Home » Genie » Garage Door Openers » Genie SilentMax 1000

Genie SilentMax 1000 Support Question

Find answers below for this question about Genie SilentMax 1000.
Need a Genie SilentMax 1000 manual? We have 1 online manual for this item!

Genie Overview Questions Manuals Reviews Videos Research

Question posted by mrmahmoudrachid on July 10th, 2022

Oblong Led Lights

solid red light on above oblong led lights; door not opening

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on July 10th, 2022 11:39 AM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,700

1,100
points

Reset the open/close travel limit--see https://www.manualslib.com/manual/60649/Genie-Silentmax-1000-3042.html?page=19#manual.

If the issue persists or if you require further advice, you may want to consult the company: use the contact information at https://www.contacthelp.com/genie.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Genie SilentMax 1000 Manual Pages

Owner's Manual - Page 1

GARAGE DOOR OPENER MODELS PowerMax® 1200/1500, SC 1200/1500, TriloGTM 1200/1500, PowerLift® 900, GPowerTM 900, SilentMax® 1000/1200, CB 1000/1200, IntelliG® 1000/1200 SCREW/BELT/CHAIN DRIVES OPERATION & MAINTENANCE MANUAL Includes INTELLICO®DE 2 Remote Control. Safe-T-Beam® System must be installed to the store. Need ...

Owner's Manual - Page 2

...store. 9 S2afety Inf3ormatio4n Safety Notifications 3 Important Safety Instructions 3 Infrared Protection Function 3 F3eatures Safety 4 Opener 4 R4equired5Progra6mming Introduction 5 Overview of Powerhead Controls 5 Travel Limits Closing Garage Door (DOWN Limits 6 Opening Garage Door (UP Limits 7 Wall Console Overview 8 Series III Wall Consoles with Black Buttons... 8 Series...

Owner's Manual - Page 3

...INSTRUCTIONS Garage doors are large, heavy objects that move with the help of the doorway. This symbol alerts you to be fully grounded. tion, call your nearest trained door system...having an emergency release, mount the emergency release within reach, but a avoiding contact with the door opener. All safety messages will follow the safety alert symbol and the word "DANGER", " WARNING",...

Owner's Manual - Page 4

... only after completing assembly and installation of opener. Review the Assembly and Installation poster to the full open /close . 3.When the garage door is closing door if a problem is activated and automatically turns OFF 4 minutes later. The door stops and reverses to ensure all steps have been completed. LED indicator lights on the powerhead and on page 11...

Owner's Manual - Page 5

... used to enter and complete the setup programming. PROGRAM SET - + Enters into and selects programming menus. The LED lights indicate status or a function change by illuminating ON, OFF, or ON FLASHING in the garage door opening and closing your garage door. Remote Programming synchronizes your remote control devices (remotes, wall console, and keypad) with additional remote control...

Owner's Manual - Page 6

... setting limits confirm wall console red indicator light (or backlight) is ON. PROGRAM SET + HOLD 1 2 1 2 Press and hold the down arrow button (-) until garage door is fully closed on floor,...do so now. Closing Garage Door (Down Limits) 1 Lift the door open by hand until the long LED comes on the Powerhead, you see two solid red or flashing LEDs on blue (round LED remains off). PROGRAM ...

Owner's Manual - Page 7

...). SET HOLD 2 seconds 7 Release up arrow button (+) until the long LED light comes on blue (round LED remains off ). PROGRAM PROGRAM - + SET The DOWN (closed is recommended but not necessary. 6 Press and hold the up arrow button (+) for 2 seconds until door is fully open ) limit is programmed. 8 Press and hold the up arrow button (+) and...

Owner's Manual - Page 8

... door opener lights from inside garage. 8 Series III Wall Consoles with this button is ON, the powerhead cannot be activated by the wall console or a remote. • Press and release (or until Indicator Light flashes) to activate Sure-Lock™. • Press and release to work normally. Independent Light Control Button Use this light is OFF. Indicator Light -Red...

