seems to be very little difference between high and simmer setting on the burners. Is this ad...
(Posted by arnoldsko 12 years ago)
Burner Flame Too High At Low Setting
How do I adjust the burner flame? My stove has been converted to LP.
How do I adjust the burner flame? My stove has been converted to LP.
(Posted by neurott192 13 years ago)