Honeywell IS215T Support Question
Honeywell IS215T Support Question
Find answers below for this question about Honeywell IS215T.Need a Honeywell IS215T manual? We have 1 online manual for this item!
Question posted by fleadbeater on June 18th, 2012
Why Do You Have To Turn Off A Dill Switch After Walk Testing This Is-215t Pir
After walk testing the IS-215T the switch S1 Alarm disable switch has to be turned off.
The PIR then does not flash confirming that it is sensing movement. Is this normal.Will it affect the operation if it is switched on?
Any advice would be appreciated.
Current Answers
Related Honeywell IS215T Manual Pages
Installation Instructions - Page 1
...the unit.
IS-215T Passive Infrared Motion Sensor Installation Instructions
❶ Select the mounting location.
❷ Separate the sensor housings and remove the printed circuit board (PCB).
• Use a small screwdriver to push in a corner.
• Replace the PCB.
❻ Walk-test the sensor. High Sensitivity: 2-4 Steps
(Pulse Count 1)
Low [Normal] Sensitivity: 3-5 Steps
(Pulse...
Installation Instructions - Page 2
... Operating temperature...IS215T...PIR sensitivity: Switch selectable low [normal] (pulse count 2) 3-5 steps high (pulse count 1) 2-4 steps
PIR fields of their respective owners. All rights reserved.
5-051-680-40 Rev C w/o LED -
Alarm: 10mA max.; IS-215T Passive Infrared Motion Sensor Product Information
ALARM LED DISABLE
After walk-testing the sensor, disable the alarm LED by turning Switch S1...
Similar Questions
Activate System, Alarm Set, Senor Trip Without Any Motion In Path?
red button in lower right hand corner ? Reset
red button in lower right hand corner ? Reset
(Posted by Eweebe 1 year ago)
Low Motion Sensor Battery Alarm
Model DT-7235 motion alarm sensors keeps alarming low battery. After I opened the alarm. There was n...
Model DT-7235 motion alarm sensors keeps alarming low battery. After I opened the alarm. There was n...
(Posted by bonshere 1 year ago)
Alarm Code
Code for door motion sensor (this type). Seems it does not have batteries and receives 12 volts from...
Code for door motion sensor (this type). Seems it does not have batteries and receives 12 volts from...
(Posted by chicjim2003 9 years ago)
Operation
The 5890PI device emit a 'BIP' every 1 minute, the LYNXR24 does not show any malfunction, no low bat...
The 5890PI device emit a 'BIP' every 1 minute, the LYNXR24 does not show any malfunction, no low bat...
(Posted by louis1948 10 years ago)
Is215t Conecction To Control Pannel
THE PIRHAS TWO TERMINALS MARKED AS C AND NC TO BE CONNECTED TO THE CONTROL PANNEL. ON THE CONTROL PA...
THE PIRHAS TWO TERMINALS MARKED AS C AND NC TO BE CONNECTED TO THE CONTROL PANNEL. ON THE CONTROL PA...
(Posted by antoniopj 11 years ago)