Home » Genie » Garage Door Openers » Genie Excelerator

Genie Excelerator Support Question

Find answers below for this question about Genie Excelerator.
Need a Genie Excelerator manual? We have 1 online manual for this item!

Genie Overview Questions Manuals Reviews Videos Research

Question posted by dlecair on April 22nd, 2014

Manual 4063

The person who posted this question about this Genie product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BusterDoogen on April 22nd, 2014 1:00 PM

This answer was accepted by the poster of the original question.

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,407

1,100
points

Go here for the manual.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Related Genie Excelerator Manual Pages

Owner's Manual - Page 1

... Information 2 Important Installation Instructions 2 Safety Features 2 Pre-installation Checklist 3 Garage Door Opener Assembly 9 Record Data (for 8' Doors Included Wall Control MUST be Properly Set to Operation of this Garage Door Operator. Extension Kit is available for Service 11 Garage Door Opener Installation 12 Accessories 22 Maintenance 25 Troubleshooting 26 Wiring Diagram 29...

Owner's Manual - Page 2

... knob 6 feet above the floor. Automatic Lighting System Two light bulbs up to the wall button or console. Manual Emergency Release Allows the garage door to , the emergency release 8 The operator must be opened or closed manually for opening equipment. Install the emergency release tag on, or next to be made by a trained service person using...

Owner's Manual - Page 3

...automatic Garage Door Balance Detection System. This Opener is out of balance, have a wooden door, measure door's thickness. (1/4" x 2") Lag Screws are included for repairs and adjustments to door mechanism. One-Piece Door B Raise door to door mechanism. E If you will need. not included) WARNING: If your garage door for installation on page 27. NOTE The Excelerator Opener is...

Owner's Manual - Page 4

... a Genie Factory Authorized Dealer. • If a door spring is in your rail is long enough to open the garage door. Bottom of the wall just above door. Rail Extension for a stud or a solid header at center of door and on header directly above the top of the garage door opening. Check Step 4: CHECK DOOR HEADER AREA NOTE The header is...

Owner's Manual - Page 5

... above where Opener Power Head will be partially disassembled to install appropriate wiring in place of Power Cord. See page 19 NOTE Permanent wiring must be mounted (Figure 5): A Measure from garage door center line mark toward rear of garage: • Approximately 10' back if garage has a 7' 6" door. • Approximately 11' back if garage has an 8' 0" door. • Approximately...

Owner's Manual - Page 6

... Extensions (dealer) ❐ Garage door opener reinforcement bracket (dealer) ❐ Garage door frame reinforcement brackets, screws, bracing or reinforcement kits (dealer) ❐ Lag Screws (11/4") for a wood door less than 2" thick (store) ❐ Electrical outlet and/or wiring (supplied by a licensed electrician) ❐ Excelerator Extension Kit (for 8' garage doors) (store) ❐...

Owner's Manual - Page 9

..., skip Assembly Step 2. Snap on both ends. CAUTION The Drive Screw and Rail Liner can slide out of Rail Sections. GARAGE DOOR OPENER ASSEMBLY Assembly Step C1H: CONNECT RAIL TO POWER HEAD OPEN BLUE PARTS BAG A Turn Power Head upside down and place on collar 11B. Assembly Step C2H: INSTALL REMAINING RAIL SECTIONS A Arrange...

Owner's Manual - Page 12

... the Header Bracket be used depending on the center line of these may be necessary to attach a 2" x 6" board across the wall studs above the door header to the garage framing. GARAGE DOOR OPENER INSTALLATION NOTE For lightweight garage doors, make sure you have sufficient support. • If a door spring is recommended) Lag Screws and Flat Washers (not supplied).

Owner's Manual - Page 13

... materials must be properly braced before mounting door Opener. Finger-tighten until later. 28 30 56 or 30 28 SECTIONAL DOORS Center Line of door ONE-PIECE DOORS Center Line of door. For doors thinner than top rollers Attach at highest point on door Optional Door Operator Bracket (not included) Figure 19 Attach Door Bracket Rail Strap Rail Strap Bolt...

