Frigidaire IM115 Support Question
Frigidaire IM115 Support Question
Find answers below for this question about Frigidaire IM115 - Ice Maker Kit.Need a Frigidaire IM115 manual? We have 1 online manual for this item!
Question posted by karen031207 on October 12th, 2011
Ice Maker Gd21 Stopped Making Ice. Any Clues?
I have a Frigidaire with factory installed ice maker GD21 and it stopped making ice. It has power but I have no clue. Should I replace filter, is there a reset button and suggestions would be appreciated.
Current Answers
Related Frigidaire IM115 Manual Pages
User Manual - Page 1
... the supply line. • DO NOT install water supply tubing in a kit from the softener may damage the ice maker, causing it greatly increases the potential for water leaks. P/N 240394901 ICE MAKER INSTALLATION INSTRUCTIONS
To avoid electric shock, which can cause death or severe personal injury, disconnect the refrigerator from electrical power before connecting a water supply line to...
User Manual - Page 2
...3. Qty 2
6. Qty 1
7. Plastic Clamp - Water Inlet Tube - Screws - Ice Maker
2. Plastic Water Supply Tubing
4. Qty 1
9. Leveling Bracket Qty 1
8. Qty 1
Tools Required:
• Putty Knife • ¼ inch Socket Wrench
or Nut Driver • Knife
• ...
User Manual - Page 3
Peel off label covering ice maker hole.
7. Push water inlet tube into small hole on shelf to ...on back of hole. If refrigerator has exterior condenser (C), go to remove.
4. DO NOT remove compressor sound baffle (A), if installed.Carefully bend condenser out away from wall outlet.
2. Remove freezer shelf (some models).
3. Remove plugs from inside compressor compartment...
User Manual - Page 4
... NOT over tighten.
12. Make sure connection is sitting inside fill cup.
11. Ice maker is level when gap between freezer wall and ice maker is same at top and bottom. Install adjustable leveling bracket (7) on back freezer panel. Tighten another one hand, plug ice maker connector into freezer wall. Start two, long, ice maker mounting screws (5) into connector mounted...
User Manual - Page 5
... refrigerators with wrench. 15. Set ice container (2) on shelf.
18. Tighten another one half turn with dynamic condensers, remount sound baffle, if installed. NOTE: Clean back of cabinet with a Phillips® head bit to water valve. Make sure connection is tight.
20. DO NOT over tighten.
16. Use a power drill with a commercial household cleaner...
User Manual - Page 6
... 24 hours for installing a water supply line. Discard ice made of 1/4 inch OD copper tubing, a saddle type shutoff valve (nonpiercing), (2) 1/4 inch brass compression nuts, (2) ferrules/sleeves, and instructions for the ice maker to the refrigerator. Manufacturer will go (1/4 inch). NOTE: Water line kit number 5303917950, available from electrical power before making a full tray of...
User Manual - Page 7
... water supply or
whenever the water supply is turned off. • The following sounds are normal when the ice maker is operating.
• Motor running • Ice loosening from a malfunctioning softener can damage the ice maker. To stop the ice maker, lift the wire signal arm until the refrigerator is connected to the closed position.
7
Empty the container...
Similar Questions
Ice Maker Model Number Gd-21.where Is The Filter Located And How To Replace It.
(Posted by soryanth 9 years ago)
How To Fix Frigidaire Ice Maker Gd21
(Posted by kesqucicc 9 years ago)
How Long For Ice Maker Im115 To Make Ice
(Posted by Anabeaye 10 years ago)
Ice Maker Does Not Make Ice Fast Enough
(Posted by lukf4 10 years ago)
Ice Maker Makes No Ice But Water Works.. I Replaced The Filter.
originally it made ice and no water. now it makes water and no ice! I replaced filter. please help
originally it made ice and no water. now it makes water and no ice! I replaced filter. please help
(Posted by Taurus176 12 years ago)