Home » Whirlpool » Ranges » Whirlpool WFG361LVQ

Whirlpool WFG361LVQ Support Question

Find answers below for this question about Whirlpool WFG361LVQ - 30 Inch Gas Range.
Need a Whirlpool WFG361LVQ manual? We have 4 online manuals for this item!

Whirlpool Overview Questions Manuals Reviews Videos Research

Question posted by neurott192 on July 14th, 2010

Burner Flame Too High At Low Setting

How do I adjust the burner flame? My stove has been converted to LP.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Whirlpool WFG361LVQ Manual Pages

Dimension Guide - Page 1

...adjusting the leveling legs. It should be used for connecting range to the gas...with LP gas. ...flame retardant millboard covered with not less than 24" (61.0 cm), oven frame must be located in insufficient gas supply. A smaller size pipe on longer runs may be equipped with leveling legs screwed all the way in the system. G. 8" (20.3 cm) H. ® 30" (76.2 cm) Freestanding Gas Range...

Owners Manual - Page 1

® GAS RANGE USER INSTRUCTIONS THANK YOU for additional information. If you still need your model and serial number located on some models 8 RANGE CARE 8 Self-Cleaning Cycle (on the oven frame behind the storage drawer panel. You will need assistance, call us at www.whirlpool.com for purchasing this high-quality product. If you...

Owners Manual - Page 2

... killed or seriously injured if you smell gas" instructions. WHAT TO DO IF YOU SMELL GAS: • Do not try to potential hazards that you cannot reach your gas supplier, call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you use any other appliance. - RANGE SAFETY Your safety and the safety...

Owners Manual - Page 3

... anti-tip bracket, if the range is equipped with the National Electrical Code, ANSI/NFPA 70. Doing so may cause carbon monoxide poisoning. Remove broiler pan and other flammable vapors and liquids. ■ Storage in an oven or near surface units. ■ Top burner flame size should be adjusted so it does not extend...

Owners Manual - Page 5

... poor ignition and uneven flames. REMEMBER: When range is not pressed within 1 minute after a spillover and routinely remove and clean the caps according to follow these instructions can be used to IGNITE. Keep spillovers out of the gas tube by always using a surface burner. A B A. 1-1¹⁄₂" (25-38 mm) B. To set length of soil...

Owners Manual - Page 6

...to give incorrect readings. To Adjust Oven Temperature Calibration: 1. Clean clogged burner ports with the burner cap. Replace the burner cap, making sure the ... is displayed, the oven light will be set between 30°F (15°C) and -30°F (-15°C). 3. If "LOFF... Celsius. Oven Light with a damp cloth. 3. Clean the gas tube opening the oven door may result in death to "-...

Owners Manual - Page 8

...Press START TIME. The temperature and/or time settings can result in food poisoning or sickness. 1....Adjustable Clean Time (on some models) The SELF CLEAN self-cleaning cycle is time adjustable between 2 hours 30 minutes and 4 hours 30.... If the temperature is too high the oven door will remain locked...Exposure to move birds to cook. 5. Prepare Range ■ Remove the broiler pan, grid, ...

Owners Manual - Page 10

... tripped? Gas range noises during Bake and Broil operations Noises that may be heard each time the Bake or Broil burners ignite during self-clean cycle. ■ Is the control knob set correctly? Turn on any one of the surface burner knobs to release air from the solenoid. See "Sealed Surface Burners" section. Surface burner flames are normal...

Installation Guide - Page 1

...30" (76.2 CM) FREESTANDING GAS RANGES Table of Contents RANGE SAFETY 1 INSTALLATION REQUIREMENTS 3 Tools and Parts 3 Location Requirements 3 Electrical Requirements 5 Gas Supply Requirements 5 INSTALLATION INSTRUCTIONS 6 Unpack Range 6 Install Anti-Tip Bracket 7 Make Gas... 12 GAS CONVERSIONS 13 LP Gas Conversion 13 Natural Gas Conversion 16 ANTI-TIP BRACKET TEMPLATE 19 RANGE SAFETY ...

Installation Guide - Page 4

...metal cabinet is covered by adjusting the leveling legs. The shaded...For minimum clearance to top of rigid gas pipe. upper cabinet depth C. 30" (76.2 cm) min. Model/...serial rating plate (located on the oven frame behind the top left side of the oven door) *Range can be raised approximately 1" (2.5 cm) by not less than ¹⁄₄" (0.64 cm) flame...

Installation Guide - Page 5

... is factory set for the control panel to be electrically grounded in accordance with local codes and ordinances, or in death, explosion, or fire. Observe all gas connections. latest edition or CAN/CGA B149 - See "Gas Conversions" section. Gas Supply Line ■ Provide a gas supply line of the range must be ½" (1.3 cm) minimum. Usually, LP gas suppliers...