Owner's Manual - Page 15

... is as long as possible. C Attach both Arms together with Clevis Pin and Cotter Pin (Figure 24). If the Knob is pulled with garage door fully or partially open, garage door may leave Emergency Release Knob within reach of Emergency Release Cord Knob to comply may close without warning! 33 32 Clevis Pins Cotter Pins...

Owner's Manual - Page 16

...® System Wires. NOTE To help prevent interference from the door opening, where it now. A Install Safe-T-Beam® Source and Sensor (Figure 25): • Mark both sides of wood, etc. Blocks of garage door frame or wall 6" above floor. • Hold Bracket against door frame or wall. B Attach Safe-T-Beam® Source (Red LED...

Owner's Manual - Page 18

... 2 Striped Wire to prevent small children from operating garage door). • Away from inside garage. • Independent Light Control allows convenient manual control of Wall Console, connect Striped Wire to terminal... B Find a convenient mounting location: • Within direct sight of any moving garage door or Opener parts (you should not be sure to only tap them in as far as needed...

Owner's Manual - Page 20

... Magnet Open Limit Switch Switch (door fully open garage door. - Setting Force Controls and Final Adjustment of Limit Switches WARNING • The garage door opens rapidly, and can cause serious injury or death. • Keep the path clear. • Position the ladder to floor. B Setting Open Limit Switch: • Manually open garage door to full open position. • Slide Open Limit...

Owner's Manual - Page 21

... activates the Close Limit Switch. If your Excelerator® is blocked, door will prevent the Timer/Cycle Counter from Close Limit Switch to Open Limit Switch. NOTE • To protect your new investment, your Opener suddenly stops responding to the Wall Console - A Open garage door using Wall Console. • Observe that door runs to Close Limit Switch. - E Check...

Owner's Manual - Page 22

... Memory." B Press Button again. B Snap Battery Cover closed. Garage door will not cause the door Opener to close the garage door if the Safe-TBeam® System is malfunctioning. • When...Push to the door and door Opener Owner's Manuals before attempting any similar device. - You cannot use the door Opener, Remote Controls, or Wireless Keypad. • Refer to open . •...

Owner's Manual - Page 23

... LED stays on Keypad. Enter your PIN (3 to Door and Door Opener Owner's Manuals before attempting any repairs. NOTE • If the door does not move the garage door: - Learn Code Indicator LED (on your PIN (3 to control ( or ). • Press . - After the LED stops blinking, re-enter your door opener has a black antenna Indicator LED wire,the Learn...

Owner's Manual - Page 26

...door ...door increases the risk of severe injury or death. 7 KEEP GARAGE DOORS PROPERLY BALANCED. IMPORTANT SAFETY INSTRUCTIONS WARNING TO REDUCE THE RISK OF SEVERE INJURY OR DEATH 1 READ AND FOLLOW ALL INSTRUCTIONS. 2 Never let children operate or play with the door open...door is closed . NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR. 4 NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR. 5 Test Opener...

Owner's Manual - Page 27

...-unplug (or disconnect power), wait 5 seconds, plug back in (reapply power), and activate from Opener. Check door condition. Have a Genie Factory Authorized Dealer check that Ribbon Cable on Motor Board is equipped with an automatic garage door balance detection system. Have a Genie Factory Authorized Dealer check: - Check for further assistance. Contact Customer Service for...

Owner's Manual - Page 28

...; Check condition of Collar and Clip. General Troubleshooting (Always Check the Status LED Light) Problem What To Do Opener does not run open Operator runs, but door does not move • Check (ensure) that garage door and Opener are in good repair, properly lubricated, and properly balanced as detailed in Maintenance Section. • WARNING: If you...

Owner's Manual - Page 29

... Service at 1-800-35-GENIE. YELLOW ORANGE GREEN MOTOR SECONDARY GROUND 29 Noisy operation • Ensure all fasteners are tightened. • Check that the garage door and Opener are in Safe-T-Beam® System Self-Diagnostic Troubleshooting Chart (See page 26). General Troubleshooting (Always Check the Status LED Light)(Continued) Problem What To...