Onkyo HT-RC270 Support Question
Onkyo HT-RC270 Support Question
Find answers below for this question about Onkyo HT-RC270.Need a Onkyo HT-RC270 manual? We have 1 online manual for this item!
Question posted by Jgold69993 on November 12th, 2013
Firmware Update Problems
I am trying to do a firmware update and it starts out downloading and gets to 78% and then just stays there. Any suggestions?
Current Answers
Answer #1: Posted by waelsaidani1 on January 28th, 2014 5:57 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
Make sure your AV receiver and TV are turned
on and an Ethernet cable is connected to the rear
panel of the AV receiver.
• Never unplug or turn off the AV receiver while it
is being updated.
• Never plug or unplug an HDMI or Ethernet cable
during the update process.
• Do not attempt to access the AV receiver from
your PC while it is being updated.
• Never unplug the power cord during the update
process.
• It takes maximum 60 minutes to complete the
firmware update.
• The AV receiver will retain all your settings after
the update is finished.
on and an Ethernet cable is connected to the rear
panel of the AV receiver.
• Never unplug or turn off the AV receiver while it
is being updated.
• Never plug or unplug an HDMI or Ethernet cable
during the update process.
• Do not attempt to access the AV receiver from
your PC while it is being updated.
• Never unplug the power cord during the update
process.
• It takes maximum 60 minutes to complete the
firmware update.
• The AV receiver will retain all your settings after
the update is finished.
Set the “HDMI Control(RIHD)” setting to
“Off”.
• Turn off the controller device connected via
Ethernet cable.
• Turn off Zone 2.
• Stop playback of contents from Internet
Radio, iPod/iPhone, USB or servers, etc.
Press RECEIVER followed by SETUP
on the remote controller.
The Setup menu will be displayed on the
TV screen. The procedures thereafter can
also be performed on the AV receiver by
using its SETUP, arrow and ENTER
buttons.
2 Select “Hardware Setup” and press
ENTER.
3 Select “Firmware Update” and press
ENTER.
Note that the “Firmware Update”
option will be grayed out for a short
while after the AV receiver is turned on.
Please wait until it becomes operable.
4 Select “Via NET” and press ENTER
Related Onkyo HT-RC270 Manual Pages
Owner Manual - Page 1
... retain this manual thoroughly before making connections and plugging in this manual will enable you for future reference. Following the instructions in the unit. AV Receiver
HT-RC270
Instruction Manual
Thank you to obtain optimum performance and listening enjoyment from your new AV...
Owner Manual - Page 5
... Hardware Setup 53 Lock Setup 56 Using the Audio Settings 56
NET/USB 59 About NET 59 Connecting the AV Receiver 59 Listening to Internet Radio 60 Playing Music Files...for Onkyo Components Connected via V 77 Resetting REMOTE MODE Buttons 78 Resetting the Remote Controller 78 Controlling Other Components 78 Learning Commands 80 Using Normal Macros 80
Others
Troubleshooting 82 ...
Owner Manual - Page 6
.../Napster)
* Services available may vary depending on the region.
• Network Capability for Streaming Audio Files • Bi-Amping Capability for FL/FR with 4 Activities and ModeKey LEDs
*1
Manufactured ... Display via HDMI • Preprogrammed (with Audio Return Channel, 3D), Deep- which are registered in the United States and other U.S. To receive HD Radio broadcasts, you must install an ...
Owner Manual - Page 10
...jacks I FM ANTENNA jack and AM ANTENNA terminal J PC IN port K Power cord L GND screw
M Composite, S-Video and analog audio jacks (BD/DVD IN, VCR/DVR IN and OUT, CBL/SAT IN, GAME IN, PC IN, TV/CD IN and PHONO IN)...Speaker Terminals (FRONT L/R, CENTER, SURR L/R, SURR BACK L/R, FRONT HIGH L/R and FRONT WIDE/ZONE 2 L/R)
See "Connecting the AV Receiver" for connection information (➔ 13 to 23).
Owner Manual - Page 17
...
Optical digital connections allow you to connect DVD players with AV components
HDMI cable
: Video & Audio AV receiver
Other cables
: Video AV receiver
: Audio
TV, projector, etc.
Note
• The AV receiver does not support SCART plugs. • The AV receiver's optical digital jacks have shutter-type covers that open when an optical plug is a conventional...
Owner Manual - Page 18
...-compatible TV, Player, or Recorder" (➔ 89).
■ Audio return channel (ARC) function Audio return channel (ARC) function enables an HDMI capable TV to send the audio stream to "On" (➔ 54). Tip
• To listen to audio received by controlling the AV receiver's volume, the AV receiver's speakers will be seen on the TV screen (on...
Owner Manual - Page 19
....)
' PC IN ( Multichannel input
Analog RGB
Personal computer
*2
Analog audio
DVD player, DVD-Audio or *3
Super Audio CD-capable player,
En
or an MPEG decorder
19 If your components to the MONITOR OUT V, MONITOR OUT S or the COMPONENT VIDEO MONITOR OUT, use the AV receiver's display when changing settings. Connecting Your Components
The on...
Owner Manual - Page 20
... (see "Subwoofer Input Sensitivity" (➔ 43).
• The AV receiver can output audio and video signals from the AUX INPUT jacks to PHONO IN. You must...audio from the external components in Zone 2 as well. • With connection $, you can use the following special functions:
■ System On/Auto Power On When you start playback on a component connected via V while the AV receiver...
