Panasonic UF-4500 Support Question
Panasonic UF-4500 Support Question
Find answers below for this question about Panasonic UF-4500.Need a Panasonic UF-4500 manual? We have 1 online manual for this item!
Question posted by Kanvaseeharan on October 18th, 2017
Can’t Fax Multiple Pages.
No issues faxing 2 pages, but it will not fax more than 2 pages. It will say waiting to dial. Worked fine for couple of years and issue start happening recently.
Current Answers
Answer #1: Posted by Odin on October 18th, 2017 10:19 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Try a reset: unplug the Power Cord for a few seconds and then plug it in again. If the problem persists (or if you require further explanation), you'll have to obtain a walk-through from Panasonic: use the contact information here--https://www.contacthelp.com/panasonic/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Panasonic UF-4500 Manual Pages
Operating Instructions - Page 17
... number, File number) when the unit is
active.
Used for One-Touch Dialing. (See pages 51 to Know Your Machine
Control Panel
No. Getting to 58)
17 Used to Standard, Fine, Super-Fine or Halftone. (See page 46)
Used for the following:
- Used to start activation.
- Used to start On-Hook
-
Used for copy operations.
14
15
(See...
Operating Instructions - Page 24
... the Key Operator Password (The factory default password is 00000000.) and press Set .
4 06
FAX PARAMETERS NO.= (01-169)
DIALING METHOD? PULSE
or
DIALING METHOD? Setting the Dialing Method (Tone or Pulse)
Your machine can operate with either of two dialing methods (Tone or Pulse), depending on the type of telephone line you need to change...
Operating Instructions - Page 25
...dial tone, dialing signals, and busy tone. The built-in the Fax Parameter No. 10 (KEY/BUZZER VOLUME). (See page 38)
25 or
MMM-dd 15:00 00%
RINGER VOLUME (((( ))))
repeatedly to raise the volume.
Installing Your Machine... enables you to raise the volume. You can adjust the monitor and ringer volume on your machine receives a call. or
MONITOR VOLUME
L [
] H
MONITOR VOLUME
L [
] H
...
Operating Instructions - Page 41
... appears again when transmitting the documents (pressing the start key). VALID : Starts dialing the telephone number immediately
after storing the first page. Displays the memory size. OFF ON NORMAL DARKER INVALID VALID
INVALID VALID
When the machine receive the faxes with Group Dialing or Program Dialing function. Set whether to "2:ON". This function also operates when the addresses...
Operating Instructions - Page 42
... been registered as junk fax number. Unit will
start transmitting, or "No" to "VALID".)
03. DIAL RE-ENTER D. Up to "VALID", manual input destination Tel No.
ID NO. Up to 30 fax numbers can be stored.
Select "Yes" to start transmitting the stored originals. REGIST.".
02. JUNK FAX FILTER" is 255 pages for junk fax number. (Including numerals...
Operating Instructions - Page 45
...(s) is free of paper.
2. ENTER STATION(S) THEN PRESS START
NOTE
1. Transmitting documents longer than 30 pages, wait until the leading edge
inserted in the feeder. 3. You ...page in the machine stops.
Place the document(s) FACE UP on the Automatic Document Feeder (ADF) until transmission or storing in memory starts as follows. Adjust the Document Guides to send multiple pages...
Operating Instructions - Page 48
... stored is stored.
* STORE * NO.003 PAGES=002 10%
COMPLETED TOTAL PAGES=005
2. When sending a Fax, ensure the external telephone is also printed on the lower right corner of the receiving unit, and upon hearing the receiving unit's answering tone, press the Start Key and hang up before dialing.
3. JOURNAL), Transaction Journal and File List...
Operating Instructions - Page 49
...advance. (See page 39) Then the following display appears and the machine will not accept ...UF-4500: 10 files, UF-5500: 20 files) and you whether to transmit the successfully stored documents
or to delete the documents, change the setting of Fax...WAIT!
49 CODE=870
See the Specifications on page 179 for the transmission on the ADF will start transmitting the stored documents, then change Fax...
Operating Instructions - Page 54
...
The following functions have been provided to prevent transmission to multiple addresses. This function operates if Fax Parameter "136 RESTRICT D. NOT AVAILABLE 1 STN ALLOWED
54
NOTE
1. DIAL" of Fax Parameter set to "VALID". (See page 42)
• If this device, it is not possible to multiple addresses.
2. If keypad or Redial/Pause are set to "INVALID...
Operating Instructions - Page 56
...if setting "125 CONFIRM STATIONS" of Fax Parameter set , a message prompting ...Dialing (See page 51)
• Abbreviated Dialing (see page 51)
• Group Dialing (See page 81)
CONFIRM STN ∨ ∧ THEN PRESS START
2
Press or to "VALID". (See page 41) When telephoning from an external telephone, address confirmation is not displayed.
