Home » Honeywell » Motion Sensors » Honeywell IS2535T

Honeywell IS2535T Support Question

Find answers below for this question about Honeywell IS2535T.
Need a Honeywell IS2535T manual? We have 1 online manual for this item!

Honeywell Overview Questions Manuals Reviews Videos Research

Question posted by Twokays on May 9th, 2023

Troubleshooting Motion Detector

Motion detector red indicator light does not go on, have had no problems in pastPossible solutions

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by SonuKumar on May 9th, 2023 9:59 PM

This answer was accepted by the poster of the original question.

SonuKumar

Member since:
May 9th, 2021

Points: 16,617,810

1,100
points

To perform a reset on your Honeywell IS2535T motion detector by removing the batteries or disconnecting the power source, follow these steps:

Locate the power source of the motion detector. If it's battery-powered, locate the battery compartment. If it's hardwired, locate the power supply wires.

If it's battery-powered, remove the batteries from the compartment. If it's hardwired, turn off the power source by either unplugging it or turning off the circuit breaker that powers the motion detector.

Wait for at least 10 to 15 seconds.

Reinsert the batteries into the battery compartment or reconnect the power supply wires.

Turn on the power source or turn on the circuit breaker.

Wait for the motion detector to power up and calibrate. This can take up to a minute.

Test the motion detector by walking in front of it to see if it detects motion and triggers the control panel.

Performing a reset can sometimes help resolve issues with the motion detector, such as a malfunctioning sensor or programming error. If the motion detector still isn't working after performing a reset, consult the user manual or contact Honeywell customer support for further assistance.

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Answer #2: Posted by HelpHero on May 9th, 2023 3:40 PM

HelpHero

Member since:
September 3rd, 2022

Points: 523,390

100
points

If the device is not flashing red, then it is not detecting motion, and the position of the sensor will need to be adjusted. A motion sensor will enter this mode on its own immediately after powering on. After 10 minutes, it will exit this mode automatically.

I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers.

Helphero

Related Honeywell IS2535T Manual Pages

Specifications - Page 1

...sensor optics which reduces the chance of pet immunity or for home and office. The design of the entire IS2500 series is possible • White Light...sensor • Tamper switch: Is activated before access is sleek and attractive, all sensors share the same family look. The IS2535T sensor...of a complete range of the world motion sensor standards including the European TS 50131-2-2 Grade...

Specifications - Page 2

... 6500 Lux 112 x 60 x 40 mm (HxWxD) 87 gram Mounting hardware Lens masking Look down mask High security / Pet immune lenses Ordering: IS2535T 11 m PIR motion sensor with Pet Immunity Detection Patterns: IS2535T • Top View • Side View High security lens • Side View Pet immune lens Accessories: SMB-10: SMB-10C: SMB...