Owner Manual - Page 23
... by the analog VCR/DVR OUT.
When choosing a connection format, bear in the following audio connection formats: analog, optical, coaxial, analog multichannel, or HDMI.
En
23 Audio Connection Formats
Audio component can be selected automatically in mind that the AV receiver does not convert digital input signals for analog line outputs and vice versa.
Owner Manual - Page 26
...; 69), this menu.
Note that are grouped in 10 minute steps.
BD/DVD
Audio
Bass
Video
Treble
0dB
Info
Subwoofer Level
Input
Center Level
Listening Mode Dynamic EQ
Dynamic Volume
2 ...Tip • If you need to cancel the sleep timer, press SLEEP repeatedly
until the AV receiver sleeps, press
SLEEP. Selecting Speaker Layout
You can temporarily mute the output of input selectors, ...
Owner Manual - Page 27
Note
*1 If Pure Audio or Direct listening mode is selected, "Dynamic EQ" and "Dynamic Volume" cannot be selected.
*2 Only when...here output the sound.
*4 When you to Stereo, Mono, Direct, or Pure Audio. • Only the Stereo, Direct, Pure Audio, and Mono listening modes can be displayed if the AV receiver receives it 's already set to change the input display. This setting can be displayed....
Owner Manual - Page 29
... position Also referred to as this function, connect and position all audio electronics.
• The microphone picks up to which played through...Radio Frequency Interference (RFI) can measure up test tones which the AV receiver is set to "On" (➔ 48), the "Equalizer" setting... caused by room acoustics by capturing room acoustical problems over the listening area in your hand during ...
Owner Manual - Page 34
... on the VCR and start playback. VCR, DVD recorder
L
R
AUDIO IN
VIDEO IN
Cassette, CDR, MD, etc. See the manuals supplied with recording capability, and how to record audio and video from your TV or playback VCR to the recording VCR without going through the AV receiver, connect the TV/VCR's audio and video outputs...
Owner Manual - Page 41
... that is connected to change
the setting. Miscellaneous H 7. Tuner 3. HDMI 4. Firmware Update
I 8. Picture Adjust
F Listening Mode Preset (➔ 52)
9. Listening Mode Preset
1. VCR/DVR 3. MENU 1. Input/Output Assign 2. Audio Adjust 4. ate external input is connected to change the AV receiver's various settings. Hardware Setup I Remote Controller Setup (➔ 76)
3. Lock...
Owner Manual - Page 55
... the TV is compatible or not.
• The "TV Control" setting can update the AV receiver's firmware.
Check the network connection before update. ` via USB: You can update the firmware via NET: You can update the firmware from a USB mass storage device.
You are both audio and video stream from 30 seconds before the Auto Power Down functions. Note...
Owner Manual - Page 61
...My favorite song 6 My favorite song 7
1 / 10
En
61 See "Supported Audio File Formats" to the instruction manual of items on the server appears.
Refer to...receiver may not able to play music files on a computer or media server through the AV receiver. DISPLAY
NET/USB
ENTER R/X/F/S
RETURN
REPEAT RANDOM
1 Start ...To update the screen, press RETURN.
3 Use R/X to the presets. 1.
A list...
Owner Manual - Page 62
...repeatedly.
Not all servers support all of the songs on your computer.
1 Start Windows Media Player 11. 2 On the Library menu, select Media Sharing....receiver in random playback. This completes the Windows Media Player 11 configuration. Supported Audio File Formats
For server playback, the AV receiver supports the following screen appears.
Incompatible files cannot be downloaded...
Owner Manual - Page 63
... Update Rollup for Windows XP can play stored music files. Members of DLNA develop
a concept of wired and wireless interoperable networks
where digital content such as the AV receiver... files are supported. (Playing times may display incorrectly with VBR.) • WMA files must be downloaded for lossless audio data compression. • Sampling rates of 8 kHz, 11.025 kHz, 12 kHz, 16 kHz,...
Owner Manual - Page 65
...; This procedure can then be performed on the AV receiver by SETUP. The DNS (Domain Name System) translates domain names into an IP address, in your Web browser, before accessing the site, your TV.
2 Use R/X to select "Hardware Setup", and then press ENTER. Firmware Update
3 Use R/X to select "Save", and then press ENTER...
Owner Manual - Page 84
...
Make sure you 've selected the correct remote con- 11, 78 troller mode. If you've connected a cassette tape deck, to...start immediately.
When using the - manufacturers' AV components, some buttons may not work
Before operating this indicates that the video input to which -
This is 88 not guaranteed.
antenna. RECEIVER. Make sure that the V 20 cable and analog audio...
Similar Questions
Onkyo Ht-rc270 Freezes Up.
My receiver freezes up and will not recognize any buttons, or remote. Reset does not fix problem. Th...
My receiver freezes up and will not recognize any buttons, or remote. Reset does not fix problem. Th...
(Posted by n2psr1 7 years ago)
Hook Up Two Subwoofers
i have a ht rc 270 onkyo receiver and a skw200 (75w) subwoofer and a sw10 polk audio subwoofer, can ...
i have a ht rc 270 onkyo receiver and a skw200 (75w) subwoofer and a sw10 polk audio subwoofer, can ...
(Posted by lprave 11 years ago)