Installation Guide - Page 9

...range is removed from outside the range. 2. The cooktop "low" burner flame should light within 4 seconds. High flame 9 Plug into a grounded 3 prong outlet. When the cooktop control knob is turned to floor. ■ Slide range back so rear range... that burner caps are set to adjust leveling legs up . Check that rear leveling leg is installed, use electronic igniters in the gas line....

Installation Guide - Page 10

If the "low" flame needs to be adjusted, locate the air shutter near the center rear of the range. Control knob stem B. Repeat above steps for each setting. 5. Remove the oven rack. 2. Remove from "LO" to lowest setting. 2. Flame reflection D. 2 screws 4. Under certain conditions it may take the burner up and back until the front of the panel is...

Installation Guide - Page 11

...range to cool completely before attempting to disengage the storage drawer one side at the same time, then pull drawer out another inch. 4. Press the tab down on some models) Remove all the way out. It will be necessary to remove the drawer. Adjust the air shutter as needed for proper flame...Burner 1. A flat-blade screwdriver will be needed . 3. Adjust Oven Broil Burner Flame...

Installation Guide - Page 12

... the range has been on surface burners and oven. 3. Continue to see the "Range Care" section of liquid household cleaner and warm water to open , press the CANCEL button on range operation.... . ■ If the gas supply line shutoff valve is set into the door. Complete Installation 1. Check that the gas supply line shutoff valve is open it inside the range in the Use and Care ...

Installation Guide - Page 14

...Chart for proper sizing of oven and set it . Replace the burner base using both screw. 7. To Convert Oven Bake Burner (Natural Gas to remove tabs from the front frame. A A. Igniter electrode B. Burner base 3. A A. Lift front of the flame spreader and pull forward to LP Gas) 1. B A A. Screws B. Burner cap D. Replace burner cap. 8. Remove the oven racks. 2. Remove...

Installation Guide - Page 15

... the side to the oven with 2 screws. B To Convert Oven Broil Burner (Natural Gas to the bake burner, position the back of the bake burner over the oven orifice, and slide the tab on the rear of the flame spreader to remove tab from the broil burner orifice hood. A B A A. Bake burner 7. Replace the "47" spud with a "56" spud...

Installation Guide - Page 16

Refer to the "Make Gas Connection" section for proper burner ignition, operation, and burner flame adjustments. Natural Gas Conversion WARNING To Convert Gas Pressure Regulator (LP Gas to the gas supply. 2. See "Storage Drawer" or "Warming Drawer" section. 2. NOTE: On models with solid end facing out D. Reconnect the anti-tip bracket, if the range is not as distinct as the inner cone. ...

Installation Guide - Page 17

... Convert Oven Bake Burner (LP Gas to remove. Remove from oven and set it aside on a covered surface. Screw D. A A. 3. Remove the oven racks. 2. Orifice spud B. Remove 2 screws from the front tabs of the panel is away from rear of the bake burner off the oven orifice, disconnect the igniter wire, and set it aside on the side. Flame...

Installation Guide - Page 18

...The hood will hang in the back of the flame spreader to adjust the "LO" setting for proper burner ignition, operation, and burner flame adjustments. IMPORTANT: Do not overtighten. Orifice spud 9. To Convert Oven Broil Burner (LP Gas to Natural Gas) 1. A 4. Place the broil burner on the broil burner orifice hood and insert the broil burner ceramic igniter in the hole in the...

Whirlpool Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

What are the control panel features on my 30-inch gas modular downdraft cooktop?
... and features quickly, page references from your 30-inch modular downdraft cooktop control panel. Below is a captioned illustration of all parts and features. Use it to become familiar with the location and appearance of your Use & To help you find information on my 30-inch gas modular downdraft cooktop? What are included.
What are the parts and features on the control panel of my freestanding ceramic glass electric range?
... panel features on my 30-inch gas modular downdraft cooktop? The location and appearance of the features shown here may have some or all What are the parts and features on my electric range? My range is the Control Lockout or Lockout on the control panel of my electric drop-in range? The range you have purchased...
The oven temperature on my gas range is either too high or too low
... in Fahrenheit or Celsius. calibration The oven burner flames on my gas range are not what I expected Temperature not accurate - Guides: /shared.whirlpoolcorp.com/service/modelnumber.jsp','modelnumber',500,480);return false;" href="#"> Lookup Model # What is either too high or too low The oven temperature on my gas range is the Oven Temperature Control feature on my...