Whirlpool WGD8127L Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WGD8127L manuals!
Problems with Whirlpool WGD8127L?
Ask a Question
Free Whirlpool WGD8127L manuals!
Problems with Whirlpool WGD8127L?
Ask a Question
Popular Whirlpool WGD8127L Manual Pages
Owners Manual - Page 2
... of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, Part 1, CSA C22.1.
2 This is , tell you how to potential hazards that can happen if the instructions are very important.
The dryer must conform with local codes, or in the absence of local codes, with local codes, or in this manual and on...
Owners Manual - Page 4
..."Assistance or Service" section in ring terminals or spade terminals with upturned ends.
■ A UL listed strain relief
Parts needed: (Not supplied with dryer) Check local codes. For further information, please refer to propane gas
Parts supplied (all models):
Level Plastic putty knife
Vent clamps
Leveling legs (4) Parts needed (steam models):
Caulking gun and compound (for installing new...
Owners Manual - Page 5
... drying times.
For gas dryers mobile home installations:
■ Mobile Home Installation Hold-down Kit is suitable for Mobile home construction and Safety, Title 24, HUD Part 280) or Standard CAN/CSA-Z240 MH.
Space must support dryer weight of dryer. For further information, see "Assistance or Service" section in your local building inspector.
18...
Owners Manual - Page 7
...Code, C22.1-latest
edition and all local codes.
Failure to follow these instructions can result in
conformance with a UL listed
and/or CSA International Certified Power
Cord intended to do so can result in "Assistance or Service" section of your responsibility:
■ To contact a qualified electrical installer... supply is your "Quick Reference
Guide."
A time-delay fuse or circuit ...
Owners Manual - Page 8
... must be used . The location should be installed within six (6) ft (1.8 m) of the dryer in the "Assistance or Service" section of gas available, contact your dealer or call the phone numbers referenced in accordance with the B149.1, Natural Gas and Propane Installation Code.
In the U.S.A.:
An individual manual shut-off valve. GAS SUPPLY REQUIREMENTS
WARNING...
Owners Manual - Page 16
... system to follow these instructions can be purchased from your "Quick Reference Guide."
16 For more information, see "Assistance or Service" section in final dryer location.
■ Remove excess to avoid crushing and kinking. Flexible metal vent: (Acceptable only if accessible to clean) ■ Must be fully extended and supported in your dealer.
Do...
Owners Manual - Page 21
q Check dryer's final location. Electric Models:
q For power supply cord installation, plug into place.
3. The dryer door is level. If dryer will receive L2 code for certain part replacement or repair. You will not start, check the following:
■ Controls are set into a grounded
outlet.
A
A. Close the dryer door as far as the door is first heated. Continue...
Owners Manual - Page 22
... screw (on some models) on some models)
3.
Install 2 plastic plugs (A)...MODELS)
The following instructions are applicable for reinstalling the door.
5. Remove the dryer door by lifting upward and out to lift the door off to avoid damaging the surface. NOTE: Door strike and plugs must be on some models) opposite
the door strike (A). Remove door from where they were removed. Set...
Owners Manual - Page 25
... Add inside door panel back into the dryer door by placing set pin in sideways to snap into the top trim piece and then lower door down . Install 6 hinge screws and the other 2 screws.
13. 10.... lined up with the hinge holes.
12. Tighten all hinge screws. Install hinge covers and plugs. Using a T20® screwdriver, install (A) screws and then (B) screws. Then press down on the corners to...
Owners Manual - Page 26
... is hard to both sides of the dryer. A screen blocked by a qualified appliance servicer or ventilation system cleaner.
Explosion Hazard Keep flammable materials and vapors, such as gasoline, ... should be done by lint can build up and out. Doing so can result in the Installation Instructions.
■ Clean space where lint screen is probably clogged if lint falls off the screen ...
Owners Manual - Page 27
... into a grounded outlet or reconnect power.
To clean or repair venting, contact a venting specialist. each load. ■ Replace plastic or foil vent material
with a 10 W appliance bulb only.
GOOD AIR FLOW
Along with the screw.
4. Proper venting will be sure to follow the Installation Instructions supplied with your lint screen before each bend and...
Owners Manual - Page 28
...
Installation Instructions. Failure to reduce the risk of replacement. See "Base trim". NON-USE, STORAGE, AND MOVING CARE
Steam models only: Install and store your dryer where it .
When replacing ... should:
1. On models with base trim: Remove base trim before servicing. Unplug the power supply cord. 2. Gas models only: Cap the open fuel supply line. 5. On models with base trim: ...
Dimension Guide - Page 1
Gas WED8127LW- Gas
Chrome Shadow Available WED7120HC - Electric WGD8127LC- Electric WGD8127LW- Electric WGD7120HC - Gas WED8127LC- Gas
W11412666B
White Available WED7120HW - Dimension Guide
Whirlpool® Smart Capable Front Load Electric/Gas Dryer with AccuDry™
System, Steam Refresh Cycle - 7.4 cu. Electric WGD7120HW - ft.
Dimension Guide - Page 2
...PLANNING DIMENSIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in (max) 433/4 405∕8 71/4 -
mm (max) 1111 1031 184 -
2 Electrical ... 61/4 103∕8
mm (min) 1086 686 1006 759 158 264
in your appliance's Owner's Manual, before installing and operating this appliance.
Dimension Guide - Page 4
... dimensions shown are for the recommended spacing allowed.
Ƀ Additional spacing should be considered for ease of installation and servicing. Ƀ Additional clearances might be required for wall, door, and floor moldings. Ƀ Additional spacing of 1" (25 mm) on all sides of the dryer is ...
Whirlpool WGD8127L Reviews
We have not received any reviews for Whirlpool yet.