Hoover U6436-900 Support Question
Hoover U6436-900 Support Question
Find answers below for this question about Hoover U6436-900 - TurboPower 7600 Self Propelled WindTunnel Upright.Need a Hoover U6436-900 manual? We have 1 online manual for this item!
Current Answers
Related Hoover U6436-900 Manual Pages
Manual - Page 3
... wet hands. • Do not put any opening blocked; Brushroll continues to rotate when in the upright position. • Turn off all parts of body away from product, and do not allow to be... present. • Unplug before operating. • Operate vacuum only at bottom of cleaner. • Do not leave appliance when plugged in areas where they may...
Manual - Page 5
... back of the cleaner, make sure switch (A) is in dirt duct on back of handle.
1.2
A
Using a Phillips screw driver, tighten screws securely.
1.4 Remove label (D) from self-propel button.
1.3
1.4
D
Attach hose
1.5 Align end of hose with projection (E) over rack and into hose tube (G).
1.5
1.6
1.7
E
F
G
F
IMPORTANT
Hose must be connected as shown for all operations.
5 Actual...
Manual - Page 6
.... HOW TO USE
Cleaner Description 2.1
1. Powered Hand Tool
6
7. Check Bag Indicator
12
23
15
18
21
8 22
17. Extension Wand 21. H 1.11
2. Cord Hooks
19.
Self-Propel Button
2
3. Final Filter Door
4
8. Upholstery Tool*
23. To turn cleaner OFF, push switch down.
2.2
Actual model may be purchased separately by visiting www.hoover.com, or...
Manual - Page 7
... cleaning strokes in upright position, tilt cleaner back on . IMPORTANT The self-propel feature operates only when the cleaner switch and the self propel button are removed. upright for general operation on...red light will remain on for reaching under furniture, noncarpeted floors), slide the self-propel button to OFF to deactivate the feature.
2.3
Transporting cleaner
2.4 To move your...
Manual - Page 8
...to "Hard" to the next higher setting.
2.8
C
Brushroll control
IMPORTANT
When handle is in upright position, brushroll is automatically OFF.
2.9 Move the brushroll control only when the handle is difficult ... cloth dampened in carpet near baseboards and furniture. Actual model may be washed in the upright position.
Slide control to "Carpet" to raise and lower the front of the cleaner ...
Manual - Page 9
... may be used to give extra length to your hose.
Crevice tool may be in the upright position to activate the
automatic "brushroll OFF" and for convenience in such places as shown.
...and carpeted stairs. Use extra care when cleaning on stairs or furniture, as it may result in upright position, clean from falling, always place cleaner at bottom of the above tools. A
Turn cleaner ...
Manual - Page 10
... available on some models.
! CAUTION ! If the bag is only partially full of your vacuum.
There are three conditions that you change filter bag often. MAINTENANCE
Familiarize yourself with these home... with dirt.
IMPORTANT
All new carpet has loose fibers which can fill the bag quickly while vacuuming. Attach Hose
2.16 Push ON/OFF switch to become completely red:
1. Very fine materials,...
Manual - Page 11
...cleaner without either the secondary or final filter in cold water with your vacuum. Removing and Installing Filter Bag
3.2 Grasp filter bag collar (A) and pull... in place.
To reduce the risk of bag compartment, protects the motor from moving parts, unplug vacuum before servicing. If filter becomes dirty, pull off grill and lift out filter. Changing filter bag
Disconnect...
Manual - Page 12
... a Phillips screwdriver, remove the two screws as follows: 1) Disconnect cleaner from moving parts, unplug vacuum before servicing.
Additional bulbs may vary from moving parts, unplug vacuum before cleaning or servicing. Actual model may be replaced with your WindTunnel™ cleaner picks up and suction.
! CAUTION ! Headlight (Available on sides of the cleaner.
Final...
Manual - Page 13
...
What to Replace
3.9 To check the flat belt, remove bottom plate as shown with your cleaner.
Lift off bottom plate (A).
3.10 Flat belt (B) operates the self-propel feature and indirectly drives the brushroll. Remove used belt (B) from large pulley (C) and discard.
3.11 With lettering on outside of belt, slide new belt over...
Manual - Page 17
... set Set switch to lower setting.
Cleaner / tools won 't pick up
Broken or worn belt.
Change filter bag. Move carpet height control to carpet position. Self-propel button in OFF position. Brushroll in OFF position.
Move brushroll control to tool. Blockage in turbine channel. Replace belt Continue using the checklist below.
Remove blockage...
Manual - Page 18
... will only result in Glenwillow for service. Always identify your vacuum to find the service outlet nearest you need further assistance: To... call 1-800-944-9200; Customers) or hoover.ca (Canadian customers). Do not send your vacuum by :
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. Mon-Fri 8am-7pm...
Similar Questions
No More Self Propelled
My Hoover 300 Platinum Windtunnel model has worked well for years. Love it! However, I just started ...
My Hoover 300 Platinum Windtunnel model has worked well for years. Love it! However, I just started ...
(Posted by peggyrice 9 years ago)
Hoover Windtunnel Anniversary Upright Vacuum, Self-propelled, Bagged, U6485900
won't shut off
won't shut off
(Posted by patciam 9 years ago)
Self Propel Not Working And Brush Not Turning
I am trying to figure out why my self propel stopped working. I have taken it apart and cleaned it o...
I am trying to figure out why my self propel stopped working. I have taken it apart and cleaned it o...
(Posted by C2koebel 10 years ago)
