Home » Honeywell » Motion Sensors » Honeywell 5800PIR-RES

Honeywell 5800PIR-RES Support Question

Find answers below for this question about Honeywell 5800PIR-RES.
Need a Honeywell 5800PIR-RES manual? We have 1 online manual for this item!

Honeywell Overview Questions Manuals Reviews Videos Research

Question posted by uebelhartthomas on July 5th, 2018

Sensors Do Not Detect Movement

My sensors do not detect movement unless I wave my hands right in front of them, or cover them with the hand. It looks like they got "tired" and loose sensitivity with time. No problems with batteries, nor communication with the base station. Did the walk test and everything else recommended by the manuals, for no avail.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Honeywell 5800PIR-RES Manual Pages

Installation Instructions - Page 1

... an installation height of inactivity before being reactivated. Range Pattern Sensitivity Detection Speed Operating Voltage Battery Saving Timer Alarm Period LED Indicator Weatherproof Operating Temperature Humidity Accessories (included) Adjustable up to the ground. 2 Prepare the Sensor for Mounting 1. Remove the Cover by pulling from bottom. This pattern can be adjusted in...

Installation Instructions - Page 2

...four batteries at the same time. If necessary, loosen the Captive Lock Screw and lift Cover off. Install the Back Box on the wall using two M4 x 20 mounting screws. 2. Perform Settings & Adjustments. 6. Do not mix weak batteries ... a pole with an outside diameter of battery is pointing away from the springs. 4 Mount the Sensor WALL MOUNTING 1. Program the control panel. - 2 -

Installation Instructions - Page 3

... . ƒ If there is not made . The upper detection area stays parallel to environmental conditions. Detection length is based on a motion sensor height of 1m (3.3ft) • The height of the lower detection area since both upper and lower areas have to be blocked at all times. Detection Length Detection Length Detection Length UPPER and LOWER beams are blocked...

Installation Instructions - Page 4

Snap in the selected timer period. Cover 6. Set the Sensitivity Select Switch to prevent false detections. Best to the desired sensitivity. Note: The alarm output activations are tagging video, or need high security awareness. Used when frequent alarm transmission is held by the left and right cover prongs and the two tabs are continuous alarm events, the...

Installation Instructions - Page 5

Replace the cover. 2. Repeat the walk test through the detection area, and verify satisfactory results. 3. Approx.8m (27ft) position B Approx.12m (40ft) WALK TEST ƒ This sensor has a multi-level detection pattern (from side view). Examples include puddles, wet surfaces, very smooth asphalt or concrete surfaces. ƒ If this causes a problem, adjust the detection length to position...

Installation Instructions - Page 6

... sensitivity setting. Remount and align sensor so the detection area is faulty or loose. Wiring is parallel to ground. Water in the area may be causing an abrupt temperature change. Transmitter or PIR sensor is too long. Lower detection area is faulty. REMEDY Check for cracks in the housing that would allow water infiltration. Replace batteries. Replace...

Installation Instructions - Page 7

COMPONENT IDENTIFICATION DIAGRAM Pole Bracket Back Box Use four M4x30 screws if mounting to pole brackets, or two M4x20 screws if mounting to wall. UP Sensor (Do not touch) Cover LED Indicator DIP Switch Sensitivity Select Switch Detection Length Ajustment Switch Transmitter Lens Holder Lens Cover Captive Lock Screw M3 x 10 Masking Strip (Use as required) - 7 -