Honeywell IS215T Support Question
Honeywell IS215T Support Question
Find answers below for this question about Honeywell IS215T.Need a Honeywell IS215T manual? We have 1 online manual for this item!
Question posted by antoniopj on June 2nd, 2012
Is215t Conecction To Control Pannel
THE PIR HAS TWO TERMINALS MARKED AS C AND NC TO BE CONNECTED TO THE CONTROL PANNEL. ON THE CONTROL PANNEL THERE ARE ONLY TWO CONNECTORS AVAILABLE PER ZONE WITH NO MARKS. CAN I CONNECT THE TERMINAL C TO ANY OF THE TWO POSITIONS AVAILABLE ON THE CONTROL PANNEL AND NC TO THE OTHER ONE? THANKS!
Current Answers
Related Honeywell IS215T Manual Pages
Installation Instructions - Page 1
...Count 2)
• Connect wires as shown using...215T Passive Infrared Motion Sensor Installation Instructions
❶ Select the mounting location.
❷ Separate the sensor housings and remove ... Aim sensor away from windows or heating/
cooling devices • Sensor must have a clear line-of the sensor, and ...❺ Configure the sensor sensitivity.
Observe proper polarity.
• ...
Installation Instructions - Page 2
...IS215T must be connected to a UL listed power supply or UL listed control unit capable of providing a minimum of four hours of their respective owners.
Alarm: 10mA max.; Suitable for connection to the OFF position... of standby power. IS-215T Passive Infrared Motion Sensor Product Information
ALARM LED DISABLE
After walk-testing the sensor, disable the alarm LED by turning Switch S1...
Similar Questions
Troubleshooting Motion Detector
Motion detector red indicator light does not go on, have had no problems in pastPossible solutions
Motion detector red indicator light does not go on, have had no problems in pastPossible solutions
(Posted by Twokays 11 months ago)
Activate System, Alarm Set, Senor Trip Without Any Motion In Path?
red button in lower right hand corner ? Reset
red button in lower right hand corner ? Reset
(Posted by Eweebe 1 year ago)
Low Motion Sensor Battery Alarm
Model DT-7235 motion alarm sensors keeps alarming low battery. After I opened the alarm. There was n...
Model DT-7235 motion alarm sensors keeps alarming low battery. After I opened the alarm. There was n...
(Posted by bonshere 1 year ago)
My Sensor Can't Send Signal To The Control Board After Change The Battery.
The whole system can't be set up, since one of the sensor's batteries have been changed. I don't kno...
The whole system can't be set up, since one of the sensor's batteries have been changed. I don't kno...
(Posted by properties5amy 4 years ago)
Alarm Code
Code for door motion sensor (this type). Seems it does not have batteries and receives 12 volts from...
Code for door motion sensor (this type). Seems it does not have batteries and receives 12 volts from...
(Posted by chicjim2003 9 years ago)