1
Operate "Manual Number Dialing". (See page...
Operating Instructions - Page 65
... number is shown in the upper right hand corner of the display if it is detected, the machine will redial the number up to dial the last dialed number. ON
3 1
ENTER STATION
4
Your machine starts to 3 times at 3 minute WAITING TO DIAL
intervals.
Basic Operations
Redialing
Automatic Redialing
Sending Documents
If a busy line is a memory transmission file...
Operating Instructions - Page 69
Setting the Fax Mode
1
Change Fax Parameter No. 17 (RECEIVE MODE) to receive documents automatically when a call is received.
Basic Operations
69 Receiving Documents
Fax Mode
When your machine is set to this mode, it will begin to 2: FAX. (See page 38)
Operation of Fax Mode
Your machine will immediately begin receiving automatically when a fax call is received.
Operating Instructions - Page 71
... documents immediately from the calling
station. Once the fax transmission is a voice or fax call.
2
Your machine will be monitoring the line to
distinguish whether it is a voice or fax call , your fax machine will be monitoring the line to
distinguish whether it is started during the Telephone Answering Machine(TAM) answering, the TAM will switch the line...
Operating Instructions - Page 75
... one page. 3.
ENTER STATION(S) THEN PRESS START
COPY NO. The copy will be reduced slightly even if the reduction ratio is set to Manual, press and to set to fit the data on the length of copies. If you made a copy with Super Fine resolution, it will be prompted for single or multiple copies...
Operating Instructions - Page 103
...on the availability of Fax Parameter No. 36 (See page 39). The following ...fax, business or personal use with a corresponding ring pattern identifying each number.
Dialing "555-2222"
Ring..Ring Ring..Ring
The fax machine distinguishes that the call is for your local telephone company on a single phone line. "DRD" lets you provide multiple phone numbers, one for the fax machine...
Operating Instructions - Page 107
... pages 50 to 52.) Ex:
after each
ENTER STATION(S) THEN PRESS START
(STN name) 5551234
010
[010](STN name) 5553456
If you want to confirm the number of stations you have entered, press Set .
2 STN(S) SET ADD MORE, START
3
ENTER PIN CODE
4
Ex: 9 8 7 6 (Up to 36 digits)
5
Your machine stores the document and starts dialing the...
Operating Instructions - Page 123
... or receiving a fax from an unauthorized station. You can set a 4-digit transmission password in the other compatible Panafax machine(s). The password must...UF-585
• UF-770
• UF-895 • UF-4500 • UF-5200
• UF-6300
• DP-2330 • DP-4520
• DP-8032
• DP-C264 • DP-C306 • DP-C405
NOTE
1. If the transmission password in your machine...
Operating Instructions - Page 128
If your machine receives two confidential faxes with a confidential code into memory. That means you can receive the confidential fax using a 4-digit confidential code. If confidential faxes were received in the mailbox of compatible Panafax models which ensure that the Confidential information you cannot poll those documents. The UF-733 is received only by the person...
Operating Instructions - Page 140
... not be used simultaneously with connected machine. • UF-490, 590, 790, 890, 990 • UF-4000, 4100, 6000, 6100 • UF-6200, 6300
140 Installing the Printer Driver and Application Software
General Description
The Panasonic Document Management System enables the machine to your computer For sending, receiving fax documents using your computer For confirming the...
Operating Instructions - Page 153
...(UF-5500 Only)
4
Enter the fax number or select the checkbox from the [File] menu.
3
Select [Panasonic Fax Driver] as the active printer, and click [OK].
• The [Panasonic Fax Driver... PC-FAX password
(See page 139) at initial use of header information by clicking [Preview].
5
Click [Send]. • A confirmation dialog box appears.
Using the machine as a PC Fax Sending ...
Similar Questions
Error Code 420
My fax seems to be working fine but I get a code Incomplete Info error 420
My fax seems to be working fine but I get a code Incomplete Info error 420
(Posted by gmobrien 6 years ago)
Install Panasonic Uf 4500
There was no disk that came with my printer to install it. Only the operating one. Can't get it to i...
There was no disk that came with my printer to install it. Only the operating one. Can't get it to i...
(Posted by ampdawn 10 years ago)
New Machine! Fax Rings, Nothing Received! Have Rebooted And Still Have Issue!
(Posted by Anonymous-114919 10 years ago)
I Can Not Receive Fax On My 4500 All In One What Do I Do I Can Send Faxe
I thought i could down load that part of the manusl to find the answer
I thought i could down load that part of the manusl to find the answer
(Posted by diamondjoy 12 years ago)
Kx-f880 Fax/answering Machine Will Only Receive Fax; Will No Longer Send.
used to send and receive fax-- all of sudden will not transmit fax-- each time says its ready for re...
used to send and receive fax-- all of sudden will not transmit fax-- each time says its ready for re...
(Posted by jekell 13 years ago)