Owner's Manual - Page 9

... programmed and automatically set force limits. Red LED lights on the Wall Console. The door MUST complete a full cycle from open to close and close to open and close the garage door for the ﬁrst time automatically sets the Force needed until door passes the Contact Reverse Test. Making adjustments to open before it should stop and reverse direction...

Owner's Manual - Page 11

... HomeLink® device will ONLY respond to pressing THIS button on the remote (the door should open or close). PROGRAM SET - BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR IS READY TO USE! Each Remote can be programmed for other garage door openers, repeat the steps above using one of the other two Remote buttons. to connect...

Owner's Manual - Page 12

... the red LED on steady. Enter your new PIN (3-8 characters). 4. Opener LEDs will run. To erase, follow the steps in order 3-5-7. 2. " Changing Your PIN 1. Press Up/Down key . Press Program key . Press Up/Down key again. Press and hold Program Set key for programming. Press the Program key . 3. Press Up/Down key again. Door opener will...

Owner's Manual - Page 13

... using the Wall Console. NOTE: The garage door opener will not activate the door opener. All remaining (or recovered) Remotes and wireless Keypads MUST BE reprogrammed as shown on pages 9 and 12. T - + SET HOLD 2 seconds 2 Release the Program Set button, round LED goes off and the long LED flashes purple. Your opener will no longer recognize any signal...

Owner's Manual - Page 14

... start with 10 or higher, the Learn Code Button and Indicator LED are located near the antenna. The LED color displayed on the Remote back to turn ON). Press and hold the button for this Intellicode® 1 model of Genie® garage door openers .The default Intellicode® 2 setting must be changed to Intellicode®...

Owner's Manual - Page 16

... hardware, and DO NOT OPERATE garage door automatically or manually if door is closed , pull manual emergency release handle DOWN and let go to contact customer service at least 5 feet above floor to prevent small children from door to the fully open . A. Check for multiple door installations). • No STB red or green LED displayed. - REGULAR MAINTENANCE Basic...

Owner's Manual - Page 17

...carriage, pull down on relaese hanfle. Reconnect power to carriage assembly. To engage shuttle to door opener. • Open powerhead light cover. • Remove light bulb(s). • Replace light bulb(s). - DO NOT use light bulbs with a CR 2032 coin cell battery. 1. Replace battery. 3. Reset Open/Close Travel Limit Performing all eleven (11) Limits/Force setting steps (see pages...

Owner's Manual - Page 19

... increase speed. Sensor modules CAN be positioned further away from door opening if necessary to avoid sunlight but no further off the wall to maintain alignment with condition of the garage receives direct sunlight. • Position the Source (Red LED) on the direct sunlight side Multiple Garage Doors • NEVER position Safe-T-Beam modules where signals will...

Owner's Manual - Page 21

... good one. See page 6. See pages 6-7. • Check if Safe-T-Beam® Red LED is flashing. • Check Safe-T-Beam® system for beam obstruction or misalignment of lenses. • Check garage door for binding. • If an operational problem exists, and opener will only run from remote. • Make certain carriage is OK. - See...

Owner's Manual - Page 22

... opener is lowest speed setting. • If carriage travel . Door component failure detected. Check door spring, track, rollers, hinges and fixtures. Limits NOT set properly. Re-program limits, see page 19. WHAT TO DO • Be sure all door fasteners are tight. • Be sure garage door is in . POWERHEAD LEDS Powerhead LED Round LED Long LED OFF OFF ON/RED...

Owner's Manual - Page 23

... d/b/a The Genie Company ("Seller") warrants to the original purchaser of the below identified, SilentMax® 1000/1200, CB 1000/1200, IntelliG® 1000/1200, PowerMax® 1200/1500, SC 1200/1500, TriloG™ 1200/1500, PowerLift® 900, or GPower™ 900 garage door openers, ("Product"), subject to all of the terms and conditions hereof, that the...

Owner's Manual - Page 24

... 10 17 AM Gives warning tone and flashes red when garage door does not close ? enables safe parking in garage Universal Wall Push Button • Easy to mount inside garage • Used in One Keyless Entry Pad • Wireless; Closed Confirm™ Wireless Remote (Works with all Genie garage door openers manufactured from 1993 to the present •...