Sharp XG-V10WLP Support and Manuals
Get Help and Manuals for this Sharp item
View All Support Options Below
Free Sharp XG-V10WLP manuals!
Problems with Sharp XG-V10WLP?
Ask a Question
Free Sharp XG-V10WLP manuals!
Problems with Sharp XG-V10WLP?
Ask a Question
Popular Sharp XG-V10WLP Manual Pages
Operation Manual - Page 1
Sharp Projector(s) Network Configuration Operation Manual
For The
XG-V10WU XG-V10WM
XG-V10XU XG-V10XM
Sections: 1.) AN-L10T Optional Card Installation 2.) Projector Menu Configuration 3.) S.A.P.S. Software Configuration
L:\tekcentr\CACTrain\SPS_ntwk
1
10/16/2001
Operation Manual - Page 2
... Optional LAN Board into the Projector
The following must occur:
1.) Install AN-L10T Optional LAN Board 2.) Configure XG-V10W / XU / M Projector Menu Setup 2.) Configure S.A.P.S.
T Network adapter. Software
Installation of the AN-L10T LAN Card into the XG-V10W/XU/M Projectors.
In order to configure the XG-V10W / XU / M projectors to the network is called a "NODE". LAN...
Operation Manual - Page 5
... used with the AN-L10T LAN card.
1.) ID Number Setup 2.) Optional Board (LAN Board) Setup 1.) To Setup the ID Number, proceed to the Projector menu "Options 2" and toggle down to the Set ID Number using is ID # 11 as indicated above 2.) When the LAN board is installed, select Menu Button "OPTIONS 2" from the menu screen...
Operation Manual - Page 7
... company's network or at all.
2.) The second option to be configured is "Gateway Set" when that option is selected, the following "Gateway Set" will appear. L:\tekcentr\CACTrain\SPS_ntwk
7
10/16/2001 The computers that control traffic within your local Internet service provider (ISP) are gateway nodes.
The IP Address is a unique string of...
Operation Manual - Page 8
...NOTE: On the XG-V10W/XU/M modified... NOTE: IP Address, Gatway Set, Subnet Mask addresses must be part of a network that start... with IP addresses that shares a common address component. This information is disabled.
A "Subnet Mask" is a portion of the same subnet Dividing a network into subnets is useful for RS232.
NOTE: When the LAN board is installed...
Operation Manual - Page 9
... select "Use ID Number" This can be accomplished through the "File" menu option "Operation Mode Setting". (Refer to Figure 3)
NOTE: Make sure projectors have different I.D. software for either "Single" ...the S.A.P.S. S.A.P.S Software V1.41 Network Configuration
The steps below show how to ID # Setup on how the software was originally configured, the menu when launched will be indicated at ...
Operation Manual - Page 11
... This "ID" number is an additional option to help the enduser / customer to ID number Setup on page 4). This "ID" number is selected and inputted on the Projector from the projector...Figure 5
From the "Projector Setting" Mode we can now proceed to the "Projector Setting " menu option under "Options 2" (Refer to better identify, monitor and control Sharp projectors which will be obtained from...
Operation Manual - Page 12
Figure 6
Under the "Projector" item select the proper projector XG-V10W / XU / M. Finally place a check in the "Use Projector" box. After confirming / adjusting the "Projector Setting" menu the "Apply" button will become active (Not ghosted) click the "apply" button and then the "OK" button and your projector's ID number and the ...
Operation Manual - Page 13
... will be interacting with on this menu option.
1.) Projector / Unique Name 2.) E-Mail Address Book 3.) Send E-mail Setting 4.) Sender setting
(Refer to Figure 8)
Figure 8
1.) The first item "Projector / Unique name" is not specifically necessary for configuring the XG-V10 projector to an existing network, it does however offer another opportunity to further help with the...
Operation Manual - Page 14
...Name".
The SAPS software is reading the information previously identified through the "Projector Setting" from the "File" menu option. (Refer to Figure 6)
For this ...ID" number and the port connection type is limited to call our unit "Sharp's Unit". This name can control up to help the Administrator identify the ...manual for further details on the physical layout and or number of the Unit...
Operation Manual - Page 15
... failure problems while also giving the E-mail recipients an overall status report. 2.) The next item to configure is the "E-mail Address Book" These addresses are the e-mail address's for who ever is going to receive "Projector Condition" (sending periodic e-mail messages on projector status) and "Projector Error" e-mail messages (Notifying that errors have...
Operation Manual - Page 16
... existing projector(s) which was just setup. The "Scan Setting" once again is under the...set e-mail address should projector errors be detected. The "E-mail Server (SMTP Server) line is where the actual IP address of the S.A.P.S.
This concludes the S.A.P.S section on page 10 )
L:\tekcentr\CACTrain\SPS_ntwk
16
10/16/2001 software. (Refer to Figure 5 for detailed screen image on Network Setup...
Operation Manual - Page 17
... 16 17
10/16/2001 Depending on the bottom right of the scan setting screen the following screen appears. Once identifying the "Scan Setting" menu option, the following window will appear under the LAN line item....the IP address which is where the S.A.P.S. software is installed is depressed on your projector setup and port configuration you must select what com ports to be selected.
Operation Manual - Page 18
...". (Refer to Figure 17)
Figure 17) The green circle and the information indicated informs the SAPS administrator the unit is not detected with the scan setting the following screen will appear on the "Multiple Control" screen under the "All projector List". (Refer to Figure 18)
Figure 18 At this point verify...
Operation Manual - Page 19
... to another location in another part of the network, a new IP address must be assigned to another network.
The computers that control traffic within your local Internet service provider (ISP) are they...number of IP addresses.
When an organization sets up its computer users with a connection to the Internet, an IP address must be entered manually at your company's network or at ...
Sharp XG-V10WLP Reviews
We have not received any reviews for Sharp yet.